Media Access Control
-
product
Indoor Air Quality Monitor and Controller
VAT930-CO2/VAT930-CO2-VOC88
Shanghai Yi Hua V&A Instrument Co., Ltd. CO.,LTD
indoor air quality monitor and controller ( temperature meter. humidity meter . CO2 meter.VOC meter).
-
product
PathWave BenchVue LCR Meter Control App
BV0014B
Easily control your LCR meters with corrections, list sweeps, and more. Visualize results and create automated test for faster insights.
-
product
2-Port 9 GHz Analyzer, Direct Receiver Access
C2209
C2209 Vector Network Analyzer delivers industry-leading dynamic range and sweep speed, with all the features engineers have come to expect included standard in our software.
-
product
Serial Controller
PMC522/FP
The PMC522/FP provides a uniquely effective solution for integrating serial I/O requirements into a VMEbus or CompactPCI system. Implemented on a single PMC card, the PMC522/FP is fully compatible with the current generation of VMEbus and CPCI single board computers, as well as any special purpose processor that includes a PMC connector.
-
product
Fast Response Flow Controller for Low Flow
HFM-300 / HFC-302
The all metal HFM-300/HFC-302 is Teledyne Hastings' metal sealed, fast response series of mass flow meters and controllers. Featuring reliability and stability, the 300 Series is chosen by OEM's for its fast response under a wide range of conditions. .The HFM-300 / HFC-302 meters and controllers have flow ranges from 0-5 sccm to flows of 0-25 slm; provide analog outputs, are constructed of stainless steel and have normally closed valves. The full scale range is specified by the end user. A NIST traceable calibration certificate is standard. Corrosive gases and pressures up to 1000 psig are easily measured. Cleaning for oxygen service is available.
-
product
Turbine Control Solutions
NRG’s turbine control sensors are engineered exclusively for the wind energy industry. These rugged yet simple devices consistently provide accurate wind speed and direction data. With a service interval of 10 years, you can rest assured that Hybrid turbine control sensors will perform as expected with minimal maintenance. Tens of thousands of NRG sensors are being used for turbine control around the world, including regions that experience the most extreme weather conditions in both hemispheres.
-
product
JTAG Boundary-Scan Controllers for High-Volume Production Systems
Corelis has designed special hardware that autonomously performs concurrent (gang) testing and programming of multiple units without additional user intervention. The entire testing and programming, including on-the-fly verification of results, is done in modular and expandable hardware.
-
product
Universal Test Set for Recloser Controls
ARCO 400
ARCO 400 is a smart and rugged testing solution for all recloser controls. It provides the fastest way to perform simple manual trip and close checks. Using the OMICRON Smart Connect technology, ARCO 400 is capable of detecting recloser specific test adapters.
-
product
On-Off Controllers
The STM6600 and STM6601 smart push-button on/off controller chips offer protection for battery-operated devices in many ways. These include minimizing the risk of powering up without sufficient battery energy to complete the sequence, which can damage the system. It can also prevent power-up if it detects a fault in the power supply.
-
product
Space Flight Gimbals & Controllers
Precision gimbals for pointing and tracking, stabilized platforms, and pedestals have been a specialty of CAES for more than 60 years. We have deep and broad experience in both terrestrial and space applications.
-
product
Data Acquisition & Control
With these DAQ systems, you can acquire and digitize signals from variety of sources and sensors, store the data, analyze it, and present the results in local and remote locations.
-
product
cRIO-9055, 1.33 GHz Dual-Core CPU, 2 GB DRAM, 4 GB Storage, -40 °C to 70 °C, Artix-7 A100T FPGA, Extended Temperature, 4-Slot CompactRIO Controller
787043-01
1.33 GHz Dual-Core CPU, 2 GB DRAM, 4 GB Storage, -40 °C to 70 °C, Artix-7 A100T FPGA, Extended Temperature, 4-Slot CompactRIO Controller - The cRIO-9055 is a rugged, deployable controller for data acquisition and control applications. It offers Intel Atom dual-core processing, an Artix-7 FPGA, and four slots for C Series modules. It runs the NI Linux Real-Time operating system with access to the I/O through NI-DAQmx drivers or with the LabVIEW FPGA module. The controller provides precise, synchronized timing and deterministic communications over the network using TSN, ideal for distributed measurements and control. This controller offers two Gigabit Ethernet ports, one USB 3.1 host port, one USB 2.0 device port, a trigger line, and a μSD card slot for storing data locally. The registered trademark Linux® is used pursuant to a sublicense from LMI, the exclusive licensee of Linus Torvalds, owner of the mark on a worldwide basis.
