-
Product
Aerospace Testing Solutions
-
Aerospace Testing SolutionsDewesoft offers a variety of solutions for aerospace testing. From standard data recording, structural dynamics, rotating machinery analysis, acoustic testing, to more specific applications like ground station telemetry solutions with full support for ARINC-429 and MIL-STD-1553 buses, PCM telemetry, IRIG 106 - Chapter 10, Ethernet packets, and iNet telemetry.We can provide flexible and robust data acquisition hardware and software that will match your requirement for testing airplanes, helicopters, rockets, satellites in the air, space, or on the ground - proving ground, wind tunnel, vibration shaker or acoustic chamber. Our solutions are being used and trusted by leading aerospace companies on the most demanding projects like NASA, ESA, Space X, Airbus, Boeing, Lockheed Martin, Bombardier, Honeywell to name just a few.
-
Product
Convergence
-
Many network topologies provide resiliency to protect network services. This typically means re-routing traffic away from a faulty line section. However frame loss will occur if a connection is re-routed. When traffic with a given transmitted frame rate is sent through the connection during re-routing, packet loss can be measured and the convergence time can be calculated. Valkyrie can be used to measure convergence, while Chimera is used to emulate latency and jitter.
-
Product
Serial-to-Daq Card
Model 2307
-
* 2307 Board provides 32 digital I/O lines, 4 analog outputs, 6 analog inputs, 6 relay driver outputs and 4 temperature inputs.* Firmware supports ASCII command strings, Addressed commands for RS-485 networks and packet protocol. * Operates as a RS-232 as a RS-485 to Data Acquisition Board. * DE-9 connector has both RS-232 and RS-485 signals.* SCPI commands and IEEE 488.2 compatibility provide GPIB like operation over the serial link. * Runs on 5 Vdc power.
-
Product
Low Power RF Transceivers
-
Analog Devices provides a wide range of low power RF transceivers covering sub-GHz and 2.4 GHz frequency bands. Drawing on over 40 years of experience designing high performance RF ICs, the ADF7xxx family of transceivers delivers industry-leading RF performance combined with ultralow power consumption. Our latest transceivers incorporate configurable packet handling capability for proprietary and industry standard protocols to address emerging Internet of Things requirements. As faster time to market grows in importance, evaluation platforms such as the latest ADF7xxxMB4Z will be critical to kickstarting software development.
-
Product
SpaceWire-USB Brick Mk3
326
-
The SpaceWire Brick Mk3 is a USB 3.0 (also works with USB 2.0 and USB 1.1) to SpaceWire interface device that is suitable for use in all stages of SpaceWire equipment development: initial SpaceWire evaluation, instrument simulation, control system simulation, unit testing, integration support, and EGSE. The SpaceWire Brick Mk3 provides two SpaceWire interfaces, support for high speed data transfer, the capability to inject various types of errors on demand, the ability to transmit and receive time-codes and act as a time-code master, and comes complete with highly optimised host software for low latency transmission of SpaceWire packets directly to and from the host PC.
-
Product
Duty Cycle Meter
-
Displays ON or OFF period as a percentage of total period over a programmed gate time from 10 ms to 199.99 s. A resolution of 1%, 0.1% or 0.01% is user-selectable. Applications include monitoring modulated proportional control systems and pulse-modulated systems, such as radar, lasers or packet radio.
-
Product
cPSB 2.16 4 slot - 3 w/cPCI, 1 FS
107PS11604-0157R
-
CompactPCI CPSB 2.16 6U 4 slot, 3 w/cPCI, 1 Fabric, fully compliant to the PICMG 2.16 Packet Switching Backplane specification.
-
Product
Network Traffic Generator
LANforge FIRE
-
LANforge FIRE generates network traffic at various speeds with the ability to monitor packets for throughput and correctness. LANforge FIRE sits on the edge of your network and tests your network core. Useful for testing any network, and especially cost effective for efforts requiring many data-generating ports, such as DSL, Cable-Modem, and Satellite modems.
-
Product
Interface
RCNIC-A2PA
Interface
The RCNIC platform is a high performance PMC module for the AFDX/ARINC 664 protocol. With two independent ports for traffic monitoring, traffic generation, external triggering and analysis, the RCNIC provides high-resolution time-tagging of incoming packets simultaneously with highly accurate traffic generation.
-
Product
6U cPCI 1/10/40 GbE Switch
ComEth4050e
-
The ComEth 4050e is a cutting-edge 6U cPCI Layer 2/3 Ethernet switch for PICMG 2.16 & VITA 31.1 systems and is powered by the newest Marvell highly integrated system-on-chip (SoC) with programmable packet processors.
