Abaco Systems Inc
With more than 30 years of experience, Abaco Systems is the global leader in open architecture rugged embedded systems. We deliver market-leading commercial off-the-shelf and custom products, together with best in class program lifecycle management. This, together with our 800+ professionals’ unwavering focus on our customers’ success, reduces program cost and risk, allows technology insertion with affordable readiness and enables platforms to successfully reach deployment sooner and with a lower total cost of ownership. With an active presence in hundreds of national asset platforms on land, sea and in the air, Abaco Systems is trusted where it matters most.
- 1-866-652-2226
- 8800 Redstone Gateway
SW, Ste 200
Huntsville, AL 35808
United States of America
-
Product
Mezzanine System
5158
System
The 5158 Electrical Conversion Module (ECM) provides eight (8) RS-232 outputs and eight (8) RS-232 inputs. Built around Maxim 1488 & 1489 chips for true RS232 levels and voltage tolerance, all outputs come up in the 1, mark or idle state. Electrically this is a negative output voltage, the start bit is always a 0 or a positive voltage level.
-
Product
OpenVPX SBC
SBC328 3U
OpenVPX
The enhanced support the VPXcel3 SBC328 single board computer provides enables customers to implement advanced security capabilities such as anti-tamper and information assurance. This support includes an inherently secure FPGA solution, and support for Intel’s Trusted Execution Technology.
-
Product
PCI Edge Connector Card
PMC239/F
-
The PMC239/F also comes with a fan. The fan can be disconnected from its power if not needed.
-
Product
Carrier Card
VIPC627-ET
-
VIPC627-ET is a 6U VME carrier card with four IP slots and extended temperature range. Two 50-pin, 0.1 inch flat ribbon cable connectors mounted in the front panel provide access to all IP I/O lines. Also, all I/O lines of 'IP D' are routed to VME P2 and 14 user selectable I/O lines of 'IP C' can be routed to VME P2 via a jumper field.
-
Product
PCIe FPGA Card
PC821
-
The PC821 is a high-performance, PCI Express card with advanced DSP capabilities and multiple I/O options.It supports one VITA 57.4-compliant FMC+ and one VITA 57.1 compliant HPC FMC site. Both FMC sites are closely coupled to the Virtex or Kintex UltraScale FPGA and a DDR4-2133 SDRAM SO-DIMM.
-
Product
Target Tracking/Image Processing
-
Our automatic video trackers and image processors are at the heart of a wide range of commercial, military and paramilitary systems where they provide the highest performance solutions in the smallest, fully environmentally proven hardware packages.
-
Product
Digital I/O Board
3512
Digital I/O Module
The 3512 is an eight channel non-isolated digital I/O board with +5V tolerant 74LCX14 inputs with hysteresis and +3.3V CMOS 74LVTH125 driven outputs. Each I/O line features a series 10 ohm damping and protection resistor and a 4.7K pull up resistor to +3.3V. On power up the outputs are tri-stated, and can then be enabled on a bit by bit basis. Output high drive is 32mA @ 2.0V minimum. Output low drive is 32mA @ 0.8V maximum.
-
Product
FPGA Board
VP889
FPGA Board
The VP889 is a high-performance FPGA processing board featuring Xilinx® Virtex Ultrascale+™ and Zynq® Ultrascale+™ technology.
-
Product
FPGA Mezzanine Card
FMC172
-
The Abaco FMC172 wideband low latency FMC module is based on the latest high performance ADC device from Texas Instruments and DAC devices from Teledyne-E2V. It is the fastest ADC Abaco offers with LVDS interfaces, delivering up to 6.4 GSPS ADC on a single channel (or two channels @ 3.2 GSPS) and a single channel DAC at up to 6.0 GSPS, making it among the fastest low-latency devices available on the market. The combination of the FMC172's >6.0 GHz bandwidth, its high sample rate and low latency is ideal for advanced Digital RF Memory (DRFM) systems.
-
Product
NETernity
PMC942RC
-
The NETernity™ PMC942RC is a fully integrated 8-port 10/100/1000BaseT Ethernet switch designed to support the low-cost requirements of unmanaged switch applications and converging networks. Seven of the ports are external; the eighth port appears as a NIC (Network Interface) to the host SBC to which the PMC is attached.
-
Product
NETernity Ethernet Switch
RM984RC
-
The RM984RC delivers full wire-speed 10/100BaseTX Ethernet Layer-2 switching on all ports. It is available in three models including air-cooled commercial temperature; air-cooled industrial temperature, and conduction-cooled.
-
Product
VME Bus Repeater
VME-5532L
-
Easily link your VMEbus systems via fiber-optic cable, with total electrical isolation, no EMI generation and high-noise immunity.
-
Product
Wideband Digital Down Converter
-
A Digital Down Converter performs channel access functions in digital receivers. It is used for extracting a channel (frequency band) of interest in a wideband signal. Abaco Systems' wideband DDC core employs a quad DDC architecture to achieve ultra high performances. The core accepts up to 16-bit complex data and can process 1GSPS continuously. With a fully programmable architecture at all stages of the processing, this core combines flexibility and speed and can be used in combination with our dual-channel 1GSPS ADC module.
-
Product
RCONAF-EC
Multifunction Cable
A 6”cable transitions from the card edge connector on the RAF-EC-2P (champ 36) to one male HD-15 connector and two shielded RJ-45 connectors.
-
Product
FPGA Systems
-
Leverage our development platforms and rugged FPGA based systems that provide a rapid migration path from the lab to the field - without having to re-architect an entire system.
Parent
-
AMETEK Inc.
