Filter Results By:
Products
Applications
Manufacturers
-
product
Rain Indicator Data Logger
HD2013-DB
Rain indicator Data Logger with LCD display; reads and stores up to 32,255 pulses coming from a rain gauge with tipping bucket.
-
product
Rain Test Chamber
Wewon Environmental Chambers Co, Ltd.
Water pump for rain test chambers uses highly pressure stainless steel pump, ensure water pressure and flow of the test cycle, the pump is installed in the side of the IP test device, and both ends of the inlet and outlet to set up the joint, easy to replace and repair. Water tank can be disassembled,The corresponding joint or hose connection is arranged in the water pipe connection.
-
product
IPX3 IPX4 Rain Test System
CX-RIP3/4
Shenzhen Chuangxin Instruments Co., Ltd.
For checking the protection against water with spray nozzle of 0,4 mm bore are used to prove the degrees of protection for the second characteristic numerals 3 and 4 “Protection against Spraying Water” resp. “Protection against splashing Water”.
-
product
High Voltage Isolation Switch Contact Pressure Tester
WA1401
Wuhan Sangao Electrical Test Installations Limit Co.
Isolation switch is the high voltage switch equipment, it was large and frequently use in power system . The outdoor isolating switch is the only completely exposed in the atmospheric environment electrical equipment, It is also a electrical equipment affected by climatic conditions influence the most direct and most serious. The operating conditions is relatively poor, It is easy to generate fault of mechanical or electrical. Especially the finger contact part is easy to be affected by rain, dust and harmful gas invasion, resulting in poor contact caused fever, provide the spring with contact pressure due to heating and annealing for reducing the pressure, so that more cause finger heat form vicious spiral eventually burn out finger accident. In maintenance often only pay attention to replace the obvious failure and fracture of spring, but spring to reduce the pressure can not judge and replacement, so again in the operation, each finger current distribution by the pressure difference, The greater the difference between the current distribution is not uniform, long-term operation will occur is bad and the overheating. Fever finger will be vicious spiral, a finger contact bad will spread over the entire bad contact. At the same time, there are a lot of isolating switch contact pressure can be adjusted, if in maintenance adjustment pressure is not enough or each finger to adjust the pressure difference will also appear afore-mentioned phenomena.
-
product
Environmental Testing
Environmental Testing is the evaluation of a product in conditions which simulate the physical environments that may harm or adversely affect the products performance. Environmental testing can play an important role throughout a product's development cycle to ensure that the materials and manufacturing processes can survive the stresses of the environment in which the product is likely to operate. These environments may include high and low temperatures as well as quickly changing temperatures. Also, temperature humidity environments may also be a factor. Environments with an added media such as dust, ice and freezing rain may also have an adverse effect on products. Listed below are some of Global Testing Services Environmental Testing capabilities
-
product
UL Rain Spray Test Device With Nozzle
CX-UL56
Shenzhen Chuangxin Instruments Co., Ltd.
UL rain spray test device with nozzle Size:500*800*2000mm((adjustable height 1000~2000mm)Nozzle water column intersection from the ground height 0-1400mm adjustable
-
product
IPX9K Rain Spray Testing Chamber / Rain Resistant Test Machine
CX-IP9K
Shenzhen Chuangxin Instruments Co., Ltd.
Water Spray Test Equipment is used to test the water resistance; which is mainly for electronic and electrical products. It can also provide references for product design and quality control.
-
product
Present Weather Sensors
Bristol Industrial & Research Associates Ltd
Biral forward scatter Present Weather Sensors measure visibility and report precipitation type and intensity. These compact sensors can identify a wide range of precipitation types including drizzle, rain, snow, hail, freezing rain and other forms of frozen precipitation. Precipitation type is reported using a combination of WMO Table 4680 and METAR codes. The range of precipitation types identified varies with sensor model.
-
product
Bundesmann Rain Tester
Sataton Instruments Technology CO., Ltd
Bundesmann rain tester which is also called as Bundesmann water repellency tester can provide artificial rainfall to simulate the process of rain under natural environment. The tester is designed to determine the water repellency of fabrics by the bundesmann rain shower method. It can provide water repellency performance of tested materials under a certain rainfall in a certain time.
