-
product
SQUID Series Arrays
The SQUID series arrays are ideal for readout of TES sensors or as amplifier stage for discrete two-stage applications. Integrated bias resistors for TES or two-stage applications reduce wiring complexity. Various arrays with input inductances of 3 to 6 nH, input sensitivities of 17 to 23 µA/Phi0, and a current noise between 5 and 10 pA/sqrt(Hz) @ 4 K are available.
-
product
ICP Electret Array Microphone
130A23
Nominal Microphone Diameter: 1/4" Frequency Response Characteristic (at 0 incidence)Free-FieldInherent Noise (A Weighted)<30 dB(A) re 20 Pa<30 dB(A) re 20 Pa Dynamic Range (High)150Environmental Temperature Range ( Temperature Effect on Output (-10 to +50 C)<0.7 dB<0.7 dB[2] Influence of Axial Vibration Excitation Voltage 18 to 30 VDC18 to 30 VDC
-
product
Impadence Measurement on Multielectrode Arrays
MEArack
Well established in electro-physiological research the standard form factor multielectrode arrays (MEAs) are one of the go-to standards when it comes to impedance measurements on cell cultures.
-
product
Mobile Sound Ranging Array
MSRA
In a peer to peer conflict, weapon location radars used for counter battery purposes will be extremely vulnerable.With aerial/satellite based surveillance available for the opponent, radars will be seen. With electronic warfare means being omnipresent, radars will be triangulated and jammed. There is an urgent need for 24/7 persistent surveillance with (preferably) passive sensors. With mobility being the key for survival on the battlefield, rapid re-deployable, or even truly mobile sensor capabilities are required. Therefore, the traditional sheer sound pressure based sound ranging capability becomes obsolete, as the triangular footprint of the sensor nodes is too large to be installed on a manned, or unmanned platform. With the trend towards longer ranges and “shoot and scoot” drills, the concept of capturing the muzzle blast noise becomes questionable, as the speed of sound is too slow to provide timely localizations.
-
product
Solar Array Simulator
G5.SAS
The G5.SAS series are unidirectional sources. It was developed specifically for testing inverters and simulating solar arrays and is suitable for use in laboratories and on test benches. The modular and finely graded G5.SAS series is characterized by highly dynamic response times and a wide current-voltage range with an auto-ranging factor 3. The power supplies feature especially low capacitance values in the output filter stage and switchable earth leakage resistors for adaptation to the insulation measurement of the DUT.
-
product
SparkFun IR Array Breakout
110 Degree FOV, MLX90640 (Qwiic)
It's time to say hip hip array for this IR Breakout! The MLX90640 SparkFun IR Array Breakout is equipped with a 32x24 array of thermopile sensors creating, in essence, a low resolution thermal imaging camera. With this breakout you can detect surface temperatures from many feet away with an accuracy of ±1.5°C (best case). To make it even easier to get your low-resolution infrared image, all communication is enacted exclusively via I2C, utilizing our handy Qwiic system. However, we still have broken out 0.1"-spaced pins in case you prefer to use a breadboard.
-
product
Photodiode
A high sensitivity receiver in a fiber pigtail coupled package, it includes a high speed InGaAs avalanche photodiode with a high gain TIA in a hermetically sealed coaxial package. It incorporates an LC/UPC pigtail and a flexible printed circuit (FPC). The signal GND and a receptacle are electrically isolated in this APD receiver.
-
product
Grid-EYE® Infrared Array Sensors
Panasonic Industrial Devices Sales Company of America
Panasonic Grid-EYE® is an 8x8 (64) pixel Infrared Array Sensor. This Sensor offers digital output (I2C) for thermal presence, direction, and temperature values. The built-in lens includes a 60-degree viewing angle. Grid-EYE features compact SMD design using MEMS thermopile technology.
-
product
Phased Array Corrosion Mapping Software
Concerto
Concerto is a UT acquisition and analysis software specially designed for Phased Array corrosion mapping. For the tough field conditions that operators deal with Concerto features no menu, less than 18 icons, and few controls so that operators can easily work and not be bothered by complex GUIs. Concerto is simple and easy to work with yet WT, Surface, and back wall C-scan can still be analyzed and setting can be changed using the same acquired data.