-
Product
2U Rackmount Network Appliance Platform With Dual LGA2011 Socket Intel® Xeon® E5-2600 V3/v4 Family Processors, Intel® C612 And Up To 42 LAN
NA850
-
The NA850 offers cutting edge performance for networking applications with dual high performance 12-core Intel® Xeon® E5-2600 V3 series processors and Intel® C612 chipset, 16 high bandwidth DDR4 memory slots and two hot swappable 3.5” SATA HDD bays. For greater flexible and easy maintenance, the NA850 can be fitted with up to five Ethernet modules, supporting up to 42 Gigabit LAN ports or 20 10GbE LAN ports. Two PCIe x16 standard expansion slots are available for optional network security cards. The superior network appliance platform also supports the Intel® Data Plane Development Kit (Intel® DPDK), a set of software libraries that can improve packet processing performance by up to ten times. It could achieve over 80 Mbps on a single Intel Xeon processor and double with a dual-processor configuration. With its friendly design and high capacity, this powerful network appliance is suited for IDS/IPS, VPN, content filtering, UTM, network security applications, and cloud computing solutions.
-
Product
Mixed function mezzanine side card for CPCI-S CPU boards
SCX-PCIE
-
The SCX-PCIE is a mezzanine side card for EKF CPU boards, equipped with a PCIe® Gen3 packet switch, onboard NVMe and SATA mass storage, and high-speed front I/O.
-
Product
Sync Test
Paragon neo-S
-
Capture and decode PTP packets for analysis and Time Error testing. PTP clock emulation, plus the Paragon neo-S’ conformance test applications, removes uncertainty and maximizes test repeatability – essential for validating new, high-accuracy 5G network devices.
-
Product
ALL-OUTDOOR RADIO SYSTEM
FreeMile 5 GE
-
SAF FreeMile 5 GE MIMO all-outdoor system is a Licence-free 5 GHz gigabit radio for Ethernet packet data transmission. Making use of ground breaking 2x2 MIMO technology, the SAF FreeMile 5 GE MIMO delivers up to 210Mbps (105Mbps full-duplex) of real throughput combined with a high packets-per-second performance.
-
Product
8 Port PCI Express
PEX 8608
-
The ExpressLane™ PEX 8608 device offers 8 PCI Express Gen 2 (5.0 GT/s) lanes, capable of configuring up to 8 flexible ports. The switch conforms to the PCI Express Base Specification, rev 2.0. The PEX 8608 architecture supports packet cut-thru with the industry's lowest latency of 140ns (x4 to x1) and offers two virtual channels for traffic prioritization in the system.
-
Product
Blackfin Embedded Processors
-
Blackfin® 16-/32-bit embedded processors offer software flexibility and scalability for convergent applications: multiformat audio, video, voice and image processing, multimode baseband and packet processing, control processing, and real-time security.
-
Product
Network Emulator Software
NetDisturb
-
NetDisturb allows disturbing flows over IP networks helping to study the behavior of applications, devices or services in a “disturbed” network environment. NetDisturb is inserted between two Ethernet segments acting as a bridge and operates bi-directional packet transfer on Ethernet, Fast Ethernet and Gigabit network interface cards.
-
Product
Fast and Flexible WLAN Measurements up to 802.11ax
WLAN Test Toolkit
test
The WLAN Test Toolkit gives you direct and fine control over the generation and analysis of IEEE 802.11a/b/g/n/ac and ax signals, as well as 802.11j/p/ah/af waveforms, with industry-leading speed and accuracy. It empowers you to characterize, validate, and test a variety of WLAN connectivity products, such as RF front end components, wireless modules, and user devices.The toolkit includes extensive support for the latest features of the 802.11ax standard, including extended single-user packets, multiuser OFDMA, and multiuser multiple input, multiple output (MIMO) functionality with per-user configuration and measurement results. The WLAN Test Toolkit helps you solve demanding new access point test cases by generating signals that simulate multiuser environments, including per-user impairments. You can also use the new software to generate trigger frames to test the real-time response of client devices and make power precorrection and relative center frequency measurements.
-
Product
PROVA-X
-
10G Ethernet/IP Test Appliance. The PROVA-X is a packet-based test appliance for communications service providers, network equipment manufacturers and data centers. This appliance can be used to test and analyze the behaviour and performance of an Ethernet/IP network or device. Synthetic traffic generation, packet capture, emulation, impairment and performance assessment tool.
