Filter Results By:
Products
Applications
Manufacturers
-
product
Spectroscopic Personal Radiation Detector
identiFINDER® R200
identiFINDER® R200 instruments are rugged, pager-sized Spectroscopic Personal Radiation Detectors (SPRD). They provide full ANSI N42.32 Personal Radiation Detector (PRD) compliance and feature next-generation solid state detector read-out technology that delivers ANSI N42.48 SPRD compliance with nuclide identification. The R200-G detects and identifies gamma radiation and the R200-GN additionally provides neutron detection capability. Law enforcement agencies and first responders use the R200 during routine traffic stops or high visibility events and in mass transit or critical infrastructure entry control points. The OneTouch Reachback™ feature uses the latest advancements in Bluetooth® and web server technologies to provide large-scale situational awareness by alerting others before arriving on-scene.
-
product
Alpha Spectroscopy
Alpha spectroscopy is used to identify and quantify radionuclides based on the alpha particles emitted in the decay process. Similar to Gamma Spectroscopy, energy spectra are generated with high precision detectors and electronics and analyzed with special software. Typically, samples are measured following chemical separation to isolate the radionuclides of concern due to the complexity associated with correcting for these interferences with spectrum analysis software as is common for many Gamma Spectroscopy measurements.
-
product
Gross Gamma Screening System
The Gross Gamma Screening system is intended for the rapid screening of urine samples for the presence of elevated radioactivity in a post-radiological event scenario. This system allows up to eight urine samples to be counted simultaneously in discretely shielded 3” x 3” NaI Well radiation detectors to quickly identify elevated radioactivity from personnel in the exposed population. This screening process provides critical information to Emergency Response Agencies and is accomplished with minimal operator training.
-
product
Environmental (Radiation) Monitoring System
Hawk® EMS
The Hawk® EMS is a wall or tripod-mounted radiation monitoring and alarm system designed for use with the Hawk® Radius dual sensor radiation probe. Each EMS System comes with a Hawk Radius Probe. The system is extremely energy efficient and can run for weeks on an internal 9 volt back-up battery if power fails. It is well suited for operating on a small solar panel, which is an optional accessory. The Hawk® EMS features two displays that show the radiation levels measured by each of the probe’s two detectors: the weatherized “pancake-style” Geiger-Mueller tube — which measures alpha (if configured for it), beta, low energy gamma, and x-radiation — and the energy-compensated gamma tube which measures penetrating gamma dose rate. The probe can be mounted next to the EMS system or outdoors, or in adjacent rooms on cables up to 100 ft in length. Standard cable is 3 meters in length. Optional signal booster can support cable lengths longer than 100 feet. Optionally the system can also be configured to share data on ethernet or wireless networks.
-
product
HPGe Detectors & Spectrometers
Baltic Scientific Instruments, Ltd
Baltic Scientific Instruments produces gamma- and X-ray spectrometers based on HPGe coaxial or planar detectors with liquid nitrogen and electric machine cooling. The spectrometers are used for radionuclide analysis and for monitoring of activity in the nuclear industry and related environment monitoring. HPGe detectors have additional applications in scientific research and technology development as well as in various spheres of industry including security and border control.
-
product
Optical Meters
The Gamma Scientific range of light meters includes handheld and benchtop models. Configuration options include a wide range of sensors and calibrations in units including: Luminous Flux (lumens) or Radiant Flux (Watts), Illuminance (lux, foot-candle) or Irradiance (W/cm2 ), Luminous Intensity (candela) or Radiant Intensity (W/sr), Luminance (cd/m2 , foot-Lambert) or Radiance (W/m2 sr), or Pulse Energy (Joules). Cooled sensors and reference standard detectors are also available.
-
product
Mineral Insulated Extensions
The extreme operating conditions in which Photonis neutron and gamma detectors operate can lead to deterioration of organic insulated cables, resulting in signal degradation which often requires cable repair.
-
product
NIM-Modules
The "dual channel" TDC'''' - Model 7072T - converts time directly to a digital output. They offer improved performance and linearity specifications compared to separate TAC and ADC modules. There is also the Wilkinson-type ADC, Model 7070 which is suitable for high resolution HPGe detectors. Our Constant-Fraction discriminators are still state-of-the-art even after a more than 20 Year history. The Differential CFD - Model 7029A - still offers the highest counting rate (>50 MHz) of any such devices. Our Pulse-Shape Discriminator - Model 2160A - can be used to separate neutron and gamma particles, alphas and protons, electrons and alphas etc depending on the detector used.
-
product
HPGe Detectors & Spectrometers
Baltic Scientific Instruments, Ltd
Baltic Scientific Instruments produces Gamma- and X-ray spectrometers based on HPGe coaxial or planar detectors with liquid nitrogen and electric machine cooling. The spectrometers are used for the radionuclide analysis and calculation of the activity in nuclear industry and environment monitoring, as well as in various spheres of industry, science and technology.
-
product
Probes, Cables & Detectors
Probe has a mica window that has a thickness of 1.8 to 2.0 mg/cm2. This allows detection of alpha radiation as low as 3.0 MeV when in close proximity to the window. Beta radiation in excess of 35 keV and X-ray or gamma radiation greater than 6 keV can also be deteched. The detector is provided with a BNC connector. It can be used with most count rate and survey meters which accept Geiger Mueller (GM) detectors operating at 900V DC.
