Product

Torsion Testers

10k to 300k in.lbf (1,000 to 30k N.m)

-

Tinius Olsen

10k to 300k in.lbf (1,000 to 30k N.m) - Tinius Olsen

For maximum versatility and capability, Tinius Olsen offers a full range of torsion testing machines in capacities from 10,000-300,000in.lbf or kg.cm (1000-30,000N.m). Higher capacity and other longer length models are available on request.

Product

Surge Voltage Generator

SSG 3000

-

BAUR

SSG 3000 - BAUR

Cable fault location with the BAUR SSG 3000. Surge voltage generators are used for pre-location and pinpointing of high- and low-resistive as well as intermittent faults in power cables. The energy stored in a high-voltage capacitor is released at regular intervals or as DC voltage. The thus generated acoustic signal at the fault position can be recorded with a ground microphone and a universal receiver.* High surge voltage up to 32 kV* Continuously adjustable voltage* Voltage monitoring through kV meters with 3 measuring ranges* high surge energy in each voltage range

Product

Franklin Tester

Model 717

-

Magnetic Instrumentation Inc.

Model 717 - Magnetic Instrumentation Inc.

The Model 717 Franklin Tester provides a means of testing single strips or punchings of flat rolled electrical steel, for surface insulation resistance under predetermined conditions of voltage and pressure.

Product

Qualification Tester

CableIQ

-

Fluke Networks

CableIQ - Fluke Networks

CableIQ qualification tester is the first cabling bandwidth tester for network technicians. This Ethernet network cable testergives even the most novice tech the vision to see what speeds existing cabling can support, quickly isolate cabling from network problems, and discover what is at the far end of any cable.

Product

Voltage Meter

MDN8I

-

Holding Informtest

MDN8I - Holding Informtest

MDN8I is a mezzanine module designed for high-precision measurements in dynamic signal analysis systems, as well as for joint work with ICP sensors and vibration transducers with a charge output (force sensors, dynamic pressure, acoustic emission, vibration displacement, etc.). The MDN8I mezzanine module has electrical characteristics no worse than those of most foreign and domestic counterparts, and in some parameters exceeds them.

Product

Tester Kits

-

Gardner Bender

Gardner Bender

Popular electrical testers in a storage/carry case.

Product

Peel Testers

-

IMADA, Incorporated

IMADA, Incorporated

Imada offers motorized peel testers in vertical or horizontal configurations.The motorized test stand, digital force gauge and peel fixture apply tension to a safety seals, tapes and laminates.Special attachments and fixtures facilitate 45°, 90°, 180°, ‘T’ and rotary peel tests.Motorized peel testers offer speed control and highest degree of repeatability with the ability to set a constant test speed and range of movement.All peel testers with digital force gauges have data output capability for analysis by optional data acquisition software.

Product

Circuit Testers

-

Precision Mastech Enterprises Co.

Precision Mastech Enterprises Co.

Portable, handheld electrical tools used to detect voltage, verify electrical power, check for continuity (broken circuits), and test for proper grounding in electrical systems, outlets, and automotive components.

Product

High Frequency/Microwave

-

SemiProbe

SemiProbe

SemiProbe high frequency probing solutions provide a broad array of capabilities for measurements ranging from DC to over 300 GHz. We design PS4L systems for high frequency applications with carefully selected components including chucks, probe arms, probes, cables, tuner modules, and calibration suites that are optimized for the frequency range that the application will operate in.

Product

Sensor Tester

-

Bernstein AG

Bernstein AG

*Connection facilities for DC 2-wire and 3-wire sensors, *Change in switching status signalled visually and acoustically, * 15 V operating voltage for sensors when using a 9 V block battery, * Switches off automatically when not in use, * Visual indicator for operating voltage, switching status and low battery

Product

Torque Tester

DIS-IPS series (20CL/5C)

-

Sugisaki Meter Co., Ltd.

DIS-IPS series (20CL/5C) - Sugisaki Meter Co., Ltd.

For managing various torque wrenches, torque drivers, and automatic/semi-automatic machines. The highly compact detector is ideal for automated line measurements. Five channels of pass/fail judgment conditions can be saved, and settings can be made simply by switching channels even if the tightening conditions change. Efficient measurement is possible without unwinding work by "OW joint ".