-
Product
DVB-T SFN Adapter
MIPDVB
-
MIPDVB for HDc is ENENSYS’ SFN adapter module for DVB-T that inserts synchronization data to enable Single Frequency Network broadcasting.Running at the head-end after DVB multiplexer, the MIPDVB runs in the HDc chassis to embed up to 6x MIPDVB modules in 1U so that the same chassis can output up to 6 TS with MIP packets over ASI or IP.
-
Product
Advanced Aggregators
-
Aggregators are devices designed to increase efficiency and port utilization of network packet brokers. They are commonly used at the network edge or in TOR applications where port utilization tends to be low. Aggregators are also capable of pre-filtering traffic prior to sending out to Network Packet Broker’s for advanced filtering or taking the place of packet brokers in applications where only L2-L4 filtering is required. Aggregators improve ROI by reducing the total cost of a network visibility fabric and increasing the efficiency of existing infrastructure.
-
Product
HTTP Sniffer
-
EffeTech HTTP Sniffer is a HTTP packet sniffer, protocol analyzer and file reassembly software based on windows platform. Unlike most other sniffers, it is dedicated to capture IP packets containing HTTP protocol, rebuild the HTTP sessions, and reassemble files sent through HTTP protocol. Its smart real-time analyzer enables on-the-fly content viewing while capture, analyze, parse and decode HTTP protocol.
-
Product
Packet Analysis Probe for PCI Express
N4220A/B
-
When purchased with a logic analyzer, the application software you order is installed on the instrument hard drive. If you need to add application support after your initial logic analyzer purchase or are controlling a logic analyzer from a host PC, you must install the appropriate software before you can make measurements.
-
Product
Gigabit Ethernet Tester Module for 1G and 10G Packet
GAO-ENET-103
-
GAOTek Gigabit Ethernet Tester Module for 1G and 10G Packet is designed for installation and maintenance of Metro/Carrier Ethernet and IP services. It supplies a compact test solution for 1G and 10G packet Ethernet, including ITU-T Y.1564 standard for SLA and OAM test features.
-
Product
8-port LAN Module With Intel® 82580EB Ethernet Controller
AX93316
-
Axiomtek's AX93316 LAN module is built with an Intel® 82580EB GbE Ethernet controller to optimize data traffic processing, employing advanced techniques including the Intel® DPDK, I/OAT, Jumbo Frames and VMDq, not only enabling network appliances to speed up their data traffic but also enhancing their packet processing capabilities for higher throughput of data.
-
Product
cPSB 2.16 8 Slot - 7 w/cPCI, 1 FS
107PS11608-0157R
-
CompactPCI CPSB 2.16 6U 8 slot, 7 w/cPCI, 1 Fabric, fully compliant to the PICMG 2.16 Packet Switching Backplane specification.
-
Product
Interface
RCNIC-A2PAX
Interface
The RCNIC platform is a high performance, PCI module (PMC on carrier card) for the AFDX / ARINC 664 protocol. With two independent ports for traffic monitoring, traffic generation, external triggering and analysis, the RCNIC provides high-resolution time-tagging of incoming packets simultaneously with highly accurate traffic generation.
-
Product
Passive Fiber Network TAPs
-
Passive network test access points (TAPs) are a hardware tool that allows you to monitor your network. Garland Technology offers fiber network TAPs in network speeds of 1Gb, 10Gb, 40Gb and 100Gb. Fiber Network TAPs are passive, purpose-built hardware devices that make a 100% copy of your networks data - without affecting network traffic. Passive network TAPs let your monitoring tools to see every bit, byte and packet®.
-
Product
Evolved Packet Core Commander
-
A Subscription based solution for vEPC test automation. The rapid evolution of mobile networking technology is changing MNOs and NEMs requirements for EPC test automation solutions. The new solutions have to be flexible, scalable, quickly and easily deployable in a cloud, and most importantly, affordable.
-
Product
Ethernet
-
The M4K-ETH is an intelligent Gigabit Ethernet interface module for the multiprotocol Excalibur 4000 family of carrier boards (only 64 bit versions). The module supports 10Mhz, 100Mhz and 1Ghz Full Duplex UDP/IP Ethernet.The receive channels allow for the storage of all packets to all MAC and IP addresses with status and Time Tag information appended to each packet. The receivers allow for filtering based on MAC address, IP address and UDP port. The transmit channels enable the user to define a Bus list which controls timing and order of packets without host intervention or immediate mode which enables the host to transmit packets at will.
