Micro Ohmmeters
measure low resistance in µA.
See Also: Ohmmeters, Teraohm Meters, Megohmmeters, Microhmmeters
-
product
Wide Range Ohmmeter
PAS-853B
- Wide Resistance Measurement Range from 0.01 ohm to 9.99x1012 ohms- Nominal Full Range Tolerance Averages <±5%- Fully Automatic Resistance Range, Test Voltage and Electrification Period Control- Automatic or Continuous Electrification ControlRugged High Performance 80 inches (200cm) Test Leads Included- Powered by one long lasting 9V Alkaline Battery- Large, Easy to Read LCD Display- Meets requirements of ESD Association Standards for material and audit resistance measurement requirements- Certificate of Calibration Traceable to NIST included
-
product
SD & Micro SD Duplicators And Testers
International Microsystems Inc.
International Microsystems makes the best SD and Micro SD card tester / copier and duplicator on the market. We can quickly clone your SD memory cards with our fast 8, 16, and 32 slot machines. Our ease-to-use tester/ duplicators support stand-alone operation.
-
product
Receiver, i2 Micro iCon, 168 Position, Unloaded, for Twin Female QuadraPaddle Contacts
310130107
This i2 Micro iCon receiver comes ready to load with twin female contacts (610 138 200)
-
product
Micro Coax, Contact, ITA, RG316 Double Shield
610141104
Primary mating contact 610140104. (May mate with other Receiver contacts, as well.)Mechanical SpecificationsDurability 10,000 cyclesContact Material Center Conductor – BeCuShield – BrassContact Plating 50µ" Au over 100µ" NiContact Termination Center Conductor - SolderShield - SolderInsulator PTFEMating Force 1.5 lbs max [0.68 kg]Electrical SpecificationsCharacteristic Impedance 50ΩFrequency Range DC – 10.5 GHzVSWR 1.0225 +.05 f(GHz)Insertion Loss – √f(GHz) x .06 dBDWV 800 V RMSContact Resistance 6 mOhms center/4 mOhms outer Cable Specifications RG316 Double ShieldEnvironmental SpecificationsOperating Temperature -65°C to +125°CVibration MIL-STD 202, Method 204, Test Condition DShock MIL-STD 202, Method 213, Test Condition IInsulation Resistance 2000 MOhms Min.
-
product
Micro probes 1 MHz up to 1 GHz
MFA 02 set
The two in the set included micro probes are used to measure low-frequency magnetic fields up to 1 GHz, e.g. at signal conductors (150µm), SMD componets (0603-0201) or IC pins. The MFA micro probes are guided by hand. An amplifier stage is integrated into the probe head. The amplifier stage (9V, 100mA) is powered via the BT 706 Bias tee. It has an impedance of 50 Ohm. The micro probes are connected via the Bias tee to a spectrum analyzer or an oscilloscope. The MFA 02 set delivery of Langer EMV-Technik GmbH includes correction lines. With the help of the correction lines the probe output voltage is converted either into the respective magnetic field or to the current which is running through the conductor.
-
product
Micro Power/ Micro Coax, Module, Receiver, 90 Series, 50 Positions
510104267
Primary mating module 510108262.
-
product
micro CHP system
BlueGEN
With Bluegen, you generate highly efficient electricity and heat right at the point of consumption, helping you to reduce your energy costs as well as your carbon emissions. The micro CHP unit from SolydEra, based on cutting-edge fuel cell technology, is without equal in the world and is ideally suited for application in residential and commercial buildings.
-
product
Micro Coax, Contact, Receiver, RG178
610140102
Primary mating contact 610141102. (May mate with other ITA contacts, as well.)Mechanical SpecificationsDurability 10,000 cyclesContact Material Center Conductor – BeCuShield – BrassContact Plating 50µ" Au over 100µ" NiContact Termination Center Conductor - SolderShield - CrimpInsulator PTFEMating Force 1.5 lbs max [0.68 kg]Electrical SpecificationsCharacteristic Impedance 50ΩFrequency Range DC to 3 GHzVSWR 1.22 @ 3 GHzInsertion Loss – √f(GHz) x .06 dBDWV 800 V RMSContact Resistance 6 mOhms center/4 mOhms outer Cable Specifications RG178Environmental SpecificationsOperating Temperature -65°C to +125°CVibration MIL-STD 202, Method 204, Test Condition DShock MIL-STD 202, Method 213, Test Condition IInsulation Resistance 2000 MOhms Min.
-
product
Near Field Micro Probe Sets
The near field probe is designed for a high-resolution measurement of electrical near fields.
-
product
Cable Assembly, Receiver, Micro Coax, 36", 10 SMB Plugs
540092010247
Cable Assembly, Receiver, Micro Coax, 36", 10 SMB Plugs.
-
product
Cable Assembly, Receiver, 20", Micro Coax, 12 SMA Plugs
540099010147
Cable Assembly, Receiver, 20", Micro Coax, 12 SMA Plugs.
