Filter Results By:
Products
Applications
Manufacturers
-
product
Weighing Rain Gauge
HD2016
Weighing rain gauge, area 400 cm². 3000 cc collecting reservoir. Automatic water discharge. Operating temperature from -20 °C (with heater option) to +70 °C.
-
product
Box Rain Test Chamber
Comprehensive box rain test chamber (with swing pipe and right angle tube) is used to test the electric and electronic devices by simulating natural rainfall with spraying water from the water nozzles (holes) on swing pipe or straight tube. To estimate and recognize if the shell or sealing elements of these device could ensure a good condition of working during and after the test. The products are widely used in the industries of light, electrical, electronics, automobile, motorcycle, household electric appliances, electromechanical equipment, instruments and meters, and other industries.
-
product
Rain Xplorer Inline
The CISC RAIN Xplorer Inline is a unit for high-speed performance testing of RAIN inlays and tags during the production process. It offers quality assurance during the production process from start to end. RAIN Xplorer Inline is available with a GUI but also allows full integration into assembly machines through serial interfaces, trigger lines, and API.
-
product
RF Noise Source
NS-3
The NS-3 Broadband RF Noise Generator provides an extremely flat AWGN (Additive White Gaussian Noise) signal from 5 to 2150 MHz. The output level adjusts in 0.1 dB steps over a 30 dB range.The bench-top configuration is standard and an optional two unit rack enclosure is available. The RS232 or USB remote control interface simplifies its use in automated test and factory ATE environments. The NS-3's combination of range, versatility and value make it the ideal general purpose broad-spectrum signal source for bench and ATE applications, including C/N, BER, MER, PER testing and rain fade simulation.
-
product
Rain Chambers
ER-SERIES
ER-Series Rain Chambers are designed and manufactured to meet IP tests viz., IP Test (X1 to X8) IP Test (X4K, X6K & X9K) in different possible configurations ER-Series Rain Chambers are also built according to various other international standards viz., BIS, JIS, IEC-60529, EN, DIN, JSS-55555, MIL etc.,
-
product
High-precision Surface Inspection for Wind Turbine Blades
waveCHECK™
8tree's waveCHECK is a handheld-portable 3D-inspection tool for inspecting wind turbine blades in manufacturing and operation. Its efficient detection of surface defects and instant visual feedback revolutionize surface inspection.It can detect wrinkles, steps, gaps, rain erosion and any other surface damage.
-
product
Rain Test Chamber
Wewon Environmental Chambers Co, Ltd.
Water pump for rain test chambers uses highly pressure stainless steel pump, ensure water pressure and flow of the test cycle, the pump is installed in the side of the IP test device, and both ends of the inlet and outlet to set up the joint, easy to replace and repair. Water tank can be disassembled,The corresponding joint or hose connection is arranged in the water pipe connection.
-
product
Freezing Rain and Ice Detectors
Freezing-rain and ice detectors detect the presence of icing conditions so that appropriate actions can be taken to prevent damage to power and communication lines, to warn of road hazards, to keep ice off a plane’s wings, and to prevent ice from forming on turbine blades.
-
product
Rain Gauge
P0320
This digital, self-emptying rain gauge features an easy to read LCD readout which displays current (up to 9.99″) and accumulated rainfall (up to 99.9″) for intervals of 1hr., 24hrs., 7 days, and 30 days. Also displays accumulated rainfall since the beginning of the most recent precipitation. Can be reset daily, weekly or whenever you choose.
-
product
IPX9K Rain Spray Testing Chamber / Rain Resistant Test Machine
CX-IP9K
Shenzhen Chuangxin Instruments Co., Ltd.
Water Spray Test Equipment is used to test the water resistance; which is mainly for electronic and electrical products. It can also provide references for product design and quality control.
-
product
RFID
Zebra Technologies Corporation
Leverage Zebra’s decades of expertise, design thinking and software development to achieve maximum RAIN RFID efficiency, while minimizing the pains of multi-vendor solutions. Unlike other players, Zebra gives you the industry’s broadest, field-proven RFID portfolio for unmatched accuracy and interoperability. Connect it all and create a platform that elevates every system, device, tag and worker.
