CCD
Devices for recording images, typically consisting of an integrated circuit (IC) with an array of coupled capacitors.
-
Product
LED/CCD Optical Micrometer
LS-7000 Series
-
Breakthrough technology intelligent optical micrometer with 0.01-micron high resolution, 2400 samples/second high speed. Maintenance - free LED emitter and design (no laser diode or motor). High performance controller with statistical analysis. Controller with target viewer available for easy setup
-
Product
Multichannel Grating Spectrometer
PoliSpectra® Quad
-
Horiba’s OEM Polispectra Quad spectrometer is an integration of four VS70 spectrometers built around Horiba JY Type-IV flat-field aberration-corrected holographic concave gratings. This high throughput VIS spectrometer with 4 fiber inputs provides simultaneous acquisition of 4 channels at high speed with minimal crosstalk. The main electronics board is designed to read the two CCDs on the system simultaneously and provides 1-8X binning capability. This OEM system is a unique and innovative approach to drastically reduce the cost per channel.
-
Product
Wide-Field FLIM System
LINCam FLIM
-
*Easy to Use Like an Ordinal Megapixel CCD Camera*Spatial Resolution ~ 1024 x 1024 Pixels*Temporal Resolution (IRF Width) 50 ps FWHM*Single-Photon Sensitivity*Saturated Count Rate Up to 5 MHz*Excitation by bh BDS-SM Family ps Diode Laser*Works with All Commonly Used MicroscopesI*llumination via Single-Mode Fiber*Lens System for Image Transfer Into Camera
-
Product
Chrysler CCD Vehicle Bus Comms PC Card
SL100
-
The SL100 uses a standard 16450 UART with baud rate settings that makes it capable of communicating with a Chrysler CCD Vehicle bus. The SL100 uses a protected interface driver chip, as prescribed by the bus specification, to connect with vehicle peripherals in a robust and highly noise immune way. The card automatically configures to become another COM port by using the built-in O.S. drivers that are tried and tested and are optimized to work in the Windows environment.
-
Product
Camera with the ICX618 Sensor
Guppy PRO Series
-
The Guppy PRO Series is a small 1394b camera with the ICX618 sensor. This EXview HAD CCD sensor is very sensitive both in the visible spectrum and in the NIR (near-infrared) spectrum.
-
Product
Characterization System
System 7700
-
Whether your application is characterizing a massive mosaic of CCDs for the next great observatory, designing a faster FLIR for a weapons-guidance system, or production-testing a CMOS image sensor for a digital camera, Pulse Instruments can supply you with a fully-integrated test system that allows you to focus on your your device, not on your test system.
-
Product
High Sensitivity, Compact Imaging Spectrograph
Lumetta
-
HORIBA Scientific’s new Lumetta™ delivers benchtop performance in a small, value priced package to the rapid compact spectrometer market. It offers the highest throughput/signal gathering capacity in its class, employing a tall sensor and an F/2 design. With a scientific grade-one high quantum efficiency CCD cooled to -50 oC, it provides a sensitivity that rivals more expensive high-end benchtop systems. As an imaging spectrograph, it enables advanced techniques such as multitrack spectroscopy and hyperspectral imaging ― all at an affordable price.
-
Product
Spectrometers, Vacuum
-
A compact and versatile vacuum ultraviolet monochromator. A selection of aberration-corrected diffraction gratings is available so you can tailor the instrument to your wavelength of interest and application. Connect this instrument directly to your vacuum plasma physics experiment or build an intense UV tunable source. It is available as a scanning monochromator, as a spectrometer, or as a spectrograph with microchannel plate or direct-detection CCD. The Model 234/302 is popular in systems due to its compact design, high throughput and resolution. It is also available with an additional entrance or exit port.
-
Product
Semi-automatic Semiconductor Probe Assembly Equipment
-
The components of the incoming parts are pre-assembled and preloaded to two packages. We use a high-speed four-axis robot equipped with high-precision multi-sensor grips to grab these pre-assembled subcomponents. Under CCD visual guidance, a set of rotary grab devices is equipped to capture top plunger. The device uses a multi-set CCD visual module to ensure accuracy, and the positioning accuracy of each motion link is controlled within 15um.
-
Product
IndiRAM CTR With Quantum Characterizer
Spectrometer
The IndiRAM CTR Raman/PL system with Quantum Emitter Microscope is a multi-purpose system capable of performing Quantum Emitter Characterization, Raman, Photoluminescence as well as Optical Emission Spectroscopy. The system consists of a Pulse Laser along with a single photon counting module (SPCM), a Pulse Synchronization unit, Motorized Scanning stage and a research grade microscope (Upright or Inverted) for TCSPC measurements. Along with these, it also contains a High throughput Spectrometer with a TE Cooled CCD and an optics box assembly to perform Raman/PL and OES Spectroscopy and Microscopy. obtained after the multiple set of experiments gives the lifetime function.
