Product

Transformer Winding Resistance Testers / TRT ? 2

TRT-2

-

UDEYRAJ ELECTRICALS PRIVATE LIMITED

TRT-2 - UDEYRAJ ELECTRICALS PRIVATE LIMITED

Fast measurement: Test current 0.02A to 2A DC, Digital display of resistance and test current.

Product

Standard Serial Page EEPROM

-

STMicroelectronics

STMicroelectronics

Serial Page EEPROM is a high-density, page-erasable SPI EEPROM memory that combines flexibility, performance, and ultra-low power. The Serial Page EEPROM with proprietary NVM cell technology delivers fast erase/write performance with high cycling endurance and robust retention. The new architecture allows fast wake up and byte flexibility, as well as block management and fast quad output, while keeping current surge and energy budget at very low levels.

Product

DIGITAL DC RESISTANCE METER

VE2516BU

-

Vasavi Electronics

VE2516BU - Vasavi Electronics

Micro Processor based DC Resistance Meter with PASS / FAIL indication.

Product

Electrical Resistance Probes

-

Metal Samples Company

Metal Samples Company

Electrical resistance (ER) corrosion probes are commonly used in petroleum, chemical processing, and other environments where on-line corrosion rate readings are required. Whereas test coupons must be removed from the process for evaluation, corrosion probes can allow corrosion rate determination without probe removal.

Product

Resistive AC Load Bank

-

Junxy Energy

Junxy Energy

AC load bank testing offers you whole solutions of predictive failure analysis for UPS(uninterrupted power supply), generator, transformers, PV system, inverter etc, to validate the condition and output of such power systems comprehensively. Integrated AC & DC load bank could be made in one unit or separately with different load voltages as per your need for different applications.

Product

1μΩ-4kΩ AC Milliohmmeter Low Resistance Tester

TH2521

-

Shenzhen Chuangxin Instruments Co., Ltd.

TH2521 - Shenzhen Chuangxin Instruments Co., Ltd.

TH2521 AC Milliohmmeter is a high-performance and intelligent tester widely used to test contact resistance, internal resistance and battery voltage. The application of constant current source with 1kHz frequency can greatly eliminate the potential error caused by thermoelectricity on DUT. This meter has the function to automatically detect contact failures on test cable. At the range of 30mΩ, basic R resolution can reach 1μΩ. It is applicable for transformer, inductance coil copper resistance, relay contact resistance, switch, connector contact resistance, wire resistance, PCB line and via reistance dan metal defect detection, etc. In the mean time, signals, such as HIGH, LOW, PASS, can be output through HANDLER interface, thus it is very convenient to be used in automatic production line.

Product

Battery Resistance Tester

FBR-6100NT

-

Fuzhou Fuguang Electronics Co., Ltd.

FBR-6100NT - Fuzhou Fuguang Electronics Co., Ltd.

FBR-6100NT Battery Resistance Tester is a new generation handheld battery tester of FUGUANG™, which can quickly,intuitively and conveniently judge the deterioration of batteries (lead-acid batteries, lithium iron phosphate batteries and nickel-cadmium batteries, etc.). It has the characteristics of high accuracy, repeat consistency and anti-interference. It is an ideal tool for rapid battery daily check.

Product

Circuit Breaker Contact Resistance Meters

-

Vanguard Instruments Company, Inc.

Vanguard Instruments Company, Inc.

The Vanguard Auto-Ohm 10 is a 10-ampere battery powered micro-ohmmeter designed for low-resistance-measuring applications such as the measurement of resistance in circuit breaker contacts, bushing contact joints, and welding joints. The unit is powered by four 3400mAh, 3.7Vdc Li-Ion rechargeable batteries. With these high capacity batteries, up to 2,900 tests per charge (10A/2 second duration) can be performed in the field.

Product

Automatic Dielectric Constant Tan Delta And Resistivity

-

Sivananda Electronics

Sivananda Electronics

No Balancing and Calculation required to calculate Volume / Surface Resistivityand Dielectric Constant.Complies IEC 60250, IS 4487, Test jig Conform to ASTMD 257Built in Thermal PrinterSerial port RS232 for data downloading.Can be used to check liquid sample with Three Terminal oil cell.Storage 100 Test reports

Product

Earth Resistance Tester

M71

-

HT Italia Srl

M71 - HT Italia Srl

M71 has been developed to measure earth resistance with 2 wires and 3 wires by voltammetric method in compliance with standard IEC/EN61557-1.

Product

The Gold Standard for Breast Screening & Biopsy Training

Mammography QA Solutions

-

Sun Nuclear Corp.

Mammography QA Solutions - Sun Nuclear Corp.

When the USA mandated Mammography QA requirements via the Mammography Quality Standards Act (MQSA), medical physicists, the ACR and the FDA worked with Gammex to complete the phantom design known today as the 156 Phantom.

Product

High Resistance Neutral Grounding Devices

-

Hilkar

Hilkar

HRG systems limit the fault current by placing high resistance between neutral point of transformer (or generator) and ground. As it is not possible to locate the fault point in delta connected systems, an artificial neutral point is created and delta connected system can be grounded. This allows a fault current of a few amperes thus locating the fault point gets easy. When the neutral point is grounded thru high resistance, both continuity of operation is provided during fault condition and sufficient current (typically between 2 A and 10 A) flow is provided for ease of locating the fault point.

Product

Programmable Insulation Resistance Tester

2679

-

Shenzhen Chuangxin Instruments Co., Ltd.

2679 - Shenzhen Chuangxin Instruments Co., Ltd.

Programmable insulation resistance tester Feature Resistance test range: 2512: (1µΩ—2MΩ nine shift) Variable speed test:5times/slow,10times/fast. Test accuracy:0.02%±2digits。

Product

Ground Resistance Testers

-

AEMC Instruments

AEMC Instruments

Whether you are doing a simplified 2-Point, a more complete 3- or 4-Point Fall-of-Potential test, a soil resistivity test or a touch potential test, AEMC has the right instrument for you. Our revolutionary clamp-on ground resistance tester will save you both time and money. Whichever AEMC ground tester you choose, you can count on it to be the highest quality, the most complete package and the simplest to learn to use.

Product

Earth Resistance Tester

G-TEST

-

Cirprotec, S.L.

G-TEST - Cirprotec, S.L.

To check the condition of a grounding connection, an earthresistance tester is used to measure the residual ground voltage,resistance and resistivity (Wenner method).

Product

Insulation Resistance Testers

-

Uni-Trend Group Limited

Uni-Trend Group Limited

Are designed to help prevent hazards such as electric shock and short-circuits caused when the insulation in electrical devices, parts, and equipment used in industrial plants, buildings, and other settings degrades over long periods of use.

Product

Standard IR Target Projectors

-

Santa Barbara Infrared, Inc.

Santa Barbara Infrared, Inc.

Santa Barbara Infrared’s 14000Zi Series reflective infrared target projectors are turnkey test systems for electro-optical (E-O) testing of FLIRs and other infrared (IR) imaging systems. The standard target projectors are assembled from SBIR’s STC Series Collimators, Infinity Blackbodies and 300 Series Target Wheels. SBIR also offers a standard athermal target projector with a 5.7° field of view (FOV).

Product

Inductance Standard

1482 Series

-

IET Labs

1482 Series - IET Labs

The GenRad 1482 Standard Inductors are the standard of choice in metrology labs. Used today by national metrology institutes and primary standards bodies around the world, these inductors have no peer or equivlent.