Filter Results By:
Products
Applications
Manufacturers
Softness
describes how yielding a material is to pressure, touch for example.
-
product
Manual Prober 100/150/200
Compatible with a wide range of needs for series evaluation and analysis with comfortable operability popular Always adopting a soft contact by adopting a shock absorber. It adopts a large platen and realizes mounting of a margin manipulator. Moreover, it is possible to adjust Z of the needle at once by moving the platen up and down. It is an ancient form that takes operability into account. It is easy to load / unload wafers.
-
product
Rectal Probe For Humans, Larger Animals
RET-1
The RET-1 Rectal Probe for humans, neonatal rabbits, and larger animals. Flexible vinyl covered, soft tipped. 5 foot lead (can be made longer), 5/32'' max. tip diameter, max lead diameter 3/32''. Time constant 5.0 seconds.
-
product
ARINC 429 Test And Simulation VME Module
VME-429
*8, 16, 32 or 64 software programmable TX / RX channels*Programmable high / low speed operation*Simultaneous operation of all TX / RX channels*PXI interrupts, star trigger, and PXI clock*Error entry and detection*128 MB RAM*Label selective triggering for recording / filtering*IRIG-B timecode encoder / decoder for data correlation*Real-time recording and later analysis of multiple channels*VXI Plug & Play driver including soft front panel*Supports: C, C ++, C # and .net*Driver support: Windows, Linux, VxWorks and other systems
-
product
12-Ch 10A-250VAC RCV Power Distribution Unit
YAVAR438
- Hardware controlled Enable Input- 12 Power relays up to 10A 250VAC/DC and 300W or 2.700VA switching power- 12 10-mOhm shunt resistors.- 6 Switched 2-Pole sense channels- Single phase isolated or 3-Phases non-isolated switching capabilities, to or from the device under test (power or load)- VPC TriPaddle 96 pins connector.- NI LabView & TestStand driver.- .NET, C/C++, VB driver.- Soft Front panel for direct interface.- CAN Control or Ethernet (with Ethernet to CAN Gateway).- Self-test module available.- Form A
-
product
PXI Attenuator/Switch Driver Module
M9170A
The Keysight M9170A is a one-slot PXI attenuator switch driver module that provides the flexibility to drive Keysight's expansive portfolio of RF & microwave step attenuators and electromechanical switches. It is a PXI-hybrid compliant module that comes with a full-featured graphical interface soft front panel for easy control and trigger.
-
product
100 N Pantograph Grips
Pantograph grips use a simple spring design to hold and apply pressure to specimens during tensile testing. These grips are mainly used for tensile testing plate specimens of rubber, textiles, or soft plastics.
-
product
Soft Front Panel for NI RF Generators
NI RFSG Soft Front Panel
The NI RFSG Soft Front Panel helps you quickly generate RF continuous wave (CW) or modulated signals. It works with the NI PXIe-5644R/5645R/5646R vector signal transceivers (VSTs) and NI 567x vector signal generators (VSGs). You can open multiple instances for multiple instruments in a system. In addition, you can load I/Q waveforms, save and recall setups, preview data that is loaded onto the VSG, and sweep levels or frequencies using RF list mode. The soft front panel also features built-in modulation schemes such as AM, FM, and PM.
-
product
PXI Data Acquisition
DAQ
Installation and configuration is fast and easy with standard connectors, soft front panels and Keysight connection expert. In addition, software drivers support the most common programming environments such as Visual Studio®, C, C++, Visual Basic, MATLAB® and LabVIEW™.
-
product
Coercimeter
KO 3.1
For measurement of the coercive field strenght of soft magnetic materials. Digital display of the measured values. Measurement of small workpieces is also possible. Options: PC connection and plotter software.
