-
Product
Data Communications
-
Renesas' MIL-STD-883-compliant CMOS Manchester Encoder-Decoder (MED) is a high-speed, low power device manufactured using self-aligned silicon gate technology. The device is intended for use in serial data communication, and can be operated in either of two modes, a converter mode or repeater mode. This device is qualified to QML Class Q military standards.
-
Product
3U CompactPCI® RS-232/422/485 Serial Communication Card
MIC-3955
-
The MIC-3955 is a low power 4-port or 8-port RS232/RS422/RS485 serial board with 3U CPCI form factor and is based on the EXAR PCI controller. MIC-3955 is PICMG 2.0 Rev. 3.0 compatible. Rear board module are named MIC-3527XX. The MIC-3955 supports front IO or rear IO with 4-port and 8-port, and every channel is independent.
-
Product
Serial Communications Card
104-ICOM-2S
-
The Model 104-ICOM-2S Serial Communications Card can be installed in a PC/104 stack and provide effective communication on long lines in noisy environments. Data lines are opto-isolated from the computer and from each other to assure communication even when large common mode voltages and noise are imposed.
-
Product
Data Communications
-
Renesas has receivers, line drivers and encoder-decoders for data communications applications, as well as products that cover ARINC and Manchester specifications.
-
Product
CANBus Communication
PISO-CAN400U-T
-
The CAN (Controller Area Network) is a serial communication protocol, and efficiently supports distributed real-time control with a very high level of security. It is an especially suit for networking "intelligent" devices as well as sensors and actuators within a system or sub-system. In CAN networks, there is no addressing of subscribers or stations in the conventional sense, but instead prioritized messages are transmitted. As standalone CAN controller, PISO-CAN400/CAN200 can represents an economic solution of an active CAN board. It has two or four independent CAN bus communication ports with 5-pin screw terminal connector or 9-pin D-sub connector, and has the ability to cover a wide range of CAN applications. Besides, PISO-CAN400/CAN200 uses the new CAN controller Phillips SJA1000T and transceiver 82C250/251, which provide bus arbitration, error detection with auto correction and re-transmission function. It can be installed in a 5V PCI slot and supported truly “Plug & play”.
-
Product
USB Data Communications Multiplexers
-
These USB multiplexers are ideal for the testing of multiple devices that use USB interfaces, allowing the test system to select one target device from many. The design is bi-directional to permit use as a multiplexer or de-multiplexer with no impact on performance and uses long lifetime electro-mechanical relays characterized for use in data communications systems.
-
Product
Communication Boards
-
The communication boards are designed for high-performance connection of field devices in harsh environments.
-
Product
HF Communication Equipment
MS 2000
-
The Meltronics HF/SSB system provides a reliable voice communication over 2 to 29.99MHz frequency range and is designed to meet the most diverse requirements. The HF system is used to establish communication between Air to Ground station, Air to Air and Air to Ship. This System is suitable for Aircraft, Helicopter and Ships communication applications. The HF transceiver has beyond line of sight communications providing both voice and data services. Systems is a digital, Microprocessor controlled, synthesized unit that utilizes DSP technology to increase performance and versatility.
-
Product
Advanced Platform Communications System
APCOS 4000
-
AEROMARITIME’s proven Advanced Platform Communications System APCOS® 4000 is designed to meet today’s and tomorrow’s requirements for tactical and strategic digital communications networks.
-
Product
LabVIEW Communications Application Frameworks
-
The Application Frameworks are software reference designs that provide a rich set of high performance FPGA IP for prototyping real-time wireless communication systems. When combined with NI’s line of software defined radios, the Application Frameworks form a complete hardware and software prototyping platform that enables researchers to accelerate their prototyping efforts and achieve results quickly.
-
Product
Inertial Navigation Systems
-
Safran Federal Systems is now one of the only companies with a full complement of PNT technologies with the addition of proven inertial navigation solutions.Hemispherical Resonator Gyro (HRG) Crystal™ technology leverages state of the art manufacturing and offers revolutionary performance and reliability over existing technologies, for tactical to strategic applications across all domains. With more than 30,000 HRGs produced and over 15 million operational hours, the technology is proven and tested in military applications worldwide.