-
product
Log Periodic Dipole Array
ALP650
Skeletal design remote antenna with onboard amplifier ideal for long cable runs, phantom powered from Venue, UMC16 or Bias T. The ALP Series antennas are a Log Periodic Dipole Array (LPDA) design that provides a useful directional pattern over a broad frequency bandwidth.
-
product
SINE M-15-60 Sinusoidal Array
The reflective Sinusoidal Array SINE M-15-60 is similar to the M-13-60 (1X version) except that the range of spatial frequencies begins with 0.25 cycles per mm and extends to 20 cycles per mm. To compensate for the additional frequencies, the 3/16 cycles per mm area has been eliminated. Both arrays are imaged on Photo Paper.
-
product
Column Array Loudspeakers
CAL
Designed primarily for vocal reproduction in fixed installations, CAL loudspeakers produce a vertical beam of programmable width and then digitally steer the beam’s pattern up to 30 degrees up or down for best intelligibility.
-
product
EMI Filter/TVS Arrays
ProTek offers TVS protection and EMI Filtering all in one package. These space saving devices are ideal for use in portable electronics such as Cellular Phones, Cellular Phone Accessories, Laptops, and PDAs.
-
product
Grid-EYE® Unit Infrared Array Sensor
Panasonic Industrial Devices Sales Company of America
Panasonic is pleased to announce the availability of the Panasonic Grid-EYE® Infrared Array Sensor Unit. The Grid-EYE Unit combines four Grid-EYE Infrared Array Sensors to increase the detection area up to 3.8m squared. The Grid-EYE Unit comes preloaded with firmware capable of detection and counting up to 8 people within this area and while they are in this area it can track their direction of movement. The Sensor transmits this information via RS485 using Modbus protocol.
-
product
SINE M-5 Sinusoidal Array
The Sinusoidal Array SINE M-5 is made on a strip of 70mm film approximately 5.12 inches (130mm) in length.The upper row contains the sinusoidal areas with the spatial frequencies in cycles per mm. All sinusoidal areas are carefully oriented with respect to the others, and the lines at the left end of the array have been added for alignment purposes.
-
product
*Photodiode Energy Sensors
Ophir photodiode laser energy sensors are able to measure low energy pulses down to 10pJ at frequencies up to 20 kHz. Silicon photodiodes for the UV and visible spectrum and Germanium photodiodes for infrared.
-
product
Array Solutions K9AY Loop Wire/Mast Kit
AS-AYL-4 WM
All materials required for the installation of your receiving loop system, have been included in this kit with the exception of those items listed below under the heading; ‘You will also need. ‘ The specified 8’ x 5/8” copper-clad steel ground rod can be purchased at just about any local hardware store or home center.
-
product
Avalanche Photodiodes
Excelitas offers Avalanche Photodiodes (APDs) on both Silicon (Si) and InGaAs materials. Si APDs cover the spectral range of 400 nm to 1100 nm and the InGaAs APDs cover 950 nm to 1550 nm. An Avalanche Photodiode (APD) provides higher sensitivity than a standard photodiode and is for extreme low-level light (LLL) detection and photon counting.
-
product
Phase Array Antenna System
Electronically steers radio waves without physical movement by using an array of antennas.
-
product
RMX-8268, 24-Drive, 5 GB/s RAID Array
786365-01
The RMX-8268 supports high-speed, sustained reading and writing to disk for PXI streaming systems. The RMX-8268 includes a hardware RAID controller and a set of 24 drives. You can interface the RMX-8268 to a PXI Express chassis using a PXIe-8394 Bus … Extension Module.
-
product
Ultra-Low Noise 2 kHz Photoreceiver w/ Si-PIN Photodiode
PWPR-2K-SI
Picowatt Photoreceiver series PWPR-2K with switchable gain (10 to the 9th V/A, 10 to the 10th V/A) and a bandwidth from DC to 2 kHz is the perfect choice for cw-measurements, time resolved signal acquisitions and highly sensitive modulated measurements. Si and InGaAs models cover the wavelength range from 320 to 1700 nm.
-
product
Modular Solar Array Simulator Mainframe, 1200W
E4360A
The Keysight 1200W, E4360A Modular Solar Array Simulator is a 2U high, 2-slot mainframe that accepts up to 2 E4360 series modules. Modules are ordered separately. It offers LAN, USB, and GPIB interfaces standard.