-
Product
Clock Drivers
-
Multiple timing signals ("clocks") are required by CCDs, IR FPAs, and some CMOS image sensors to transport electrical charge across the array to a sense amplifier for conversion into image data. Pulse Instruments offers a line of "clock drivers" for generating these timing signals. The parameters of these clocks (clock rate, pulse width, pulse amplitude, rise- and fall-times, etc.) greatly influence the behavior and performance of the imaging device. Our products take logic-level inputs from a pattern generator and allow the user to adjust the output parameters to suit their device and testing requirements. Clocks can be "tweaked" in real-time to determine optimal operating parameters for a particular device, or else programmed in accordance with a test plan for automated production test.
-
Product
Industrial X-Ray
-
Teledyne DALSA offers powerful, innovative CCD and CMOS X-Ray detectors combining industry-leading performance with cutting-edge features for industrial and scientific applications such as NDT (non destructive testing) in evaluation, troubleshooting, research, and quality control.
-
Product
Film Thickness Mapping Systems
-
Angstrom Sun Technologies, Inc.
Spectroscopic reflectometer mapping (SRM) tools are for industry or lab routine thin film uniformity measurement. This is relatively low cost and easy to use setup. Mapping size can be configured from 2" to 18" if needed. Dependent on film thickness range, a broad wavelength range can be configured within DUV, Vis and/or NIR range. A user-friendly software interface allows you to define various mapping patterns to map. A CCD array based detecting and data acquisition mechanism offers fast measurements. 2D/3D data presentation gives user option to quickly generate reports.
-
Product
Charge Coupled Device (CCD) Image Sensors for Space and Ground-Based Astronomy
-
(CCDs) for Space science, Ground-based Astronomy, and Earth observation applications with an impressive record of successful deliveries to a wide range of customers over 40 years.All Teledyne e2v devices can be supplied partially or fully customised to fit the application and achieve the best possible system performance. CCD image sensor design, manufacture, test and characterisation are carried out in-house enabling control from start to finish. Multi-polysilicon, multi-metal and back-illumination options are available for high resolution, high sensitivity and very low noise.
-
Product
Flying Probe
EnteFP-5060TDR
-
Two head TDR flying probe with rotation, max panel size: 20X24, accuracy +/25um, CCD camera alignment.
-
Product
Deep Cooled UV/Vis/NIR and VUV Scientific Cameras
Syncerity Scientific Cameras
-
HORIBA Scientific offers a complete line of spectroscopic multi-channel detectors for scientific research. For spectral detection from UV to near-IR, two dimensional CCDs offering a faster acquisition option over single point detectors with relatively high sensitivity. Coupled with HORIBA’s range of aberration corrected flat field imaging spectrographs, OEM packages can be assembled for a variety of applications.
-
Product
CCD Spectroradiometer Integrating Sphere Compact System
LPCE-3
-
LPCE-3 is a CCD Spectroradiometer Integrating Sphere Compact System for LED Testing. It is suitable for photometric and colorimetric measurement of luminaries such as LEDs, LED luminaires, Energy-saving lamps, Fluorescent lamps, HID lamps (high voltage sodium lamps and high voltage mercury lamps) and CCFL. The measured data meets the requirements of CIE, EN and LM-79 clause 9.1 for the measurement of photometry and colorimetry.
-
Product
LMS-7000CCD Spectroradiometer
LMS-7000
-
LMS-7000 CCD Spectroradiometer is applied with TOSHIBA TCD1304DG linear array CCD detector, measurement speed is very quick and cost-saving.• The following wavelength range is with 0.8nm FWHM: • Integrating time is 1ms to 60s • CCD Detector is 3648pix which size is 8μm×200mμm • SNR (Signal to Noise Ratio) is 1000: 1 (Full range). A/D is 16bit • Communicate with PC by USB2.0. The software has a rich re-develop platform which can be run in WinXP and Win7. • Optical port is SMA905
-
Product
Raman Spectrometer
IndiRAM CTR Series
Spectrometer
CTR series Raman Spectrometer is a state-of-the-art Raman Spectrometer with an unmatched capability to identify a broad range of materials, as well as to quantify material concentrations at femto-molar level. The system comprises of one or more laser sources, an imaging spectrometer, TE cooled (-10oC / -60oC) CCD camera, an optical magnifying lens with a spatial resolution < 1µm. The CTR series Raman Spectrometer offers unparalleled sensitivity and resolution, making it ideal for nanoscale analysis and intricate molecular investigations. Easy to use, Microsoft Windows-based control and data processing software enables the user to comfortably operate the spectrometer.
