VME Chassis
-
Product
16-Channel VME Analog Output/Thermocouple Simulator Module
V470
-
The V470 is a 6U VME module that provides sixteen independent, isolated analog outputs that may be user-programmed to operate as voltage outputs or thermocouple simulators. Users may write temperature or voltage values at VMEbus speed, and the microprocessor will transparently do all necessary calculations and update the channel electronics.
-
Product
ULI-211E - Heavy Industrial RS-232/422/485 (Terminal Block) To Multimode Fiber (ST Connector). Panel Mount Metal Chassis
BB-FOSTCDRI-PH-MT
-
Converts serial data signals to multi- or single-mode fiber2 KV, 3-way isolation (input, output, power circuits)Data rate: 9.6 to 115.2 kbps (bit-wise enable)-40 to +85°C wide operating temperatureIP30 metal panel mount case (DIN rail adaptable)FCC, CE, IEC-61850-3, IEEE 1613, UL C1/D2Note: 2 units required to extend data via fiber optic connection (see datasheet)10-48 VDC power source required (not included, sold separately)
-
Product
VME J2 12 slot
101VMEJ212-0900
-
VME J2 backplane 12 slot, compliant with ANSI/VITA 1-1994. The A+C rows are bussed in all slots. Also, row B has onboard, inboard termination.
-
Product
6-slot ShoeBox Chassis
AX60501
-
*Desktop or wallmount industrial computer chassis*One 5.25" and two 3.5" HDD drive bays*Equipped with a PS/2 type power supply
-
Product
Mini Media Converter Chassis
1 RU 19"
-
The Media Converter chassis is capable of housing up to 12 mini media converters. You can start with a single media converter, and grow to 12 Media Converters
-
Product
VME Display And Bus Analyzer Module
VM-DBA
-
VM-DBA is a new test and diagnostic module for VME-bus systems which visualizes activities on all VME bus lines on the set of front-panel LEDs, but also allows one to digitize individual waveforms of all these lines into 2kBit -long storage memories, for a subsequent readout via VME or USB interfaces.
-
Product
6 Channel 6 kV/300 µA VME HV Power Supply
V6521
-
The V6521 is a 1-unit wide VME 6U module housing 6 High Voltage Power Supply Channels 6kV, 300µA. The board is available with either positive or negative output polarity; mixed version with 3 positive and 3 negative channels is also available. The channels share a common floating return, which allows on-detector grounding reducing the noise level. HV outputs are delivered through SHV connectors.
-
Product
6-Channel VME Buffered Electrical-to-Optical Converter
V720
-
The V720 is a six-channel logic-level electrical-to-optical converter, packaged as a single-width, 6U VME module. It may be used with compatible Highland optical receiver modules for fast, low-jitter, EMI-proof distribution of pulses, triggers, and precision timing signals.
-
Product
6-Channel VME Optical-to-Electrical Converter
V730
-
The V730 is a six-channel logic-level optical-to-electrical converter, packaged as a single-width, 6U VME module. When used with compatible Highland optical transmitter modules, the V730 provides fast, low-jitter, EMI-proof distribution of pulses, triggers, and precision timing signals.
-
Product
MIL-STD-1553 & ARINC XMC Interface For SBCs, VPX, VME, CPCI/PXI Systems
XMC-MA4
-
The XMC-MA4’s BC capability includes variable message/label framing/subframing with transmission scheduling provides the most advanced control operations. ARINC TX has complete frequency control per channel. RT and ARINC RX, Monitor, Playback and Signal Generator functions also include industry leading functions to meet the most demanding requirements.
-
Product
Mounting Flange Kit, Chassis, Agilent M9018A
310113589
-
Mounting Flange Kit, Chassis, Agilent M9018A.
-
Product
13-slot VXI Chassis
-
The 13-slot VXI crate is designed for use in modular measurement information systems based on the VXI version of the standard. The 13-slot VXI crate is designed to accommodate the system module, in the first slot, and VXI instrumental modules placed in the remaining slots, to provide their power supply, as well as to provide information interconnection via the VXIbus bus between the modules and with the control computer. The chassis meets the requirements of GOST R 51884-2002 and the document System Specification VXI-1 Revision 1.4.
-
Product
Mounting Flange Kit, G20/G20X, f/ NI PXI-1095 and PXIe-1084 Chassis
310113760
-
Mounting Flange Kit, G20/G20X Slide Mount, 6.75" Series Adapters, for NI PXI-1095 Chassis and NI PXIe-1084 Chassis
-
Product
VME Extender
VME64J2
-
VECTOR Electronics and Technology, Inc.
Excellent performance with a multi layer design
-
Product
1U Chassis
-
The 1U chassis support multiple configurations include SATA hard drives, rackmount chassis and redundant power supply that fulfill server-grade IPC standard. The 1U chassis series with the cooling fans design to deliver non-stop operation.