-
product
Gamma Detectors
In Gamma detectors, the gamma radiations produce electrons by interacting with the cathode material and the filling gas.These electrons ionize the gas and the charge carriers are collected by the electrodes. The resulting anode pulse is detected by a load circuit. The primary electrons are created by several interaction mechanisms:- Photoelectric effect- Compton scattering- Pair production
-
product
Gamma Spectrometer
A gamma spectrometer is a specialized instrument used to detect and measure the energy of gamma rays. It works by converting the high-energy gamma rays into electronic pulses, which are then analyzed to determine the energy distribution of the gamma radiation.
-
product
Gamma Coincidence
Our dual parameter MCA is capable of interpreting the shaper outputs from GammaSpec1K units in order to make a modular coincidence setup.
-
product
Detectors
Each detector is properly housed, complete with any associated circuitry and can be mounted directly at the exit slit of any of our monochromators.
-
product
Detectors
Teledyne RF & Microwave offers all types of detectors with both analog & threshold designs operating from 10MHz to 26GHz, with excellent power temperature stability.With over 50 ITAR-Free designs, many packaging options and with up to 10nS pulse response, Teledyne is able to offer the right detector for your particular application.
-
product
Detectors
A device or instrument designed to detect the presence of a particular object or substance and to emit a signal in response.
-
product
Detectors
Sanwa Electric Instrument Co., Ltd
A device or instrument designed to detect the presence of a particular object or substance and to emit a signal in response.
-
product
Neutron Detectors
As a neutron has no charge, a neutron detector incorporates a neutron-to-ionisation particle converter.The incident neutrons are captured by the converter material which then produces (detectable) ionising particles by means of a nuclear reaction.Photonis gas-filled detectors are designed to detect thermal neutrons (En < 0.025 eV), so the capture cross-section of the detecting material must be as large as possible for this low energy. We therefore use 235U (580 barn at 20 °C) for our fission chambers, and 10B (3840 barn at 20 °C) for our boron-lined proportional counters.
-
product
In-plant Detectors
In-plant detectors are similar in design to the portable detectors. The key difference being, the inspection surface moves past the stationary detectors.
-
product
Leak Detectors
In various market segments from the automotive industry to refrigeration and air conditioning technology to the manufacture of semiconductor components and solar technology our leak detectors provide the highest quality and increased process safety. With an INFICON leak detector, the time and money required for maintenance and troubleshooting of your products will be reduced to a minimum and your ongoing operating costs will be significantly less. An INFICON leak detector, for example, is so highly sensitive that a release of less than one millionth of a gram of gas can be shown to be a leak.
-
product
Detectors & Sensors
Excelitas offers Photonic Detection Solutions ranging from Silicon and InGaAS PINs and Avalanche Photodiodes, Hybrid Receivers, and Photon Counting Modules to address high-performance, high-volume applications across a wide range of markets. Excelitas Thermal IR Sensors represent a broad range of Pyroelectric Detectors, Thermopile Detectors and IR Sensor Modules used for motion detection, presence monitoring, temperature measurement and gas detection.
-
product
Energy Detectors
Our pyroelectric energy meters cover a very wide range, going from nanojoules to several tens of joules per pulse. They also come in various sizes, from 8 mm to 95 mm in diameter and most of them are available with an optional attenuator.
-
product
Radar Detectors
Explore our collection of premium radar detectors designed to fit your driving style and preferences.
-
-
product
Gas Detectors
At PCE Instruments you will find a professional quality gas detector / gas detection instrument for everyday use. The gas detector meets the requirements for personal safety and issued mainly for the detection of methane, hydrogen sulphide, carbon monoxide and oxygen levels (along with 50 other possible gases). The auto-calibration function allows for easy recalibration of the gas detector. Depending on the model, the gas detector has the ability to store data and later transfer recorded values to a computer.One accessory is the manual aspirator, with this device you can draw gas directly into the gas detection instrument via a 2m long tube with which you will be able to measure gas levels without having to be in direct contact with the gas source or to be able to determine the levels of gas in places that are difficult to access. Furthermore, we have a fixed installation gas detector in many different models available.
-
product
Flaw Detectors
GAOTek flaw detectors are designed as high-quality devices that provide accurate detection whilst delivering ease of use towards testing and monitoring. These detectors examine a material by passing sound waves at high frequencies through it and are used for applications that require ultrasonic testing. They are compact, easy to carry and portable devices that allow the user to work in complex conditions and circumstances, and available for purchase in the United States, Canada and globally.
-
product
Custom Detectors
Besides the described types Inphora can supply detector-filter combinations with parameters matching the customer's special requirement, with different sized housing, without housing. If the application determines the detector's spectral responsivity, we can achieve that with a filter designed exactly to the specifications. CCD cameras with unusual spectral sensitivity functions can be matched with filters to obtain CIE tristimulus response or photopic response. Similarly, photmultiplyers can be matched also with INPHORA filters. When determining parameters for a custom detector-filter combination several details have to be considered:
-
-
product
Gamma Air Monitor
Quant Air
QuantAir is a solution for measuring radioactive contamination in the air, it provides high-performance detection capabilities with accurate in-field quantification.
-
product
Voltage Detectors
JSC-88AW
The JSC-88AW is a very reliable way to know for sure whether or not there is voltage downstream from the switches or breakers during power-offs. It dramatically increases the safety of personnel assigned to maintenance work on electrical equipment powered by three-phase voltage. As long as voltage is present downstream of the breakers, one or more (LEDs) of the JSC-88AW will stay lit. A simple visual inspection tells you whether the electrical system is in “Zero Energy” mode. In addition, this new device has been improved to enable resistance to voltage spikes (transients).