-
Product
Scientific Cameras
-
Thorlabs' Scientific-Grade Cameras are specifically designed for microscopy and other demanding applications. The Zelux™ CMOS cameras have small footprints and provide cost-effective solutions for general-purpose imaging applications. Kiralux® cameras have CMOS sensors with high quantum efficiency in a compact housing and are offered in monochrome, color, NIR-enhanced, and polarization-sensitive versions. Our polarization-sensitive CMOS camera is ideal for materials inspection, flaw detection, and other advanced techniques using polarization. The Quantalux® monochrome sCMOS cameras are fast frame rate imagers that combine high dynamic range with extremely low read noise for low-light applications. They are available in either a passively cooled compact housing or a hermetically sealed TE-cooled housing. We also offer scientific CCD cameras with a variety of features, including versions optimized for operation at UV, visible, or NIR wavelengths; fast-frame-rate cameras; TE-cooled or non-cooled housings; and versions with the sensor face plate removed. An intuitive software package, API and SDK for developers, and third-party software support provide options for custom system control and image acquisition.
-
Product
SystemSolutions
-
Whether your application is characterizing a massive mosaic of CCDs for the next great observatory, designing a faster FLIR for a weapons-guidance system, or production-testing a CMOS image sensor for a digital camera, Pulse Instruments can supply you with a fully-integrated test system that allows you to focus on your yourdevice, not on your test system.
-
Product
CMOS Standard Image Sensors
-
The vision market is constantly looking for highly specialised, cost effective solutions where performance is not compromised. Teledyne e2v has over 40 years of heritage in imaging, with a background in the design and manufacture of CCD and CMOS image sensors.Capabilities include ultra-high speed and ultra-low noise. Teledyne e2v’s unique approach involves listening to the market/application challenges of customers and partnering with them to provide an innovative solution which brings real value to their systems.
-
Product
Microscope Cameras
-
In contrast to digital cameras for normal photography, microscope cameras are built to meet the demands of high-end science- and research applications. For maximum light sensitivity they use large CCD or CMOS sensors for image acquisition. Color reproduction is often critical, why features like Microscanning or Color-Co-Site Sampling ensure optimal image quality. Due to the lack of a light absorbing color filter monochrome microscope cameras for fluorescence imaging are even more sensitive.
-
Product
Video Microcope
BVM-20101
-
High-resolution CCD sensor, built-in analog/digital converter, analog and digital signal directly display on the screen, can also simultaneously display on TV and computer through corresponding interfaces; taking photo and video through software; easy operation, reducing user's fatigue and injury.
-
Product
High Volume Semiconductor Substrate Interconnect Tester
GATS-2100
-
Pre-align *load *CCD camera alignment *electrical test * unload * sort of pass, opens, shorts, and alignment errors.The GATS-2100 concurrent approach provides unmatched volume capability... 2.5 seconds per device. As with all Nidec-Read Test systems, the GATS-2100 offers you the most test technologies for your requirements
-
Product
Micro Vickers Hardness Testers
HMV-G Series
-
This micro hardness tester features a built-in CCD camera for standardized automatic length measurement. Hardness can be measured simply and accurately with easy-touse PC software. The lineup also includes fully automated (FA) machines equipped with an electrically driven revolver mechanism and electrically driven XYZ. A manual machine with an optical head and models with color cameras are also included in the lineup.
-
Product
Machine Vision Camera - 2.3 MP, 48 FPS, Sony IMX174, Color
Grasshopper3 GigE
-
The Grasshopper®3 GigE camera family utilizes primarily Sony CCD sensors and the Sony Pregius IMX174 sensor. For FLIR GigE cameras with the latest sensors and most advanced feature sets, please refer to our Blackfly S and Oryx camera families.
-
Product
CCD Camera
MicroPublisher 6
-
The MicroPublisher 6 CCD camera is a great solution for high resolution color microscopy imaging. This 6 megapixel camera delivers high quality color images with a large field of view and accurate color representation. Connects easily through high speed USB 3.0.
-
Product
Long Range HD Multi-Spectral Surveillance System (Single LRU)
TacFLIR® 380-HD
-
The TacFLIR 380-HD is a state-of-the-art ISTAR sensor designed for land vehicle applications. Identical to airborne and maritime versions of the Star SAFIRE 380-HD, TacFLIR 380-HD goes further with other sealings and shock mounts for land vehicle environments. Payloads include a MWIR camera with a native 1280x720 resolution, HD CCD cameras, HD SWIR camera, a laser range finder, and a laser pointer. 6-axis stabilization gives the TacFLIR 380-HD unmatched geolock and target tracking capabilities.
-
Product
Data Acquisition
-
For devices with analog outputs, we are now shipping our new multi-channel data acquisition system. This high-speed, low-noise solution is highly modular, so you can test scientific CCDs and high-speed machine-vision CMOS sensors with the same basic system. Swappable pre-amps and A/D converter modules enable you to reconfigure your test system to fit your needs.