-
-
product
IP X3, X4 - Rain Test Chamber
The rain water or moisture penetrating through a leak in the case, can often reach into the circuit board and lead to failure of the equipment. This problem is frequently encountered with external equipments and devices during storage, usage or transportation in a rainy weather. Therefore, the automotive industries and various research and developmental units often use Rain Test Chambers to test the quality and performance of the product in such extreme environments.Weiber's Rain Test Chambers are such Rain Testing Machines/Chambers used for the testing of automobiles, electronic parts and components, light equipments, voltage cabinets and other wide variety of products under a rainy environment. These IP Test Chamber and IP Testing Chambers are designed to simulate specific environmental conditions, mimicking a natural rainy weather, to test the seals and water proofing capacity of the equipment and devices, thereby providing an estimation of the product performance over a period of time.
-
product
Mid-Range Pan/Tilt Multi-Sensor
DefendIR
The Ranger® MS-UC DefendIR is an industry-leading mid-range thermal imager that can see in complete darkness and through a multitude of environmental conditions, including smoke, rain, snow, dust, and dense fog. The Ranger DefendIR is ideally suited for day and night perimeter security, maritime surveillance, and DHS/DoD applications. The ruggedized housing is environmentally sealed and certified to meet NEMA4X and IP66 specifications, standing up to the most challenging weather and temperature conditions.
-
product
Rainfall Transmitter
Model A70 Rainfall Transmitter converts the signal from a tipping bucket rain gauge into a 4-20 mA signal for input to a computer, meters, system controls or other instrumentation. It features reliability, low cost, accuracy, simplicity of operation and ruggedness.
-
product
UV Accelerated Weathering Tester
TF424
TESTEX Testing Equipment Systems Ltd.
UV Accelerated Weathering Tester, age tester, to simulate the testing environment of sunlight, rain, and dew to reproduce the effect of sunlight with fluorescent ultraviolet lamps, providing rain and dew with condensing humidity. The aging of the specimens is accelerated by exposing the samples to alternating cycles of light and moisture at a certain temperature.
-
product
Standard Electromagnetic Vibrator
KD-9363-EM
King Design Industrial Co., Ltd.
The purpose of vibration testing is to make a series of controllable vibration simulation in lab, no matter generated by natural or man-made vibration environment; such as waves, tidal flaps, wind, earthquake or rain and so on. It is to test if the product is capable of sustaining the vibration environment exerted from transporting or usage along its effective life cycle; and certify the standard of design & functional requirement of product. The value of vibration testing is to confirm the reliability of products and effectively screen out the bad products in factory; avoiding damages occurred at arrival; and to assess the failure analysis on the non-performing products; expecting to reach a high standard, high-reliability products. The vibration test stresses on the continuity and fatigue; and contributes to the understanding of product’s status under vibration circumstance in a normal environment; and avoids the product’s unpredictable damage caused under certain vibrating frequency for a long time.
-
product
Rain Chambers
ER-SERIES
ER-Series Rain Chambers are designed and manufactured to meet IP tests viz., IP Test (X1 to X8) IP Test (X4K, X6K & X9K) in different possible configurations ER-Series Rain Chambers are also built according to various other international standards viz., BIS, JIS, IEC-60529, EN, DIN, JSS-55555, MIL etc.,
-
product
IEC60529 IPX1/2 Rain Resistance Tester
IPX12A-600
Shenzhen Chuangxin Instruments Co., Ltd.
The IEC60529 IPX1/2 Rain Resistance Tester is designed according to the <> of IEC60529 standard, GB7000.1 and GB4208-2008. IEC60529 IPX1/2 Rain Resistance Tester is mainly used to simulate the product under the condition of the rain climate to test the products’ physical properties.
-
product
Miniature Zirconia Oxygen Analyzer with Pump to be DIN Rain Mounted as a True OEM
Rapidox 1100Z-OEM-RSB & 1100ZR3-OEM-RSB
The new Rapidox 1100Z-OEM-RSB is the World’s first miniature zirconia oxygen analyser with pump designed to be DIN rail mounted into customer’s equipment as a true OEM. The Rapidox 1100-OEM-RSB is a cost-effective 24Vdc OEM version of our sampling 1100 zirconia analyser range. The package has been shrunk down and simplified to fit onto a DIN rail in an electrical cabinet, and comprises a compact control unit (with or without OLED display and menu keypad), a zirconia sensor with sample connection points, a particle filter and a powerful miniature sample pump capable of drawing a gas sample at up to 1.5 litres per minute through 6mm OD/4mm ID flexible tubing.