AMETEK is a global leader in electronic instruments and electromechanical devices. AMETEK consists of two operating groups: Electronic Instruments - a leader in the design and manufacture of advanced instruments for the aerospace, power, process and industrial markets. Electromechanical - a differentiated supplier of electrical interconnects, precision motion control solutions, specialty metals, thermal management systems, and floor care and specialty motors.
Siblings
-
Ametek Compliance Test Solutions
AMETEK-CTS is a global leader in EMC compliance testing and RF power amplifiers. AMETEK has been designing and manufacturing precision instruments for more than 50 years. Under the brand names of EM TEST, Teseq, IFI and Milmega the company produce a wide range of specialist solutions aligned to the individual needs of equipment manufacturers across a variety of industries.
Siblings
-
MOCON, Inc.
AMETEK MOCON is the global leader in the design, development, manufacture, and support of gas measurement and control instruments and services
Siblings
-
AMETEK Measurement & Calibration Technologies Division
Measurement & Calibration Technologies provides calibration instruments for temperature, pressure and process control. It also is a leader in level measurement devices, continuous position sensors, hardness testers, force measurement devices and retractable cord reels. In addition, it offers a line of weathering test instrumentation along with laboratory and outdoor testing services.
Siblings
-
Ametek Materials Analysis Division
The AMETEK Materials Analysis Division´s goal is to be the recognized market leading provider of world-class analytical systems, nuclear instrumentation and digital imaging solutions.
Siblings
-
Process & Analytical Instruments division of AMETEK
Process & Analytical Instruments is a leader in analyzers, monitors and other instruments used by oil, gas, chemical/petrochemical, pharmaceutical, semiconductor, factory automation and other process industries. In addition, it offers a wide range of oil field and laboratory testing instruments, infrared temperature measurement devices, subsea and ultra-deep water fluid and flow measurement equipment, and specialized sampling, extraction, transport and conditioning systems.
Siblings
-
Ultra Precision Technologies Division of Ametek
Ultra Precision Technologies is a leader in the development of ultra precise measurement devices and precision machining systems. It also is a leader in ophthalmic instruments and eye care diagnostic devices, optical lens manufacturing equipment, vibration cancellation systems and enclosures, and advanced scanners used in reverse engineering, quality assurance and 3D printing.
Siblings
-
AMETEK Programmable Power, Inc.
Located in San Diego, CA, AMETEK Programmable Power designs, manufactures, and markets precision, AC and DC programmable power supplies, electronic loads, application specific power subsystems, and compliance test solutions for customers requiring and valuing differentiated power products and services. Also part of our business is VTI Instruments, which delivers precision modular instrumentation and systems for electronic signal distribution, acquisition, and monitoring, used in the world's most demanding test applications.
Siblings
-
Ametek Power Instruments
AMETEK Power Instruments serves the world-wide electric power generation and distribution industries with our advanced instruments and monitoring systems. We offer an extensive sales and service network around the globe including the US, UK and Asia. We can provide fault recorders, power line carriers, high accuracy revenue meters, alarm management and much more for your power generation, transmission and distribution needs. Our engineers have decades of design experience and work with each client to meet their stringent requirements. AMETEK Power Instruments has over 50 years of experience partnering with leading Fortune 500 companies.
Siblings
-
AMETEK Thermal Process Management
Thermal Process Management (TPM) is a Business Unit in the Process Analytical and Instrumentation Division of AMETEK. TPM is comprised of 5 companies with unique and distinguished product solutions, leading share in their respective market space, and operating with considerable market synergies. TPM manufactures industry leading thermal management systems, winterization solutions for instrumentation, and process extraction, transport, and conditioning systems.
Siblings
-
Barben Analytical
AMETEK® Barben Analytical is a market-leading supplier of analytical measurement solutions for the process industries. We design, manufacture, and sell a broad range of industrially hardened instruments, including pH and ORP electrochemical sensors, as well as gas and liquid phase optical oxygen analyzers.
Siblings
-
Ametek Spectro Scientific
Spectro Scientific, an ISO 9001:2008 company, specializes in analytical tools and software for machine condition monitoring. The company is one of the largest suppliers of oil and fuel analysis instruments to industry and the military worldwide. Industry clients include petrochemical, mining, marine and power generation companies as well as commercial testing laboratories. Spectro Scientific’s extensive product offerings include spectrometers for wear metal analysis, lubricant degradation and contamination analyzers, particle analysis instruments and complete turnkey systems for oil or fuel analysis laboratories, all managed by its SpectroTrack software platform.
Siblings
-
Haydon Kerk Pittman
Haydon, Kerk and Pittman are three world class AMETEK brands that supply advanced linear and rotary motion solutions to a diverse mix of global customers. We are recognized as a leading manufacturer of brushed and brushless DC motors, stepper motor based linear actuators, precision Acme lead screw and anti-backlash nut assemblies, linear rail and guide systems, gearmotors, drives and complete custom automation sub-systems.
Siblings
-
NSI-MI Technologies
NSI-MI Technologies is the leading global supplier of antenna, RF, and microwave testing equipment. With a team of highly respected technical experts, we are committed to providing top-notch engineering solutions and advanced products for a wide range of industries that require precise measurement, motion control, and data acquisition.
Siblings
-
United Electronic Industries, Inc.
Produces data acquisition hardware, signal conditioning and support software as needed in today's sophisticated, demanding test environments...
Siblings
-
RTDS Technologies
Being the first of its kind, the RTDS® Simulator is the world’s benchmark for performing real time power system simulation. With satisfied customers in 42 countries across the globe and over 1400 units in operation, RTDS Technologies is the undisputed world leader in our craft. We introduced the world’s very first fully digital real time power system simulator in 1989. RTDS Technologies continues to lead the way with our world-class, in-house research and development department. Our company is committed to innovation. We are continually developing our hardware, software, and support services in response to the needs of our customers.
