Micro Ohmmeters
measure low resistance in µA.
See Also: Ohmmeters, Teraohm Meters, Megohmmeters, Microhmmeters
-
Product
Micro Coax, Contact, ITA, RG178
610141102
Coax Contact (ITA)
Primary mating contact 610140102. (May mate with other Receiver contacts, as well.)
-
Product
Signal / Micro Power/ Micro Coax, Module, Receiver, QuadraPaddle, iCon Series, 100/15 Position, loaded w/twin female contacts
510160112
Receiver Module
This module comes fully loaded with twin female contacts (p/n 610138200), iCon modules mount from the rear of the iCon/i1 receiver allowing installation and removal of pre-wired cable blocks. Primary mating module 510161107. (May mate with other ITA modules, as well.)
-
Product
Receiver, G6, 6 Module, Keying Feature, includes Micro Switch
310104336
Receiver
Receiver, G6, 6 Module, Keying Feature, includes Micro Switch
-
Product
Near Field Micro Probes ICR HH H Field
-
The measuring coil is horizontally located in the probe head. The near field micro probes are operated with a positioning system (Langer Scanner).
-
Product
50/75 Ohm Micro Coax Contacts
Coax Contact
Rated to 3 GHz using RG 316 or RG 178 Max of 10.5 GHz using RG 316 Double Shield.Rated to 10,000 cycles.50 and 75 Ohm impedance.Mating force of 1.5 lb.High density I/O Crimp contact designed for RG 316, RG 178, and RG 179 wire.
-
Product
18 Pc. Micro 64 Test Connector Kit
147
-
Test connector kit featuring a variety of terminal adapter sets which enable connection to Micro64 terminals - primarily found on GM vehicles and some EU/Asian/Domestic vehicles. Adapters connect via the included 48 inch stacking banana plug test leads. Connection to most DMM’s and scopes is no problem. Kit is designed to provide a quality & secure test connection while quickening the test process.
-
Product
Micro probes 1 MHz up to 1 GHz
MFA 02 set
-
The two in the set included micro probes are used to measure low-frequency magnetic fields up to 1 GHz, e.g. at signal conductors (150µm), SMD componets (0603-0201) or IC pins. The MFA micro probes are guided by hand. An amplifier stage is integrated into the probe head. The amplifier stage (9V, 100mA) is powered via the BT 706 Bias tee. It has an impedance of 50 Ohm. The micro probes are connected via the Bias tee to a spectrum analyzer or an oscilloscope. The MFA 02 set delivery of Langer EMV-Technik GmbH includes correction lines. With the help of the correction lines the probe output voltage is converted either into the respective magnetic field or to the current which is running through the conductor.
-
Product
Cable Assembly, Receiver, TriPaddle / Micro Coax, 20", 68 VHDCI & (2) BNC
540353020159
Cable Assembly
Cable Assembly, Receiver, TriPaddle / Micro Coax, 20", 68 VHDCI & (2) BNC.
-
Product
Fully-automatic Micro Hardness IRHD System
-
With high precision digital technology and servomotor technology employed, the Micro IRHD System has been designed on the concept of better operability and quality eligible for cutting-edge labs.
-
Product
Micro Spectrophotometer
USPM-RU III
-
The USPM-RU III is a reflectometer that provides highly accurate spectral reflectivity measurements of small, curved, and thin samples without interference from rear surface-reflected light. The curved surface of the lens can be measured from a minute spot as small as ø60 µm formed on the sample surface. This provides the ability to use a goniometer to examine even the curved side lenses or other optical component.
-
Product
ITA, I2 Micro ICon, 168 Position
410130101
ITA
The i2 Micro iCon ITA is capable of holding up to 168 QuadraPaddle contacts. Its sleek, 0.8” footprint increases the horizontal stackability. The 30 degree U-shaped cable clamp allows ITA modules to be pre-wired before assembly and can hold cable bundles with an oblong bushing effective diameter of 0.77 in. The removable cover allows easy access to wiring for maintenance and probing. Integrated spring locking tabs ensure even and secure engagement.
-