-
product
Receiver, I2 Micro ICon, 120/12 Position Hybrid, Loaded With Twin Female Contacts (610 138 200)
310130104
The i2 Micro iCon receiver is a one piece connector capable of holding up to 120 Signal QuadraPaddle contacts and 12 Micro Coax or Micro Power. QuadraPaddle modules are molded on .100” (2.54 mm) centers to meet the need for high-density I/O in a compact assembly. This i2 receiver is pre-loaded with twin female contacts, QuadraPaddle Part # 610 138 200. Accessories such as keying pin kits, protective covers, and strain relief are available.
-
product
Micro Capacity Type Torque Detector
MD Series
The MD series torque detector is designed to measure the torque output from compact & precision type motors used in the electric & electronics industry, the automotive industries and so on, featuring outstanding low inertia and low starting torque. With the phase differential system, it can realize low capacity torque measurement as small as 0.001mNm.
-
product
Micro Power, Contact, ITA, 21 Amp, 12-14 AWG
610143101
Primary mating contact 610142101. (May mate with other Receiver contacts, as well.)Specifications Operating Current 21 amps continuousContact Resistance 1.5 mOhms max.Dielectric Withstanding Voltage (DWV) 1500 VDC min.Contact Body BrassContact Plating 30µ" Au over 100µ" NiContact Termination CrimpCycle Life 10,000 cyclesRoHS Directive 2011/65/EU Status CompliantREACH Article 33 Status CompliantECHA Article 59 of Reach Regulation CompliantAVG Mating Force (lbs) 1.23u
-
product
Cable Assembly, Receiver, TriPaddle, 72", 37-Pin Female D-sub and 4 POS Micro Fit Connector
540016070501
Cable Assembly, Receiver, TriPaddle, 72", 37-Pin Female D-sub and 4 POS Micro Fit Connector.
-
product
Cable Assembly, Receiver, 20", Micro Power to 41-Pin FML Power Connector, for VTI EX1200-2001 Switch Module
540249010147
CBA, RCV, MicroPWR to 41-Pin J1 PWR Conn f/VTI EX1200-2001 Switch Module.
-
product
Cable Assembly, Receiver, 20", Micro Power and Micro Coax, 4 BNC Plugs and 4 SMB Plugs
540297010147
Cable Assembly, Receiver, 20", Micro Power and Micro Coax, 4 BNC Plugs and 4 SMB Plugs
-
-
product
Micro and Milliohmmeter
AD-7010
AD-7010 instrument is designed to measure, with high accuracy, the resistance of conductive elements power equipment: motor windings, transformer windings, conductor rails, inspecting the electrical conductivity of bolted joints, crimped, welded, the contacts of switches and relays.
-
product
Micro Mechatronics
Murata offers compact, high-performance microblowers and actuators that utilize the vibration and deformation characteristics of piezoelectric ceramics.
-
product
Cable Assembly, Receiver, 36", Micro Coax, 12 SMA Plugs
540099010247
Cable Assembly, Receiver, 36", Micro Coax, 12 SMA Plugs.
-
product
Micro Power Insert, Receiver, SIM, 2 Position, 2 Slot
510180102
This insert contains 2 micropower contacts and is part of the Infinity Connector system. It is used in the 90 Series SIM Module and occupies 2 of the 34 slots in this module. This insert comes loaded with contacts. Individual contacts sold separately p/n 610142106.
-
product
Micro Coax, Patchcord, ITA , 36", 50 GHz, Flex 405, to 2.4 MM Plug
7-372105764-036
Micro Coax, Patchcord, ITA , 36", 50 GHz, Flex 405, to 2.4 MM Plug.
-
product
Tool, Crimp Die, Micro Coax, f/ RG 316 and RG 179 wire
910101133
Included in Tool kit 910101132.
-
product
Cable Assembly, Receiver, 36", Micro Power & Mini Coax, PXI (2) 20 PIN PWR
540054030247
Cable Assembly, Receiver, 36", Micro Power & Mini Coax, PXI (2) 20 PIN PWR
-
product
Receiver, I2 Micro ICon, 168 Position, Fully Loaded With Twin Female Contacts (610 138 200)
310130101
The i2 Micro iCon receiver is a one piece connector capable of holding up to 168 QuadraPaddle contacts. QuadraPaddle modules are molded on .100” (2.54 mm) centers to meet the need for high-density I/O in a compact assembly. This i2 receiver is fully loaded with twin female contacts, QuadraPaddle Part # 610 138 200. Accessories such as keying pin kit, protective cover, and strain relief are available.
-
product
Near Field Micro Probe ICR HV H Field
The measurement coil is located vertically in the probe head. The near field probes are run with a positioning system (Langer Scanner).
-
product
Coax, Patchcord, ITA, 72", Micro Coax, RG178, Single Ended
7-363178000-072
Coax, Patchcord, ITA, 72", Micro Coax, RG178, Single Ended.
-
product
TERA Ohmmeter
Due to its compact design and battery operation, our TERA ohmmeters are ideally suited for mobile applications in industrial areas; They can also be in a stationary way through their mains connection. They are operated by only two buttons, are menu-driven and therefore very user-friendly. All settings are in the LCD display.
-
product
Micro Coax, Patchcord, ITA, 72", 50 GHz, Flex 405, to 50GHz Receiver
7-372105371-072
Micro Coax, Patchcord, ITA, 72", 50 GHz, Flex 405, to 50GHz Receiver.
