Product

3D Solder Paste Inspection Machine (3D-SPI)

3Si Series

-

Saki Corporation

3Si Series - Saki Corporation

Saki's 3D SPI identifies critical defects and assists with process improvement.

Product

Replacement 30" Matched Cable Set for Use with Dx10 HiTemp Solder Tip Leadset

Dx20-Cable-HiTemp

-

Teledyne LeCroy

Dx20-Cable-HiTemp - Teledyne LeCroy

Replacement 30" matched cable set for use with Dx20 HiTemp Solder tip leadset

Product

9-Pin D-Type Female, Solder Bucket, HV

40-960-009-F-HV

-

Pickering Interfaces Inc.

40-960-009-F-HV - Pickering Interfaces Inc.

9-Pin Female D-Type Connector, High Voltage, Solder Bucket - With Backshell

Product

SparkFun Solder-able Breadboard

Large

-

SparkFun Electronics

Large - SparkFun Electronics

This is the Large SparkFun Solder-able Breadboard. A bare PCB that is the exact size as our full-size breadboard with the same connections to pins and power rails. This board is especially useful for preserving a prototype or experiment you just created on a solderless breadboard by soldering all the pieces in place.

Product

Acoustic Wave Device

-

Murata Manufacturing Co., Ltd

Murata Manufacturing Co., Ltd

Murata offers high-performance acoustic wave radio frequency (RF) devices including filters, duplexers, diplexers, resonators, and frequency control devices. This allows us to provide a wide range of acoustic wave-based RF devices in a one-stop service to all RF engineers.

Product

Single Photon Detector System For Near-Infrared (1.3 - 1.6 Um Wavelength) Waves With Liquid Helium (LHe) Cryostat

-

Insight Product Company

Insight Product Company

Insight Product Company is proud to offer Single Photon Detector System for Near-Infrared (1.3-1.6 um wavelength) with Liquid Helium (LHe) Cryostat. Insight Product Co. offers superconducting single photon detectors and ultra-low noise registration systems for the near infrared range. All systems operate in continuous mode, no gating required.

Product

Standard DIP Socket with Solder Tail Bifurcated Contacts

Series 511

-

Aries

Series 511 - Aries

Standard DIP Sockets with Wire Wrap Bifurcated Contacts. Features: Standard DIP sockets are available with solder tail or wire wrap pins, all with bifurcated contacts. Consult Data Sheet No. 12005 for wire wrap pins. Aries offers these standard DIP sockets in more sizes than any other manufacturer.

Product

Pure Sine Wave Inverter

1210

-

TESCO

1210 - TESCO

TESCO’s Pure Sine Wave Inverter (Catalog No. 1210) converts 12V battery power into pure sine wave AC household power, allowing you to run loads up to 1000 watts. With its state of the art, easy to use design, the inverter will offer you reliable service for providing AC power and 5V USB power from your service truck or van.

Product

Wave display utility

GUI

-

Test Insight Ltd.

GUI - Test Insight Ltd.

GUI allowing users to view and analyze test vectors in all common formats (VCD/EVCD/WGL/STIL).

Product

Guided Wave Radar Sensors

LVRD10 Series

-

Omega Engineering, Inc

LVRD10 Series - Omega Engineering, Inc

The LVRD10 Series guided wave radar transmitters provide continuous level measurement with a 4 to 20 mA signal output. Offered in single rod, coaxial, or weight & cable probes in 3 or 6 foot lengths

Product

Reflow Soldering Machines

-

Shenzhen Leadsmt Technology Co.,Ltd

Shenzhen Leadsmt Technology Co.,Ltd

Used to attach surface-mount components to printed circuit boards (PCBs). It involves applying solder paste to specific locations on a PCB, placing the components on the paste, and then heating the assembly in a reflow oven.

Product

68-Pin SCSI Micro-D Female Solder Bucket

40-962-068-SB-F

-

Pickering Interfaces Inc.

40-962-068-SB-F - Pickering Interfaces Inc.

This connector is designed to allow users to directly terminate with soldered connections to the 68-Pin SCSI Style Micro D connector. Pickering Interfaces recommends the use of purchased cable assemblies for applications where most or all of the contacts are in use.

Product

04 With Soldering Eyelets | 1 Wafer | 24 Positions

04-1xx3-00/30-xx

-

ELMA Electronic, Inc.