-
product
SINE M-7 Sinusoidal Array
The Sinusoidal Array SINE M-7 has an image size of 22mm x 30mm which makes it small enough to fit into a standard 35mm projection frame. The gray scale is contained in the outer rows. It is made on 35mm perforated film.The TM-G variations are produced on a wider film (without perforations) and cemented between glass. They are available at each modulation (-35, -60, -80).
-
product
Phased Array
Phased array machines provide precise measurement with the most reliable results. Our range of phased array devices produce accurate, detailed cross-sectional pictures of internal structures at fast inspection speeds.
-
product
Diode Arrays
a silicon diode with minimal packaging overhead. The small signal 0603, 1005 and 1206 Chip Diodes are lead free with Cu/Ni/Au plated terminations while the other packages (SMA, SMB, SMC, 1408, 1607, 2010, 2419, 8L NSOIC, 16L NSOIC, SOT23, SOT23-6, 16L WSOIC) use 100 % Tin terminations. All Bourns® diodes are compatible with lead free manufacturing processes, conforming to many industry and government regulations on lead free components.
-
product
Solar Array Simulator
62000H-S series
The latest programmable solar array simulator power supply 62000H-S Series released by Chroma provide simulation of Voc (open circuit voltage) up to 1800V and Isc (short circuit current) up to 30A. The 62000H-S provides an industry leading power density in a small 3U high package. The solar array simulator is highly stable and has a fast transient response design, which are both advantageous to MPPT performance evaluation on PV inverter devices. The 62000H-S Series have many unique advantages including high speed & precision digitizing measurement circuits with a 100kHz A/D, 25kHz D/A controlled I-V curve and a digital filter mechanism. It can simulate an I-V curve accurately and response the mains ripple effect from the PV inverter. In addition, the built-in EN50530/Sandia SAS I-V model in the standalone unit can easily program the Voc, Isc, Vmp, and Imp parameters for I-V curve simulation, without a PC controller.
-
product
CAS-200 Compact Array Spectrometer
CAS-200
Hangzhou Everfine Photo-E-Info Co., LTD
CAS-200 can quickly and accurately measure the spectral power distribution in the range of 380nm ~ 780nm, mainly measuring: the relative spectral power distribution, chromaticity coordinate, color temperature, color rendering index, color tolerance, peak wavelength, FWHM, luminous flux (with integrating sphere) of traditional lamps/light sources, single LED, LED modules and other electric light sources.
-
product
Rail Wheel Testing Using Phased Array System
ECHOMAC® PA Wheel Tester
MAC introduces two versions of Rail Wheel Testers using ECHOMAC® PA platform based on customer requirements. One is a semi-automated solution using local immersion technique. Used for tread inspection of new and/or reprofiled wheels. This solution meets or exceeds EN13262, ISO5948 or AAR M-107/M-208 standards for tread inspection. The second solution is a fully automated immersion tank. Performs tread and face inspection of rail wheels using two phased array probes simultaneously. This solution meets or exceeds EN13262, ISO5948 or AAR M-107/M-208 standards for tread and face inspection, while monitoring the backwall on the face side per EN 13262.
-
product
SINE Sinusoidal Vision Demonstration Array
The Sinusoidal Visual Demonstration Array is designed to demonstrate the Modulation Transfer Function (MTF) of the human eye. Its transmittance varies sinusoidally and increases in spatial frequency from 0.2 to 20 c/mm, following a logrithmic scale. The modulation increases linearly from top to bottom. One can see, in the image, where the visual contrast contour disappears which is the MTF of the eye. Ideally suited for teaching and demonstration, the Array is available on film mounted in glass (-G), or mounted in a 2″x 2″ projection slide.(-SL)
-
product
Array Solutions OCF
Series Dipoles
Thank you and congratulations on your purchase of the Array Solutions, OffCenter Fed HF Dipole Antenna System. This antenna was built with the same quality workmanship and attention to detail as our military, government and commercial wire antenna products. It is ideal for ARES/RACES, MARS/CAP, USCG Aux., Red Cross, Salvation Army and other disaster and relief organization use. It is built especially for high duty cycle, harsh environmental applications. The use of the finest quality components available and our “overbuilt” quality construction means your new antenna will last for years under the most difficult conditions, while requiring little or no maintenance.