-
product
Water Testing Kits
Omega's Water Testing Kits monitor water quality in any commerical, residential, or industrial application. Rain and snow gauges are available for accurate measurement for Meteroligists
-
product
IEC60529 IPX1 To IPX4 In One Waterproof Rain Test Chamber
CX-IPX14
Shenzhen Chuangxin Instruments Co., Ltd.
IPX1 to IPX4 in one waterproof rain test chamber/equipment
-
product
IP X5, X6 - Walk-In Rain Test Chamber
WEIBER designs and manufactures standard as well as customized water spray test chamber for evaluating various automotive, electrical and electronics items under water, rain or shower conditions. The chamber interrogates the performance of parts when subjected to water droplets.The system is based on the IP X5, X6 specification requirements, and can also accomplish individual automaker’s tests, as well as electrical-enclosure tests.Our system uses multiple control solenoids to vary the water's spray volume/pressure. A holding tank prepares the water to the desired temperature, if required. A pump ensures the water is delivered in the proper pressure range.
-
product
Rainfall Transmitter
Model A70 Rainfall Transmitter converts the signal from a tipping bucket rain gauge into a 4-20 mA signal for input to a computer, meters, system controls or other instrumentation. It features reliability, low cost, accuracy, simplicity of operation and ruggedness.
-
product
IEC60529 IPX3-4 Rain Test Chamber
CX-IPX34C
Shenzhen Chuangxin Instruments Co., Ltd.
1.Rain Spray Test Chamber is designed according to the standards of IEC 60529-2001 & GB 4208-93 & GB10485 (Enclosure protection level). It is mainly used for electronic products to do the waterproof test of the second characteristic number 3 / 4. The appliance meets the test requirement of IP grade IPX3/IPX4.
-
product
Rainproof Tester
TF161
TESTEX Testing Equipment Systems Ltd.
Rainproof Tester, to determine the penetration resistance of fabrics or composites at different intensities of water impact. Simulated rain horizontally impacts fabric samples mounted vertically in a stainless steel bath. Samples are backed with a standardized blotting paper, which is weighed before and after each test. The rain is formed by a column of water, which can be adjusted from 600mm to 2400mm.
-
product
High Voltage Isolation Switch Contact Pressure Tester
WA1401
Wuhan Sangao Electrical Test Installations Limit Co.
Isolation switch is the high voltage switch equipment, it was large and frequently use in power system . The outdoor isolating switch is the only completely exposed in the atmospheric environment electrical equipment, It is also a electrical equipment affected by climatic conditions influence the most direct and most serious. The operating conditions is relatively poor, It is easy to generate fault of mechanical or electrical. Especially the finger contact part is easy to be affected by rain, dust and harmful gas invasion, resulting in poor contact caused fever, provide the spring with contact pressure due to heating and annealing for reducing the pressure, so that more cause finger heat form vicious spiral eventually burn out finger accident. In maintenance often only pay attention to replace the obvious failure and fracture of spring, but spring to reduce the pressure can not judge and replacement, so again in the operation, each finger current distribution by the pressure difference, The greater the difference between the current distribution is not uniform, long-term operation will occur is bad and the overheating. Fever finger will be vicious spiral, a finger contact bad will spread over the entire bad contact. At the same time, there are a lot of isolating switch contact pressure can be adjusted, if in maintenance adjustment pressure is not enough or each finger to adjust the pressure difference will also appear afore-mentioned phenomena.
-
product
Tipping Bucket Rain Gauge
HD2015
The HD2015 is a reliable and sturdy bucket rain gauge, entirely constructed of corrosion resistant materials in order to guarantee its durability.
-
product
IPX3/4 Swing Pipe Rain/ Water Spray Chamber
Shenzhen Chuangxin Instruments Co., Ltd.
