Optical Transceivers
convert, transmit and recieve electrical and optical signals.
See Also: Transceivers, Vector Signal Transceivers, Optical Receivers
-
Product
PXI Optical FPGA Board
PXIe-8324-DSP
-
The Conduant PXIe-8324-DSP FPGA board provides a user programmable hardware platform that is able to sustain full-duplex high-bandwidth transfers through its 8-lane Gen3 PXI Express (PXIe) interface and its two 12-lane HSS interfaces while performing complex calculations.
-
Product
47~2600MHz Digital TV & Satellite TV PIN Optical Receiver
HRS-26D/P
-
Hangzhou Huatai Optic Tech. Co., Ltd.
Huatai HRS-26D/P optical receiver, adopting high-sensitivity PIN detector, receiving sensitivity is -22dBm, typical value -13dBm. It can receive analogue and digital signal with the frequency of 47~2600MHz on a single fiber, and compatible with any FTTx PON to achieve triple-network combination between Analog TV(<10CH), Digital TV (DVB-C, DVB-T), Satellite TV (DVB-S) and Internet & FTTH.
-
Product
High Throughput Optical Streak Camera
AXIS-NV
-
AXIS-NV is used for time-resolved spectroscopy of subnanosecond eventsin the visible and IR range.
-
Product
CATV Fiber Optic Receiver
MX862R
-
The MX862R is a Fiber Optics Receiver used to convert a fiber optic connection to RF (coax output).
-
Product
Optical Spectrum Analyzer
S6362D
-
Saluki S6362D is a high-resolution, large-dynamic, high-speed, high-performance optical spectrum analyzer. It is perfect for testing 600 nm to 1700 nm optical systems, such as DWDM and optical amplifiers. It can also be used for optical active and passive device testing, such as LED, FP-LD, DFB-LD, optical transceivers and optical fibers and fiber gratings and other optical devices.
-
Product
Dual 2x2 Insert/Bypass F Optic FC/PC Mul
40-820-122-M
Fiber Optic Switch
Pickering PXI Fiber Optic Multiplexers connect a single channel to one of two or four channels. They are available in single or dual multiplexer configurations supporting single-mode or multi-mode fiber. A wide choice of connectors types is available. The 40-810 multiplexer connects the optical channel by redirecting the optical signal into a selected output fiber.
-
Product
Optic Node With Amplifier
OX 755
-
Converts even weak Optic Signals to a high quality RF Signal. LED BAR Optic Level Display has been provided for ease of system maintenance. They are best suitable for Analog as well as Digital transmission to maintain BER, MER Characteristics.- High Quality Nodes cum Amplifier- Frequency 40 ~ 1000 MHz- Good Sensitivity of -11 dBm- RF O/P 110 dBµV at 0 dBm Optic I/P- High Voltage Surge Protection- LED Optic Level Display- Powder Coated Housing
-
Product
*Optical Power Meters for Telecom
-
If you’re involved in any kind of photonic measurements in Telecom applications, you already know that it can be challenging. The measurements need to account for things like –*Wide dynamic range – powers from pW up to several W*For free space beams – possibly widely diverging beams*For fiber transport - losses as the beam enters and emerges from a fiber
-
Product
PXI/PXIe MEMS Optical MUX, 4-Channel, Multi-Mode, 62.5/125 Fiber
40-850A-314-M62.5-HI
Multiplexer Module
The 40/42-850A-314-M62.5-HI is a PXI/PXIe 4-channel multiplexer with MU (mini SC) connectors, includes hardware interlock and is part of Pickering's range of PXI Fiber Optic MEMS Switching modules. They are available in many high density formats with a choice of different connector styles to suit most applications: FC/APC (for optimal performance), FC/PC and SC/PC for general applications and LC and MU for high density applications.
-
Product
AFM Optical Platform
OmegaScope
-
The OmegaScope is a state-of-the-art turn-key solution that combines Optics and ultra-resolution multi-range research AFM. The OmegaScope AFM is an advanced research instrument that provides path for researchers in spectroscopy and photonics. It is available in reflection configurations providing direct top and side optical access. The flexibility of the OmegaScope platform offer almost endless possibilities in correlation of high spatial resolution spectroscopies (Raman, Photoluminescence, Fluorescence) and AFM imaging modes.
-
Product
7 Tesla Optical Cryostat
OptiCool®
-
The OptiCool by Quantum Design is a new optical cryostat using an innovative design that puts the sample volume in the heart of your optical environment. A custom 3.8 inch bore, split-coil, conical magnet offers fields perpendicular to the optical table up to ±7 tesla. The highly integrated design means, even with a magnet, your sample isn’t buried inside a large cryostat, far away from the optics. Seven side optical ports and one top optical port allow for optical access to your sample from a wide array of directions.