-
product
Software Abstraction for Easy Control of Digital IO Devices
Konrad DigitalIO
It consists of three modules:- A windows driver which is responsible for the communication and device abstraction- A DLL with NI TestStand Test Steps which allows easy integration in automated production environments- A standalone executable which simplifies debugging and setup of test sequencesThis architecture allows to open a communication channel from multiple instances to the same device. This is important when for example an I/O channel should be used in two independent applications.
-
product
Mass Flow Controller for Medium Flow
HFM-205 / HFC-207
The HFM-205/HFC-207, Teledyne Hastings' flexible, general purpose series of mass flow meters and controllers accurately measure and control mass flow in a variety of applications. Featuring reliability and stability, the 200 Series is chosen for its very stable performance with varying ambient conditions. A wide choice of elastomer seals make this flow controller compatible with most gases.The HFM-205 / HFC-207 meters and controllers have flow ranges from 0-1000 slm to flows of 0-2500 slm; provide analog outputs, are constructed of stainless steel and can be configured with normally open or normally closed valves. The full scale range is specified by the end user. A NIST traceable calibration certificate is standard. With a full complement of fitting and elastomer options, the HFM-205/ HFC-207 covers a wide range of high flow applications.
-
product
NVIDIA GPU And Intel® Xeon® AI Computing Platform For Autonomous Drive Applications
AVA-3510
The AVA-3510 Series is powered by an Intel® Xeon® E processor coupled with workstation-grade Intel®C246 chipset to support up to 64 GB ECC DDR4 memory. The system incorporates one 2.5" SSD 256G for easy installation as optional accessories for fast read/write performance.
-
product
Walk in chamber for Complex Salt Spray Test (Temperature controllable)
Guangdong Bell Experiment Equipment Co.,Ltd
Walk in chamber for Complex Salt Spray Test Relevant standards requirement1. Test Object: battery pack andsystem.2. Refer GB/T4 part 5.5.2 test method, test according to GT/T2423.17 test conditions.3. The salt solution was made up with sodium chloride (chemically pure and analytically pure) and distilled or deionized water，Its concentration is (5 + 1)% (mass fraction).4. (35 ± 2) ℃, the measured pH value is between 6.5-7.2.5. Placed the test objects in the salt spray chamber for cycling test. Each cycling duration for 24h. Spray salt solution to the test object for 8 hours under the temperature of (35± 2) ℃ , remain for 16 hours. Between the forth and the fifth hour in one cycles should be according to test requirement in GB/T 28046.1-2011, test mode with 3.2.6. Total 6 cycles testing.7. Salt spray test is not necessary for the test objects being installed in passenger, luggage or cargo compartments.
-
product
Intel® Pentium®-based VXIbus Slot-0 Controller
ProDAQ 3058
The ProDAQ 3058 Intel® Pentium-based embedded slot-0 controller is the first embedded controller to support fully the VXI-1 4.0 interface standard. Using Bustec’s high speed PCI Express to VXIbus interface it supports all VXIbus transfer modes defined in the standard including the new 2eSST block transfer mode with up to 320 MB/sec throughput.
-
product
SWB-2816, 8x46, 0.3 A, No Row Access, Reed Relay Matrix Module for SwitchBlock
781421-16
8x46, 0.3 A, Reed Matrix Module for SwitchBlock - The SWB‑2816 is a reed relay matrix module for SwitchBlock systems. Designed for high power, it can operate as an individual relay card or expand in a single carrier or single PXI chassis. You can connect any input to any output, individually or in combination. You can use matrix switches to route signals from oscilloscopes, DMMs, arbitrary waveform generators, and power supplies to various test points on a unit under test (UUT). The primary benefit of matrix switches is simplified wiring—the overall test system can easily and dynamically change the internal connection path without any external manual intervention.