-
Product
Mobile Communications DC Sources (45 W, 100 W):
663xx Series
-
Use this family of specialized DC power sources to test your digital wireless appliances. All models offer DC sourcing, current sinking, fast transient response, GPIB, and measurement capabilities to help you with the unique challenges of simulating batteries and battery packs and measuring the current drawn by your device under test.
-
Product
High Accuracy Fibre Optic Inertial Navigation System
SATURN INS
-
SATURN INS, from Teledyne TSS, is a world leading surface navigation system which offers enhanced unparalleled INS performance which builds on the TSS fibre optic gyro system by adding inertial navigation (INS) capability.As with SATURN, it is available in three standard heading accuracy variants; 0.1° sec lat (SATURN10INS), 0.3° sec lat (SATURN30INS) and 0.5° sec lat (SATURN50INS).
-
Product
Internal Communications Platform
Messenger
-
Using Messenger from Trilogy, you can build a cost effective intercom solution without the installation, operational and future expansion constraints of more traditional 2 and 4 wire systems. From the factory configured Base System, Messenger evolves to suit the emerging communication needs of your organisation.
-
Product
Malware Communication Analyzer
Malcom
-
Malcom is a tool designed to analyze a system's network communication using graphical representations of network traffic, and cross-reference them with known malware sources. This comes handy when analyzing how certain malware species try to communicate with the outside world. detect central command and control (C&C) servers. understand peer-to-peer networks. observe DNS fast-flux infrastructures. quickly determine if a network artifact is 'known-bad'.
-
Product
Communication Test Software for MODBUS RTU
ComTest Pro
-
ComTest Pro Communication Test Software for MODBUS RTU Devices via Serial and Ethernet. This complementary program allows users to test and troubleshoot MODBUS RTU communication by sending single or multiple read or write commands to the device. The software offers comprehensive data-logging, data-formatting and error checking features.
-
Product
SWaP Optimized Processing and Multifunction I/O & Communications System
NIU3A
-
The NIU3A is a small, rugged, low-power, self-contained processing and multifunction I/O system preconfigured with 24-CH programmable Discrete I/O, 8-CH ARINC 429/575, 4-CH CANBus and 2-CH MIL-STD-1553 functions. The NIU3A can also be configured with up to three smart Configurable Open Systems Architecture™ (COSA®) function modules. The NIU3A boasts Dual or Quad Core ARM Cortex®-A53 processors for customer software applications and I/O and communications management. The NIU3A is configured with two 10/100/1000BASE-T (GbE) Ethernet ports and an RS-232 port for maintenance / diagnostic or configuration interface. Ideally suited for rugged Mil-Aero applications, the NIU3A delivers off-the-shelf solutions that accelerate deployment of SWaP-optimized systems in air, land and sea applications.
-
Product
Critical Communications
-
The mission of Public Safety Communications is to meet the mission-critical communications requirements of First Responders. Morcom recognizes the extensive range of capabilities that this entails.
-
Product
Miniature Multi Communication UV-NIR Spectrometer
VS70-MC
-
VS70-MC (Multi Communication) is a high performance compact fiber coupled spectrometer system covering wide spectral range of 200 to 910 nm.This OEM optical module is built around HORIBA’s type-IV Aberration-Corrected Flat-Field Holographic Ion-Etched concave grating and is specially designed to easily adapt to a large variety of detectors and electronic drivers. This system is fitted with an integrated order-sorting filter to eliminate higher orders.