-
Product
LXI Dual 8:1 Optic MUX FC/APC Loop-Thru
60-850-022
Multiplexer Module
The 60-850 and 60-851 are LXI conformant fiber optic multiplexers that use MEMS switching technology to ensure fast and reliable switching of single-mode (60-850) or multi-mode (60-851) optical signals being carried on fiber connections. The 60-850/851 is available with a variety of connector options and in a variety of multiplexer arrangements. Loop-thru versions are also available for easy multiplexer expansion.
-
Product
PXI/PXIe MEMS Optical MUX, 4-Channel, Multi-Mode, 62.5/125 Fiber
40-850A-214-M62.5-HI
Multiplexer Module
The 40/42-850A-214-M62.5-HI is a PXI/PXIe 4-channel multiplexer with SC/PC connectors, includes hardware interlock and is part of Pickering's range of PXI Fiber Optic MEMS Switching modules. They are available in many high density formats with a choice of different connector styles to suit most applications: FC/APC (for optimal performance), FC/PC and SC/PC for general applications and LC and MU for high density applications.
-
Product
X6 Optical Fiber Fusion Splicer
-
Smart-connected APP, Splicing record management, Intelligent burglary-resisting system 1 sec. topspeed boot time, 6 sec. splicing time, 12 secs. Heating time. 3D protection cover reduce risk and unpredictability. Handy, lightweight, anti-dropping solid and durable.Hi-Speed USB connection internet remote control.
-
Product
Fiber Optic Tester
OPTOWARE-FTTx-PON Test Solutions
-
FTTx networks using PON technology can be characterized and maintained every step of the way using very simple new fiber-optic test equipment.
-
Product
Optics Test Stations For Single Lenses And Optical Systems
OTS
-
Optik Elektronik Gerätetechnik GmbH
The optics test stations of the OTS series enable the computer-based, software-controlled measurement of optical parameters of individual lenses (including cylindrical lenses) and optical systems. Measured variables are, for example, focal length, MTF, focal length, radius, contact dimension, centering, wedge angle and deflection angle. The optional software module LensTest enables the measurement of the center thickness of lenses and air gaps in complete lenses as well as the measurement of the centering error of individual surfaces.
-
Product
Silicon Optical Power Head
81620C
-
The new 81620C optical power head provides a 5 mm detector area and allows flexible placement of the remote optical power meter, which is then connected to the N7749C. The 81620C accepts parallel beams with up to 4 mm diameter, standard SM fiber and MM fiber with max. 100 μm core diameter, NA ≤ 0.3. A wide choice of adapters allows input from popular fiber connector types, bare fibers or open beams. The magnetic D-shaped adapters allow rapid removal and replacement without twisting attached fibers.
-
Product
FPGA 6 Gsps Transceiver
VPX3-534
-
Curtiss-Wright Defense Solutions
The VPX3-534 combines high-speed multi-channel analog IO, user programmable FPGA processing and local processing in a single 3U VPX slot for direct RF wideband processing to 6 Gsps. This card allows for a high performance single slot transceiver with two 6 Gsps 12bit channels, to over 6 GHz instantaneous analog bandwidth, but can also scale to larger system with many channels.
-
Product
NI-5782, 100 MHz Bandwidth Transceiver Adapter Module for FlexRIO
782705-01
Transceiver Adapter Module
The NI‑5782 is ideal for applications that require the acquisition and generation of IF or baseband signals with in-line, real-time processing. You can analyze acquired signals in the PXI FPGA Module for FlexRIO to perform measurements and generate response signals. Application areas include RF modulation and demodulation, channel emulation, bit error rate testing (BERT), signal intelligence, radio frequency identification (RFID) and near-field communication (NFC) test, real-time spectrum analysis, and software defined radio (SDR).
-
-
Product
Galvanometer Optical Scanner
-
Citizen Chiba Precision Co., Ltd.
High performance and high reliability galvanoscanner (or called as galvanometer/galvanomotor/galvanoscanner motor) with high accurate optical analogue sensor which we newly developed.
-
Product
Optical Time Domain Reflectometer
OTDR II
-
The OTDR II (Optical Time Domain Reflectometer) excels in fault finding on fibre cabling with industry-leading specifications and performance levels on both single-mode and multimode fibre networks. Not only does OTDR II deliver accurate test data and pass/fail results, it also offers automated fault-finding capabilities that help to minimise network downtime.