-
product
Computer Controlled Photoreactors
CCP
Luzchem has developed the latest in exposure chamber technology. Our new computer controlled photoreactors (CCP-4V and CCP-ICH2) are fully computerized using a USB interface. These photoreactors will automatically log exposure conditions and optics used. New integrated power sensor will also log the intensity of the light output. Ideal for pharmaceutical testing and any other industry with stringent documentation requirements.
-
product
Quad Display Controller
PXQ540
The MicroImage PXQ540 is a true high performance quad display controller designed for demanding applications. The MicroImage Video Systems Quad Display controller has been designed for industrial and professional applications. Operation is simplified with easy to use buttons to control commonly used functions rather than having to waste time in deep menus for common functions.
-
product
Motor Control Resistors
Although these types of motor and control system are in many cases being supplanted by AC variable speed drives, it remains the case that many new installations make use of traditional resistor-based motor control on grounds of cost, simplicity and reliability.
-
product
Power Factor Controller
R5&R8
DUCATI energia introduces the new and innovative R5 and R8 power factor controllers. The compactness, the latest technology and the complete range of features make the R5 and R8 models extremely adaptable to any application context in the field of power factor correction systems for both single-phase and three-phase networks of low and medium voltage with a lot of connectivity options.
-
product
Indoor Air Quality Monitor and Controller
VAT930-CO2/VAT930-CO2-VOC35
Shanghai Yi Hua V&A Instrument Co., Ltd. CO.,LTD
Indoor air quality monitor and controller ( temperature meter. humidity meter . CO2 meter.VOC meter).
-
product
Rugged, High-Performance GPR Controller
SIR 4000
Geophysical Survey Systems, Inc.
The SIR® 4000 is GSSI’s first high-performance GPR data acquisition system designed to operate with analog and digital antennas. This evolutionary step allows for true versatility and flexibility by supporting a wide range of users across numerous applications.
-
product
Electronic Speed Controller
AFI-ESC610
AFI-ESC610 is an Electronic Speed Controller designed to drive BLDC motors. It meets the industrial requirements of high voltage and high power motor application for electrical vehicles, airplanes, boats and medium duty industrial machinery. It is rated at 6KW.
-
product
Standalone ARM-based Motion Controller
Advantech provides standalone 6-axis pulse train motion control AMAX-3110 and ARM-based EtherCAT I/O Controller AMAX-324 IO for rapid development.
-
product
CCCP Controller
CCCP is the technology behind Nüvü Camēras’ extraordinary sensitivity in low light imaging. The patented controller generates significantly less clock-induced charges (CIC) than any other CCD controller during charge transfer throughout the EMCCD (down to an average below 0.001 ē/pixel/frame), therefore allowing for greater EM gain to ultimately attain sub-electron readout noise.
-
product
Process Controller
PC200
The Badger Meter PC200 is a microprocessor-driven instrument designed for batching and filling both small and large quantities, as well as displaying total, accumulated total and flow rate. Designed to interface with our complete line of industrial flow meters, it totalizes, indicates and controls fluid flows. Many years of experience in the industrial market has allowed Badger Meter to incorporate features indispensable in the liquid batching and control operations.
-
product
Embedded Controllers And Super I/O
Our portfolio of embedded and industrial controllers supports the unique requirements and long life cycles of embedded computing applications. In each category of products, you will find an array of devices that offer a variety of features including varying numbers of fan tachometers, PECI support, General-Purpose I/O (GPIO) pins and support for different interfaces and other options to meet your specific needs. They are also backed by our client-driven obsolescence practice of continuing to supply a product for as long as possible and while demand for the product exists, which means that these industry-leading products can support your requirements today and into the future.
-
product
PXI Chassis & Controller
PXI chassis can accommodate plug-in modules according to the PXI/PXIe/cPCI standards. The basic device provides the supply, the ventilation and the bus for controlling the modules. PXI chassis differ in size and therefore in the number of slots available for compatible devices.
