Humidity
-
Product
FM Tokenless Transmitter & Receiver
MS 1522
-
Transmitter and Receiver units are designed to work at 24V DC voltage (nominal) with variation between 19.2 V to 28.8V. The system is designed to work with carrier frequency 1800/2700 Hz and modulated frequency 65Hz/85Hz. For 1800Hz Carrier Frequency RED border is used in Front Panel and for 2700Hz Carrier Frequency BLUE border is used in Front Panel. Maximum power consumed by transmitter and receiver are 1.2W and 8W, respectively. Sense level for receiver is less than –19 dBm and No sense level for receiver is more than –22 dBm with 1mw (0 dBm) transmitter power. The equipment is designed to work satisfactorily with temperature variation from 0°C to 55°C with relative humidity of 95% at 35°C. Suitable test points are provided in the back of the equipment to monitor the necessary parameters.
-
Product
Extremely Accelerated Stress Test Chambers
-
The extremely accelerated stress environment is defined by high temperature, high humidity and high pressure. WEIBER provides humidity resistance evaluation test for electronics components through customized Extremely Accelerated Stress Test Chamber. This chamber provides high performance test in minimal amount of time according to international IEC 60068-2-66 standard. This chamber also known as Accelerated Stress Test Chamber, Halt and Hass Test Chamber, Halt Test Chamber and Hass Test Chamber.This chamber reduces the time taken for humidity testing in electronic components. 2 types of tests saturated and unsaturated extremely accelerated stress test can be performed. In saturated test the temperature is maintained at 1210C at 100%RH, and for unsaturated temperature of 110, 120, 1300C is maintained at 85%RH. Normally for electronic components unsaturated type test is done.
-
Product
Chamber Controller Software
-
EDC (Embedded Device Control) is specifically designed software for Sentek chamber system controllers running Temperature and Humidity environmental tests. The EDC software features an intuitive interface, a powerful data review function and live data viewing.
-
Product
Environmental Chamber
-
Wewon Environmental Chambers Co, Ltd.
The environmental chamber for conditioning of samples prior to testing, It also can be used for a variety of materials of high – low temperature alternating test. The test for temperature, humidity, time can be programmed. Provides conditions of temperature from -70 degree to +180 degree and of humidity form 10% to 98%.environmental chamber ● The ideal simulation environmental chamber for all heat and cold testing between -70 ºC and 180 ºC temperature range.● Well suited for reliability testing based on current test standard in the temperature range of -70 °C to 180 °C & 10% to 98% RH.● This design SUS environmental chamber meet all requirements for extreme testing and low temperature alternating climate profiles from -70 °C -180 °C with humidity
-
Product
Solar Spectrum Test Chambers
-
Thermoregulation system Solar simulation chamber made of a metallic frame and insulation cover panels The test chamber can be easily opened with one hand The height of the sample carrier can also be varied to ensure optimal irradiation of the various samples Corrosion resistant Stainless steel construction Air-cooled refrigeration unit Micro-processor monitoring and control unit Aerosol-free humidification and dehumidification Psychrometric humidity measuring system
-
Product
Dew Point Logger Sensor
NUL-245
-
This sensor measures temperature and humidity in a volume and gives the temperature below which the water vapor in that volume of air (at a constant barometric pressure) condenses into liquid water (the dew point).
-
Product
Wood Moisture Meters
-
PeakTech Prüf- und Messtechnik GmbH
High quality wood and material moisture meter, which is characterized by its ease of use and universal applicability. The device has an LCD display, in which measured values of humidity and ambient temperature are displayed. In addition, it is equipped with an LED display, which enables a quick good-bad assessment of the measured values. When burning wood in a wood-burning stove with a high moisture content, the efficiency of the stove decreases, while at the same time the emission of pollutants, such as soot and fine dust, increases. In addition, there is a build-up of soot in the chimney, which can lead to a fire. Therefore, this device is ideal for wood storage, control during the heating season or use in construction.