-
Product
PCIe Fast Multifunction, Multichannel Counter Board, Optically Isolated, RS-422 Inputs
APCIE-1711-24V
-
The APCIe-1711 board is a fast multifunction and multichannel counter board for the PCI Express bus. The strengths of this board are its wide range of applications and high precision and reliability for industrial applications. With this board you can realise many different applications on the same hardware base. The board is supplied with a pool of functions which provide the user with maximum efficiency yet minimum space and parts requirement. The functions are individually configured for each channel through the supplied software. The flexible programming facilities on this board allow many differentuser applications to be quickly and easily developed and reconfigured as further requirements arise. Thanks to the FPGA board structure, further counting applications canbe realised through software adaptation.
-
Product
Optical Test Instruments
OptiSpheric® & Spherometer
-
TRIOPTICS' OptiSpheric® and Spherometer are the classic optical test systems for spherical lenses that can be found in virtually any optical manufacturing process. While the Spherometer is used for the tactile determination of lens radii, OptiSpheric® systems provide contactless measurement of effective focal length, back focal length, flange focal length, MTF on axis and the radius of lenses. Specific upgrades allow determining centration errors and angles on plane surfaces. Systems for testing IOLs in compliance with EN/ISO 11979 form a class of their own. OptiSpheric® IOL R&D is preferably used for measuring single lenses while OptiSpheric® IOL PRO 2 is designed for the fully automated IOL measurement in serial production.
-
Product
PXI Single 4 Channel Fibre Optic Mux SC/PC
40-850-214
Fiber Optic Switch
The 40-850-214 4-channel multiplexer is part of Pickering's range of PXI Fiber Optic MEMS Switching modules. They are available in many high density formats with a choice of different connector styles to suit most applications: FC/APC (for optimal performance), FC/PC and SC/PC for general applications and LC and MU for high density applications. Fiber optic multiplexers create a signal path by redirecting the optical signal into a selected output fiber. This is achieved using Micro-Mechanical Mirrors driven by a highly precise mechanism and activated via an electrical control signal.
-
Product
PXI/PXIe MEMS Optical MUX, 8-Channel, Multi-Mode, 62.5/125 Fiber
40-852A-018-M62.5-HI
Multiplexer Module
The 40/42-852A-018-M62.5-HI is a PXI/PXIe 8-channel multiplexer with FC/APC connectors, includes hardware interlock and is part of Pickering's range of PXI Fiber Optic MEMS Switching modules. They are available in many high density formats with a choice of different connector styles to suit most applications: FC/APC (for optimal performance), FC/PC and SC/PC for general applications and LC and MU for high density applications.
-
Product
Plastical Optical Fiber
POF
-
POF (Plastic Optical Fiber) is a new, convenient, effective, and economical method to construct optical networks at small office or home. A visible red light of 650 nm is utilized in this application so users can easily see the light at the cutting edge of the POF. Major application here is 100Mbps Fast Ethernet over POF implemented by distinct media converter or switches.
-
Product
PXI/PXIe MEMS Optical MUX, 8-Channel, Multi-Mode, 62.5/125 Fiber, SC/PC Connectors
42-852A-218-M62.5
Multiplexer Module
The 40/42-852A-218-M62.5 is a PXI/PXIe 8-channel multiplexer with SC/PC connectors and is part of Pickering's range of PXI Fiber Optic MEMS Switching modules. They are available in many high density formats with a choice of different connector styles to suit most applications: FC/APC (for optimal performance), FC/PC and SC/PC for general applications and LC and MU for high density applications.
-
Product
Optical Light Sources
FLS100 Series
-
Shanghai Tarluz Telecom Tech Co., LTD
FLS100 Optical Light source could provide maximum 4 wavelengths in one unit, it is an cost effective solution to work with FPM100 series optical power for installing fiber optic network. The unit support Single mode and Multimode (50/125um or 62.5/125um MM fiber) optical cable in one unit. It could support FC, SC, ST, LC and 2.5mm universal optical connector.
-
Product
Dual Fiber Transceivers
-
The benefits and overall savings on a single strand (simplex) versusdual strand (duplex) fiber implementation can be considerable.Considerations include not only the cost of fiber optic cabling itself,but also the labor and material involved in terminating the endpoints,simplex versus duplex patch cords, cross-connect rack space, reducedpoints of failure, and other direct and indirect costs. This technologycan also defer the need to install new fiber to support unexpectedgrowth requirements.