-
product
Scanning XPS/HAXPES Microprobe
PHI Quantes
The PHI Quantes is the only commercially available automated, high-throughput lab-based HAXPES spectrometer. It is a unique scanning X-ray photoelectron microprobe that combines a high energy (HAXPES) monochromatic X-ray source (Chromium Kα) with a conventional monochromatic soft X-ray source (Aluminum Kα). Both sources are high flux focused X-ray beams that can be scanned across the sample surface and can be used to define analysis points, areas, lines, and maps with 100% confidence.
-
product
Anaerobic Jar Tester
LD-LAJ-A12
Anaerobic JarLD-LAJ-A12with 3.5 L capacity has PMMA transparent, smooth surface jar design. High quality O-ring is used to make tight sealing between jar and lid. Adopted with quick snap-shut coupling, enables quick connection to the system in a one soft move. The number of gas packs needed may vary in brands and pack size, required to create anaerobic condition in the jar.
-
product
Softness Tester
TESTEX Testing Equipment Systems Ltd.
Softness Tester, to determine the softness of leather and coated fabrics and other soft materials. Softness tester does not need samples to be cut from leather prior to testing.
-
product
Static Electricity Measurement Management Set
NK-1B / NK-2B
We have all the measuring instruments for solving ESD troubles.It is easy to carry and is ideal for process diagnosis.You can send it as it is by courier.Ideal for in-house static electricity education.A special soft case is attached so that the measuring instruments can be carried individually.
-
product
Digital Inspection
The DI-1000 and DI-1000L-PRO inspect fiber optic connector endfaces, providing clear sharp digital images on your Windows® PC. The DI-1000 and DI-1000L-PRO use LIGHTEL's Series 2 Tips and come with a soft case designed to fit easily into a standard laptop case.
-
product
Cabinet X-ray System
XPERT 80- L
Kubtec's XPERT 80-L, for large area imaging, is a multi-purpose cabinet x-ray system bringing high quality medical-grade imaging and ease of use to applications in scientific research, pathology and industry. A small focal spot with an x-ray source of up to 130 kV offers brighter images with higher contrast for visibility of the smallest details and most subtle variations in density. Optional sources are available for micro-focus and soft x-ray applications.
-
product
Tensile Testing Machines
Is an intelligent tensile testing machine specializing in testing the mechanical properties of various flexible packaging materials. It is suitable for test the peel force, heat seal strength, tearing resistance, deformation, puncture resistance, open force, low speed unwinding force etc of plastic film, composite film, soft packaging materials, adhesives, rubber, paper fiber and other products.
-
product
Barcol Hardness Impressor
BHI
Measures the hardness of soft metals such as aluminum, aluminum alloys, copper, brass, and other materials such as harder plastics, and fiber-reinforced plastic. Easy-to-read digital display. Comparable to 934-1 Barcol Hardness Tester. Conforms to national and international standards including ASTM.
-
product
Moisture Meters/Thermo-Hygrometers
It be used to detect the moisture content or water composition from a wide range of materials such as wood, fiber, bamboo, cotton, paper, and tobaccos. It measures from 2% to 70% of moisture level of the object being tested, which make it an essential tool for either amateur or professional surveyors, woodworkers and craftsmen. An effective device to diagnose dampness in buildings and enables building surveyors and other users to measure moisture levels of soft to medium density of wood materials using the highly accurate 2 sensor steel probes.
-
product
RF Shielded Box
TS7124
R&S®TS7124 RF shielded boxes enable reliable and reproducible measurements in shielded test environments. The R&S®TS7124 shielded box provides high shielding effectiveness, a good antenna coupling factor and a rugged mechanical design for reproducible results. RF test boxes have been designed not only for product designers or product optimization but also for production lines of wireless devices under test. The soft close feature makes the shielded box safer to operate.
-
product
Sonin Digital Moisture Meter 270
50270
This compact easy-to-use Digital Moisture Meter is ideal for anyone needing to measure the moisture content in soft and hardwoods including tropical species.