-
Product
Wireless IoT Sigfox Transmitter
-
Wireless IoT transducers / transmitters for temperature, humidity, binary input, atmospheric pressure.
-
Product
Handheld Meters
-
Omega carries a wide variety of handheld meters including anemometers, temperature and humidity meters, clamp meters, vibration meters, gauss meters, hardness meters and many more.
-
Product
LoRaWAN® Enabled Temperature And Humidity Sensor
EVA-2310
-
LoRaWAN® wireless connectivity-20 °C to 55 °C temperature detection range0%RH to 90%RH humidity detection rangeBattery life up till 5 years@25 °C, 15 mins interval settingEasy to deploy and maintain
-
Product
Thermal Management
-
Get efficient and reliable heat management and humidity control solutions geared to your specific size, location and business goals.
-
Product
Compressed Air Temperature and Humidity Regulator
H3061P-4
-
Relative humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
Product
Temperature/ Relative Humidity
-
Specialized data loggers and sensors from Onset that accurately monitor and record indoor/outdoor environmental conditions.
-
Product
Dataloggers
-
High Accurancy Measuremetn up to 1%RH. Light weight, pocket-sized design. Take accurate measurement for humidity, temperature, wet bulb and dew point.
-
Product
Salt Spray Chambers
-
Dongguan Amade Instruments Technology Co., Ltd
Salt spray chamber is intended to use method of salt-spray corrosion to evaluate the performance of corrosion resistance of specimens to salt fog under the specified conditions. It is capable of simulating a locally salt mist environment in which the test piece is placed. There are different types of salt fog chambers including microprocessor digital version, touch-screen control version and compound version featuring temperature&humidity control and adjustment. widely applied to components and parts, electronics elements, metal materials etc.
-
Product
Air Temperature and Relative Humidity Sensors
-
Air temperature and relative humidity probes typically consist of two separate sensors packaged in the same housing. Often relative humidity is measured with a capacitive RH sensor, while air temperature is measured by a PRT.
-
Product
Software
GüVü
-
For efficient field deployments, GüVü allows you to check the integrity of your installation instantaneously. GüVü displays waveforms, orientation, temperature and humidity data without instrument disturbance.
-
Product
Capacitance Sensors
Accumeasure Series
-
The Accumeasure product line features capacitive sensor products for high resolution gap and displacement measurements that require a high level of accuracy that is both stable and repeatable. A capacitive sensing system consists of a probe and amplifier. Capacitive measurements can be performed in a multitude of environments using non-contact passive capacitance probes that are not affected by magnet fields, temperature, humidity, nuclear radiation, and pressure. This is largely due to the nature of the rugged and passive capacitance probes.
-
Product
Compressed Air RH+T+Tdp Sensor
T3111P-2
-
Relative humidity, temperature sensors at probe on the cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
Product
Jumbo Display
-
These are large size Jumbo Display specifically for distant visibility. Useful for indoor as well as outdoor applications for parameter indication, clock indication, temperature and humidity indication etc.
-
Product
Ultrasonic Sensors
-
Contrinex ultrasonic sensors provide reliable, non-contact detection of solid,liquid, granular or powdered materials in air, tolerating precipitation, humidity, dust and fumes. Target materials may be colored, transparent, polished or matt; detection is practically independent of the target’s direction of travel.
-
Product
Handheld SF6 Leak Detector
JHLK-1
-
Xiamen Jiahua Electrical Technology Co.,Ltd
JHLK-1 uses pumping method and intelligent digital sensor to measure SF6 concentration. It has high sensitivity and good repeatability. Insert type MCU control contributes to the reliable performance. Excellent interface features with complete function and easy operation. Clear 128*64 LCD, small and good design shape are convenient for handheld. Built-in high accuracy digital temperature and humidity sensors make it as an optional temperature and humidity measurement device.
-
Product
Environmental Testing Equipment
-
It is to do adaptability and properties test for materials under different environment conditions, which includes salt spray test to determine corrosion resistance and temperature and humidity chamber to do a variety of high-low temperature alternating test.