Product

High Voltage System

HV-2

-

International Electro-Magnetics, Inc.

HV-2 - International Electro-Magnetics, Inc.

*Tests Power Transformers for Continuity, Ratio and Phase. Applied and Induced Potential and No-load Losses.*14 Conductor Switching Matrix will test 7 individual windings, 13 taps of one common winding or some combination thereof. (10 Amp current limit)*The System Control is Windows/Visual Basic based. Menu screens allow full selection of test parameters and sequence. Low voltage tests can be performed first, allowing defective parts to be rejected without proceeding to time consuming induced Potential dwell routines. Test data labeling and data acquisition software can be easily added to the system.

Product

Voltage Stabilizer

MS 7643

-

Meltronics Systemtech

MS 7643 - Meltronics Systemtech

VSTAB is a voltage stabilizer, regulates the incoming supply +28V voltage into the required +15V. The electrical specifications meets MIL704 standard. Over load and short circuit protections are provided. Voltage stabilizer Module is a part of shipborne unit and it is meant for ensuring the power supply of the devices of this unit when fed from DC mains with nominal voltage of 28 V and variations of voltages from minimum 16V to maximum 32 V. The power consumption is 45 watts. The module is subjected to Qualification Tests as per MIL-STD-810G.

Product

Test Probe Connector, High Voltage, Voltage, 3 %

72-6530

-

Tenma

72-6530 - Tenma

The 72-6530 is a high voltage Testy Probe with built-in meter measures voltages up to 40kVDC.

Product

WAN Tester

-

TELINC Corporation

TELINC Corporation

The Telinc WAN Tester is a sophisticated bit error rate tester in a compact, hand held package. It can test a wide variety of communications facilities and equipment including T-1, fractional T-1, E-1, fractional E-1, modems, multiplexers, CSU/DSUs, T-1 ESF CSUs, DU, NTUs and TIUs.

Product

Differential Voltage Probes

DP150/DP200pro

-

Powertek LLC

DP150/DP200pro - Powertek LLC

The DP differential isolation probes are an important accessory for any laboratory involved in power electronics and high voltage systems. These probes allow isolated and floating measurements with any oscilloscope or data recorder, whilst the oscilloscope can remain grounded. Using a DP150 or DP200pro probe, differential and floating measurements can be made on a variety of ac power systems like 230V/110V ac input power supplies, chopped and switching power supplies, thyristor controllers, variable speed motor drives (PWM signals), motor inrush current and measurement across current shunts. The isolated input is made via two 4mm/banana safety sockets. The BNC output allows easy connection to an oscilloscope. The DP probes can be powered from a 9V battery or external power supply.

Product

Memory Tester

SP3000

-

CST Inc.

SP3000 - CST Inc.

CST is proud to offer a portable stand alone and affordable memory tester, combining DIMM and SODIMM testing capability all on the same universal base unit with optional easy plug-on test adapters.

Product

H/L Voltage Clamp Meters

-

MEWOI Electronics Co.,ltd

MEWOI Electronics Co.,ltd

High Voltage Current Transformation Ratio Tester breaks traditional structure, specially designed for high and low voltage first and secondary loop current, variable ratio, and current leakage test; apply the latest CT technology and mask digital integration technology, composed of special high-voltage clamp, low voltage clamp, host, high voltage insulation rod and monitoring software, etc; its wireless transmission test data can penetrate multiple building obstacles with a straight-line distance of 30 meters.

Product

Multifunction Tester

COMBI521

-

HT Italia Srl

COMBI521 - HT Italia Srl

COMBI521 carries out tests on electric systems in compliance with IEC/EN 61557-1 and therefore measurements of continuity of the protection cable, insulation resistance (with calculation of PI and DAR), overall earth resistance, RCDs type B, A and AC tripping time and current, line / fault impedance with calculation of prospective short circuit / fault current, phase sequence and conformity.

Product

Mechanical Testers

-

Actron

Actron

Actron’s wide variety of mechanical testers includes specialty tools, compression testers, vacuum pressure gauges and advanced timing lights. All mechanical testers work effectively on most foreign and domestic vehicles, small engines, motorcycles and other recreational vehicles to save you time on inspections and repairs.