-
product
Water-cooled Light & Weather Fastness Tester
TESTEX Testing Equipment Systems Ltd.
Xenon Lamp Weather Resistance Test Chamber, to determine the color fastness, aging resistance of textiles, plastics, rubber products or materials by objecting to the simulated conditions of nature weather (daylight, rain, temperature and humidity, etc.). Water-cooled Light Fastness Tester complies with ISO105 – B02 / B04 / 06, AATCC 16, AATCC 169, etc.
-
product
Present Weather Sensors
Present weather sensors use a laser-based technology to measure the size and velocity of water droplets in the air to determine visibility, measure precipitation rate, and identify precipitation type (for example, drizzle, rain, snow, and hail). These sensors are often incorporated in automatic weather stations for road, marine, and airport applications.
-
product
Photodiodes
Opto Diode manufactures high quality standard and custom photodiodes. Our wide range of standard device feature low dark current and low capacitance. The silicon detectors are ideal for general purpose applications, laser monitoring, position sensing, measuring photons, electrons, or X-rays, or for detecting sun and rain applications. The devices operate from the deep UV to the near-infrared wavelengths.
-
product
Data Logger with GSM/GPRS Module
HD33M-MB.2
GSM/GPRS data logger. RS485 MODBUS-RTU input, additional contact input for rain gauge. Great to combine with HD52.3D and HD51.3D series anemometers!
-
product
Rain Xplorer Inline
The CISC RAIN Xplorer Inline is a unit for high-speed performance testing of RAIN inlays and tags during the production process. It offers quality assurance during the production process from start to end. RAIN Xplorer Inline is available with a GUI but also allows full integration into assembly machines through serial interfaces, trigger lines, and API.
-
product
IEC60529 IPX3-IPX4 Rain Proof Test Machine
CX-IPX34A
Shenzhen Chuangxin Instruments Co., Ltd.
IEC60529 IPX3-IPX4 Rain Proof Test Machine Application The rain test system is strictly designed according to IEC60529. It’s applied to the Electrical equipment of the waterproof test of IPX3 and IPX4.
-
product
Environmental Testers
Axi'An Beicheng Electronics Co., LTD.
Environmental Testers by RuoShui: digital thermometers, thermal imaging analyzer, infrared thermal imager, thermo-hygrometer, nicety meters, rain gauge, coating thickness gauges, combustible gas detector and monitor, carbon monoxide monitor, digital anemometer, vibrometer meters, storboscope tachometers, digital tachometer, combustible gas detectors, 4 in 1 gas detector, digital refractometer, wood moisture meter, lux meter, sound level meter, sound meter, and more.
-
product
IEC60529 Ipx56 Water Spray Test Device
IPX56A
Shenzhen Chuangxin Instruments Co., Ltd.
The ipx5/6 rain testing machine is designed according to IEC60529 standard.
-
product
High-precision Surface Inspection for Wind Turbine Blades
waveCHECK™
8tree's waveCHECK is a handheld-portable 3D-inspection tool for inspecting wind turbine blades in manufacturing and operation. Its efficient detection of surface defects and instant visual feedback revolutionize surface inspection.It can detect wrinkles, steps, gaps, rain erosion and any other surface damage.
-
product
Air Quality Measurement
Air pollution measurement is the process of collecting and measuring the components of air pollution, notably gases and particulates. The earliest devices used to measure pollution include rain gauges, Ringelmann charts for measuring smoke, and simple soot and dust collectors known as deposit gauges.
-
product
Water-cooled Light & Weather Fastness Tester
TF422
TESTEX Testing Equipment Systems Ltd.
Water-cooled Light & Weather Fastness Tester, to determine the color fastness, aging resistance of textiles, plastics, rubber products or materials by objecting to the simulated conditions of nature weather (daylight, rain, temperature and humidity, etc.). The tester simulates both light and dark cycles and nature weather conditions by rack sprays and water-cooled long-arc-xenon lamp equipped.
-
product
UV-measurement probes
For example, some UV probes must work reliably at high temperatures, in rain or under water. Meander MDR-10 (available in our shop). EMC-tested switching power supply with protective conductor connection, eg Meanwell MDR-10.