-
Product
Wireless Moisture Monitors Data Loggers
-
Lignomat’s monitoring systems can measure:*wood moisture, bamboo, gypsum, sheetrock, solid materials*relative humidity and temperature, DPT, GPP, EMC*EMC*concrete moisture using in-situ RH probes ASTM F 2170*Surface and interior temperature https://www.lignomatusa.com/wp-content/uploads/2015/02/wireless-moisture-data-logger.jpg
-
Product
Outdoor Nodes
-
The upgraded Outdoor Nodes have been developed by the NITLab team and support MIMO operation. The new version of the Outdoor Nodes are equipped with 802.11a/b/g and 802.11a/b/g/n wireless interfaces. They also feature 2-core Intel cpus, new generation solid state drives and usb web cameras. Last but not least, each node is equipped with light, temperature and humidity sensors.
-
Product
Environmental Chambers
-
Sanwood Environmental Chambers Co ., Ltd.
Sanwood climatic chambers for battery can be tested under controlled temperature and humidity conditions, similar to the conditions under which batteries operate during their lifetime.
-
Product
Environmental Chamber
REXMED REC-280
-
MOD. REC-280, AC 230/380/415V, 1/3 phase, Environmental chamber, HS CODE: 841989, UNCCS CODE: 484384, UMDNS CODE: 16327, Main construction: SS304, Interior: SS304, Exterior: SS304 powder coated, Insulation: Rigid polyurethane foam and glass wool, Controller: Fix point PID controller, temperature ˚C/PV and ˚C/SV, humidity %/PV and %/SV display and setting, Temperature range: -20˚C~100˚C, Humidity range: 20%RH~98%RH, Constancy: ±0.3˚C ±2.5%RH, Uniformity: ±1˚C ±3%RH, Temperature and humidity sensor: PT 100Ω, Temperature and humidity audio and visual warning and OFFS correction setting, Temperature heater: 2.3KW X 2pcs, Humidity heater: 4.5KW X 1pc, Heat up transition time: -20˚C~100˚C within 35 min, Refrigeration system: Air cooled, single stage, Cooling compressor: Bristol hermetic compressor, Cooling capacity: 3,140 Watts, 10,700 BTU/hr, 2,702 Kcal/hr, Cool down transition time: 20˚C~-20˚C within 45 min, Safety devices: No fuse breaker, refrigerator over load relay, refrigeration high pressure switch, over temperature protector, protection relay, protection fuse, water level control and overheat protector, Chamber: L100 X W80 X H100cm, Capacity: 800L, chamber with key lock, with lamp (DC 12V 50W) X 1pcs and double glass viewing window, testing cable port with cover: Ø25mm, 4 castors, W/S: shelf X 2pcs, standard testing wet cloth X 5pcs, PCV water container X 1pc
-
Product
All-in-One Meteo Compact Station
HDMCS-100
-
A ready to use and easy to set up Automatic Weather Station. The AWS measures wind speed, wind direction, humidity, dew point, temperature, barometric pressure and rainfall.
-
Product
SS Body Pressure Switch (longbody, NEMA 4)
P117LG
-
The P117LG NEMA 4 Stainless Steel Pressure Switches are the weather-proof, liquid-resistant version of the P117G. The NEMA 4 rating makes these rugged switches suitable for outside applications or in areas of condensing humidity. Unlike the P117G, the P117LG set point is factory set to customer specification and is non-adjustable.
-
Product
Weathering Test Services
-
Atlas Material Testing Solutions
The climates of southern Florida and central Arizona are recognized as global benchmarks for natural weathering environments. The warm, humid, subtropical environment of our outdoor test sites in Miami and the intense sun and arid climate of our site in Phoenix are some of the harshest climates to which your products can be exposed. Often the best natural weathering test scenario requires testing in a variety of climates. For that reason, Atlas offers the world’s largest network of outdoor weathering test facilities with more than 20 sites worldwide.