04-1xx3-00/30-xx - ELMA Electronic, Inc.

Very robust, multi wafer selector with 15° detent angle, switching torque up to 20 Ncm and a rotational life up to 25'000 cycles

Product

01 With Soldering Eyelets | 12 Positions | M6

01-1xxx-00/30xx-12-M

-

ELMA Electronic, Inc.

01-1xxx-00/30xx-12-M - ELMA Electronic, Inc.

Multi wafer compact selector with 30° detent angle, 3 mm shaft diameter, 25'000 switching cycles and with up to 6 Ncm switching torque

Product

Solder Paste

MVP Versa (3D SPI)

-

Machine Vision Products

MVP Versa (3D SPI) - Machine Vision Products

The first part of any SMT process is Paste. MVPs Versa and 900 Series platforms provide high accuracy paste inspection. High accuracy paste measurements are made using a choice of 10um or 5um 3D measurement systems.

Product

01 With Soldering Eyelets | 12 Positions | M8

01-1xxx-00/30xx-12-0

-

ELMA Electronic, Inc.

01-1xxx-00/30xx-12-0 - ELMA Electronic, Inc.

Multi wafer compact selector with 30° detent angle, 4 mm shaft diameter, 25'000 switching cycles and with up to 6 Ncm switching torque

Product

Single Photon Detector System For Near-Infrared (1.6-2.3 Um Wavelength) Waves With Liquid Helium (LHe) Cryostat

-

Insight Product Company

Insight Product Company

Insight Product Company is proud to offer Single Photon Detector System for Near-Infrared (1.6-2.3 um wavelength) with Liquid Helium (LHe) Cryostat. Insight Product Co. offers superconducting single photon detectors and ultra-low noise registration systems for the near infrared range. All systems operate in continuous mode, no gating required.

Product

Millimeter Wave Continuously Variable Waveguide Attenuators

-

Fairview Microwave Inc.

Fairview Microwave Inc.

Our millimeter wave variable waveguide attenuators allow designers and engineers to test their systems at various signal strengths and attenuation values to determine the optimum signal performance of the system. The key feature of these waveguide attenuators is that the attenuation level is adjusted using a built-in micrometer which enables repeatable and rapid re-setting to different attenuation levels without the need for additional external components. Our waveguide attenuators handle varying attenuation levels from 0 to 30 dB over the specified band allowing the designer to tune the attenuation level needed for the application. These continuously variable waveguide attenuators cover a broad frequency range of 33 to 110 GHz in five bands and also display flat performance across a wide band with low insertion loss.

Product

01 With Soldering Eyelets | 6 Positions | M6

01-1xxx-00/30xx-6-M

-

ELMA Electronic, Inc.

01-1xxx-00/30xx-6-M - ELMA Electronic, Inc.

Multi wafer compact selector with 60° detent angle, 3 mm shaft diameter, 25'000 switching cycles and with up to 6 Ncm switching torque

Product

Point on Wave Synchronous Test Sequencer

-

Crest Test Systems Pvt. Ltd.

Crest Test Systems Pvt. Ltd.

The Portable Point on Wave Synchronous Test Sequencer is India’s only system that helps in time synchronizing the control signals during short circuit tests performed on medium and high voltage switchgear and control gear.

Product

3D Inline Solder Paste Inspection System

TROI 7700 SERIES

-

Pemtron Co., Ltd

TROI 7700 SERIES - Pemtron Co., Ltd

Using Moire' pattern, Pemtron's three-dimensional lead applicationdosage tester combines 2D color images with 3D measurement data toprovide more detailed, near-real PCB images, unlike traditionalcolor maps. We will also provide you with the best solution forhigh-quality and high-precision PCB production with a varietyof statistical programs, along with information you need toquickly and accurately judge positive/failure.

Product

Solderability Tester

LBT210

-

Microtronic Microelectronic Vertriebs GmbH

LBT210 - Microtronic Microelectronic Vertriebs GmbH

Microtronic's LBT-210 solderability tester has software that offers statistical information such as mean value, standard deviation, etc. A camera option offers video of the test cycle and storage in memory with the appropriate test measurements and data. Additionally, it has the feature to test under nitrogen. This function can be switched on in the software. An enclosure that is flooded with nitrogen lowers and rises with the device under test.