-
Product
VME SBC
XVR19 6U
-
The XVR19 provides straightforward, cost-effective and low risk upgrades for users of previous XVR products, bringing enhanced processor performance, enhanced storage and improved protection against obsolescence. They will also be attractive for new programs looking to benefit from Abaco’s established and proven VME roadmaps.
-
Product
VME Form Factor Extender, 6U, 120mm
111FFE6012-012X
-
The VME form factor extender 6U 120 mm allows to adapt boards for use in the same VMEbus system. It maintain the correct depth dimensions and allow the front panel to be aligned.
-
Product
12-Channel VME Picosecond Resolution Time-Interval Measurement Module
V660
-
The V660 is a 12-channel time-to-digital converter used to record the time of occurrence of twelve independent electrical pulse inputs, each independently timestamped and buffered in FIFO memory.
-
Product
VME Bus Tester
VBT100
-
The VBT100 has been designed to withstand and measure excessive voltages on both signal and power supply pins. This capability allows it to operate in faulty backplanes that could damage other boards. The tester also detects, measures and identifies which signals have excessive voltages so they can be repaired before boards are loaded into a backplane.
-
Product
6-slot Chassis
CH-06 AXIe-0
-
The 6-slot chassis in AXIe-0 format is intended for use in modular measurement information systems based on the AXIe standard.
-
Product
VME Generic Carrier Card For Conduction Cooled PMC(PCIbus Mezzanine Card) Modules
AVC-2-CC
-
VME64x (6U) generic carrier card for conduction cooled PMC (PCIbus mezzanine card) with 2 PMC slots. Modular solution combines any AIM conduction cooled PMC module for ARINC429, MIL-STD-1553 or any conduction cooled 3rd party PMC module.
-
Product
3U Storage Chassis For ATX/μATX Serverboard With 16 Hot-Swap Drive Bays For Enterprise Storage.
HPC-8316
-
3U rackmount chassis supports ATX/μATX motherboard16-bay hot-swappable 3.5"/2.5" SAS 12Gb/s drives or SATA 6Gb/s drivesSupports 2 hot-swappable 2.5" drive bays at the rearSupports 80Plus redundant power supply
-
Product
6U VME 1/10/40 Gigabit Ethernet Switch
ComEth4000e
-
The ComEth4000e is a cutting-edge 1 slot & 2 slot options. 6U VME Layer 2/3 Ethernet switch compatible with VME 64x systems. Each configuration can also be built with or without a P0 connector.
-
Product
Mounting Block Kit, Instrument Bracket, Use with Various Test Chassis
310113542
-
Instrument brackets come with pre-drilled holes that can be used to mount different instrument chassis (from multiple vendors) to the bracket. In order to use these mounting holes with Pickering Chassis, this mounting block kit must be used.
-
Product
16-Channel VME AC Power Analysis Module
V180
-
The V180 is a single-width VME module that allows accurate and comprehensive measurement of AC power circuits. The V180 acquires powerline current and voltage inputs using approved current transformers and model C750 remote potential transducers.
-
Product
OpenVPX Chassis Platforms
-
With options for VITA 46/VITA 48 compliant specifications for VPX (with VITA 65 OpenVPX compliant backplanes), Pixus offers complete systems with power supply unit and backplane, fully assembled, pre-wired and tested. With a modular design approach, Pixus can offer virtually unlimited VPX chassis configurations for 3U and 6U boards. The VPX enclosures come in 1U-4U horizontal-mount (for 6U boards), 4U-5U vertical-mount (for 3U cards), and 7U, 9U, and higher chassis (for 6U OpenVPX boards).
-
Product
SOSA Aligned Family Of Chassis Managers, VITA 46.11
79-V46-CHMC-x-CHMC-CMx-S1
-
Designed to align with SOSA™, Elma’s VPX Chassis Manager assures the proper operation of the chassis and boards in defense embedded computing platforms. It monitors the health of the chassis, reports anomalies and takes actions when needed.
-
Product
2 Slot 1U CompactPCI 19" Rackmount Development Platform; Type 39 19" Rackmount Chassis
39C02AD118Y3HCBX
-
The Type 39C, 1U is an advanced generation of CompactPCI chassis for PICMG 2.0, 2.16, 2.17, and EXP.0 applications. IEEE 1101.10/11, 6U x 160mm CPCI cards from the front and 6U x 80mm I/O cards from the rear.
-
Product
VME Test Extender 9U/220mm J1/J2/J0
111EXT9122-0120
-
The VME extender boards are designed to bring a circuit card completely out of a card cage so that it can be tested or debugged on both sides of the test board. Each signal, power, and ground line can be individually isolated with the DIP switches.
-
Product
64-Channel VME Relay Module
V210
-
The V210 is a single-wide, 6U VME module that includes 64 SPDT relays and drivers. User-settable DIP switches set the A16/A24 VME address mode, VME address, and select whether the relays are statically operated or operate in latching mode, where relay states are sustained when VME crate power is off.