-
product
Power Distribution Unit with Switchable Outputs, Soft Start & Integrated Ethernet Switch
PDU-200
The PDU-200 is a power distribution unit for automatic tests equipment (ATE). Its outputs are software controlled to allow power on sequencing and direct interaction form the test sequence. The integrated 24V power supply provides power for additional equipment like relays and sensors. The PDU-200 is intended to use with an external remote-control panel which provides On & Off buttons as well as an E-Stop and acknowledge button. It’s integrated eight port switch simplifies wiring as no additional components are required.
-
product
Constant Distance SECM
VS-STYLUS
In collaboration with SENSàSION, we are pleased to offer the Soft Stylus Probe contact mode technique developed by Professor Hubert Girault and co-workers of the Laboratory of Physical and Analytical Electrochemistry (LEPA) at the École Polytechnique Fédérale de Lausanne (EPFL) for constant distance SECM. The probe technology offers the following benefits:
-
product
Stainless Steel Shims and Sensor Brackets
PRÜFTECHNIK Condition Monitoring GmbH
Sensor mounting brackets and stainless steel shims for vertical alignment and soft foot correction are an integral part of a precision alignment solution. They contribute to the quality of the measurement and the resulting asset reliability. PRUFTECHNIK offers universal or chain-type brackets as well as stainless steel shims for trouble-free machine corrections. Brackets and stainless shim sets are alignment accessories that improve the results and experience for unusual or challenging situations, including soft foot. Quality stainless steel shim sets improve alignment adjustment results and make challenging alignment situations, including soft foot faster and easier.
-
product
Racing Tire Hardness Tester
52-50553
Longacre Racing Products, Inc.
Tire hardness has a huge affect on your car's performance. A tire too hard won't bite and a tire too soft may wear quickly or even ball up. Also tire hardness changes during its life cycle. To run your best you must keep track of all your tire's hardnesses.
-
product
Yoke
M-XY10
The JM-XY10 yoke is designed to measure dynamic magnetic properties of tested materials under alternating and rotational field. The measuring could by made on square samples (side: 60÷100 mm) or circle samples with diameter 60÷85 mm. The JM50 yoke could be cooperating with following equipment designed to measuring soft magnetic properties:
-
product
Gratings for Synchrotron, FEL and EUV Light Sources
HORIBA Scientific holographic lamellar gratings exhibit ultra-low grooves roughness and unique efficiency uniformity making them ideal for Synchrotron, Free Electron Laser (FEL), EUV or Soft X-ray light sources.
-
product
Fully Automatic Three Phase kilo Watt hour Meter Test Bench
SY8320
Hong Kong Songyang Industrial Ltd.
Suitable design, good figure. The frame for meters and the body frame are fully made by special aluminum alloy. The table board is composed of fireproofing and heat-proof fiber materials. The whole device is in soft color and good figure.
-
product
Thin Film Chip Resistors, High Stability and Reliability Type
ERA-XV/ERA-XK Series
Panasonic Industrial Devices Sales Company of America
Anti-Sulfurated Thin Film Chip Resistors From Panasonic For Dependable, Accurate And Reliable Performance In Extremely Hazardous EnvironmentsPanasonic's ERA-xV and ERA-xK Series Thin Film Chip Resistors feature a soft terminal and passivated layer. With a total of 2,889 part number variants, Panasonic ERA-xV and ERA-xK Series Resistors provide design engineers with a wide array of Resistors to choose from specifically developed to handle extremely hazardous and challenging application environments.
-
product
USB Products
Keysight´s compact USB modular products are a series of modules that are flexible to be used standalone or plugged into a compatible chassis to make synchronized measurements as a modular unit. Essential measurements can be made with a laptop PC and these modules through USB high-speed 2.0 connections. Through individual windows, the Keysight Measurement Manager (AMM) software provides a friendly soft front-panel interface for each of the modular products. This helps to perform quick configuration and measurement acquisition as well as flexible analysis of measured data.
-
product
Shore Durometer
3120
The Elcometer 3120 range of Shore A and Shore D Durometers is widely used to test the hardness of soft materials.