Ipx3/4 Swing Pipe Rain/ Water Spray Chamber 1. Item name: Ipx3/4 Swing Pipe Rain/ Water Spray Climatic Chamber
-
product
IPX12A Rain Test Chamber
CX-IPX12C
Shenzhen Chuangxin Instruments Co., Ltd.
CX-IPX12A rain test chamber is in accordance with IEC 60529: 2001 "Degrees of protection provided by enclosures (IP Code)".
-
product
De-Ice
Kratos Defense & Security Solutions, Inc.
Kratos has acquired the business assets of W.B. Walton Enterprises, Inc, also known as Walton De-Ice.Walton De-Ice has been building products that protect networks from rain, snow and ice for over 40 years, including but not limited to:Antenna hot-air de-icing systemsSnow shield productsThese products are no longer available from Walton but can be sourced from Kratos going forward.
-
product
Bundesmann Rain Tester
Sataton Instruments Technology CO., Ltd
Bundesmann rain tester which is also called as Bundesmann water repellency tester can provide artificial rainfall to simulate the process of rain under natural environment. The tester is designed to determine the water repellency of fabrics by the bundesmann rain shower method. It can provide water repellency performance of tested materials under a certain rainfall in a certain time.
-
product
Precipitation Detector
HD2013.3
Rain, snow, hail detector - Modbus-RTU or 4-20mA or 0-10V or contact output.
-
product
IPX56 Simulation Rain Test Chamber
CX-IPX56A
Shenzhen Chuangxin Instruments Co., Ltd.
IPX56 Simulation Rain Test Chamber widely used in the lamps and electrical and electronic product certification testing institutions and for testing the waterproof of electrical and electronic products of shell protection level.
-
product
Rain Test Chamber
Sanwood Environmental Chambers Co ., Ltd.
Rain Test Chamber is used to test anti-rain and waterproof performance for products, the products such as .steam locomotive lamps, wiper performance, waterproof bands, motorcycle instruments, defense industry, navigation systems, missiles, radar cone top, aerospace industry, IEC IP code specifications that need an additional discussion.
-
product
Laser Open Path H2S Detector
GD1
Teledyne Gas & Flame Detection
The GD1 has been designed with features that provide an effective response to the detection of gas hazards in a wide range of industrial environments from offshore production facilities to wastewater treatment plants. At the heart of the detector is a tuneable laser diode that eliminates environmental effects from sun, rain and fog. The laser scans single absorption lines where there is no interference from other gases.The GD1 needs no recalibration and can replace multiple standard detectors to cover the same risk. The complete optomechanical design and construction is so stable that an ultra fast speed of response can be achieved while providing unparalleled service life and detector stability, thus saving on maintenance and service costs.Supplied with worldwide hazardous area approvals. Suitable for use in systems with SIL 2 requirement.
-
product
Precipitation
Bristol Industrial & Research Associates Ltd
Biral provides a wide range of instruments for the detection, measurement and study of precipitation. We offer the following classes of instrument: Precipitation Monitors to detect the presence of precipitation Rain Gauges for the measurement of precipitation amount Laser Precipitation Monitors for the detection and classification of precipitation in real-time Micro Rain Radar for the measurement of precipitation in a column up to 6km high Precipitation Collectors for the collection of precipitation for subsequent chemical analysis
-
product
IEC60529 IPX9K Waterproof Test Chamber
CX-IPX9
Shenzhen Chuangxin Instruments Co., Ltd.
The main purpose of the equipment is to test product performance of storage, transportation and use in the rain condition.The equipment, mainly used in electronic and electrical products, lamps ,lanterns, electrical cabinets, electrical components, automobiles, motorcycles and their parts etc, tests physical and other related properties of products by simulating the rain condition.After test, judge if the performance of the product meets the demand by verification for product design, improvement, check and factory inspection use.
-
product
UV-measurement probes
For example, some UV probes must work reliably at high temperatures, in rain or under water. Meander MDR-10 (available in our shop). EMC-tested switching power supply with protective conductor connection, eg Meanwell MDR-10.