-
Product
Land True-Inertial Navigation
Geonyx™
-
Geonyx™ family is designed for three main applications:- Navigation- Target geolocation- Artillery pointing Capable of operating under extreme conditions and in a full GNSS denied environments, Geonyx™ is highly reliable.- Pointing accuracy < 0.5 mils thanks to HRG Crystal™ technology- Quick & flexible alignment in GNSS denied environment- The most compact, robust & reliable on the market and hard-mounted
-
Product
Radio Communications
-
General Dynamics Global Imaging Technologies
Every day around the globe, General Dynamics'' radios ensure planes land safely, isolated personnel are found, soldiers communicate securely and first responders have the communications they need to go where no one else can. Our radios are more than tools, they are lifelines. Building on a strong, 50-year legacy in RF communications and networking development for military, government and commercial customers, General Dynamics’ radio products and systems are trusted globally in air traffic control, Blue Force Tracking, search and rescue, line of sight communications, satellite and wireless, and battlefield communications applications.
-
Product
Power Line Communication (PLC) Module For Single Board Computer
MIOe-PLC
-
Dual QCA7006 for EVSE / Charging Station sideEthernet Host Interface, SPI OptionalExtended Operating Temperature -40~85° C
-
Product
Universal PCI, Eight or Four-port RS-232/422/485 Serial Communication Card
LPCI-COM Series
-
The LPCI-COM Series are eight or four-port asynchronous serial communication cards designed for use in PCI bus computers. The cards support RS-232, RS-422, and/or RS-485 communications which can be selected on a port by port basis.
-
Product
Communication Data Logger
LE-270AR
-
LE-270AR is an Analyzer and Communication Data Logger of CAN/LIN. It has logger mode with which you can records CAN/LIN communication logs in the SD/SDHC card for long hours and remote mode with which you can monitor data at real time by connecting the analyzer with PC. It also has simulation mode with which you can repeatedly transmit CAN/LIN data which is registered in advance and selected on the PC. You can measure 2 channels of CAN/LIN communication lines and can simultaneously register voltage data of 4 external signals.Its power failure protection, waterproof, and low power consumption widens the usage of analyzer such as in the automation factories and other production factories.
-
Product
Wireless Communication Sensor Platform
-
Delivering on both form and function, the wireless communication sensor product platform includes a battery-powered wireless sensor endpoint for easy installation, a sensor and communication board for easy integration, and a development kit for application specific customization.
-
Product
Communication Converter
F485
-
The F485 is a self-contained device for converting between RS232, RS485 and fiber optic signals. The F485 is electrically isolated to improve communications in noisy environments. The converter uses internal switches to select the signal conversion type and communication rates up to 57600 bps. The F485 converter uses the data on the serial ports to determine direction and therefore requires no hardware handshaking signals from the computer.
-
Product
Data Communication Solution
BACnet/IP
-
BACnet is a data communication protocol mainly used in the building automation and HVAC industry (Heating Ventilation and Air-Conditioning).
-
Product
Optical Communication Analysis
-
In lab and manufacturing environments, R&D engineers require scalable and optimized test solutions to enable them to properly characterize new advanced modulation scheme signals for next-generation, ultra-high-speed telecom networks. Through EXFO’s optical communication analyzers, R&D engineers and manufacturing operations involved in the development or production of transmitters or systems based on new high-speed technology will find the right tools for their advanced technology needs.
-
Product
LTE Cat4+GNSS, Full-Size Mini-PCIe Form Factor, USB Communication Interface
AIW-344
-
Main Chipset Qualcomm MDM9X072 LTE Antenna Coaxial Connectors +1 GPS antenna connectorLTE FDD:150Mbps DL/50Mbps UL (Cat 4)LTE TDD:130Mbps DL/30.5Mbps UL (Cat 4)Operation: Normal: -30°C ~ +75°C/Extended: -40°C ~ +85°CAIW-344FQ-E02 LTE/HSPA+/GPRS module, with GPS, for EU, for TW, for Australia, for BrazilAIW-344FQ-N01 LTE/HSPA+/GPRF module, with GPS, for USAIW-344FQ-J01 LTE/HSPA+/GPRF module, with GPS, for JP
-
Product
Satellite Communications Modems
satTRAC
-
satTRAC Modems provide RF conversion and modem processing for TT&C and Payload links with support for all commonly used frequencies and waveforms.
