Line Impedance Stabilization Network
Line Impedance Stabilization Network
See Also: Line Impedance, LISN
-
Product
MIL-STD-1553 Data Acquisition Module for Ethernet Networks
eDAQ-1553
-
Avionics Interface Technologies
One or two dual redundant MIL-STD-1553 bus interfaces - Transformer and Direct bus coupling supported - Two 10/100/1000 Mbit/s Ethernet LAN Interfaces - Streams MIL-STD-1553 bus data in standard IRIG 106 Chapter 10 format. - Compatible with 3rd party recorders and telemetry tools - All captured MIL-STD-1553 bus data provided with timestamps - Full error injection & detection capabilities - Works with AIT’s Flight Simulyzer™ GUI Analyzer/Simulator software
-
Product
Network Management
RESTORE
-
While connected to neighbouring supply the RESTORE provides protection against several possible hazardous situations.
-
Product
Short Circuit Loop Impedance Meter
AMZC-304
-
Short circuit loop impedance measurement in networks with nominal voltage: 220/380V, 230/400V, 240/415V, with frequency 45…65Hz ; Short circuit loop impedance measurement with 15mA current, without triggering RCD. ; Detection of the replacement L and N in the socket and automatic swap in the meter
-
Product
Precision Stabilized Positioners
-
CAES’ precision stabilized positioners and digital controls provide the industry with the best combination of reliability, precision and value. Our military Commercial Off the Shelf (COTS) products incorporate field-proven expertise in Line of Sight (LOS) stabilization and control systems technology, with modular designs and sizes to accommodate a range of sensor payloads.
-
Product
2U Rackmount Network Application Platform Base On Intel 12th/13th/14th Gen Intel® Core Processors. Ideal For Data Center Deployments.
FWA-4134
-
12th/13th/14th Gen Intel Core Processors, up to 24 Cores/32 Threads, Hybrid Performance & Efficiency Cores4 x DDR4 3200MHz ECC UDIMMs, up to 128GB4/8 x Advantech network module expansions1x Mini-PCIe slot1x PCIe x8 slot on rear, supports FH/HL add-on cards1 x mSATA slot, 2/4 x 3.5” HDD bays
-
Product
Network AutoTester
LinkRunner® AT
-
Test and validate copper and fiber Ethernet connectivity in less than 10 seconds. Validate up to 30W 802.3af/at PSE with TruePower™ loaded Power over Ethernet (PoE) test. Verify twisted-pair cable length and wire-map in a snap.
-
Product
ProfiShark Network TAPs
-
ProfiSharks are portable traffic capture devices that provide quick packet-level insight anywhere they are deployed. With capture regardless of packet rate and high quality hardware timestamping, ProfiShark delivers high fidelity capture files, forming an ideal starting point for troubleshooting or network forensics. Designed for easy, non-intrusive traffic capture, ProfiShark offers a valuable improvement over less performant options, such as SPAN ports on a switch or direct capture on a laptop. They give reliable insight into the network, ensuring the quality of analysis, and optimizing workflow, without dropping any packets.
-
Product
2U Rackmount Network Appliance Platform With Dual LGA2011 Socket Intel® Xeon® E5-2600 V3/v4 Family Processors, Intel® C612 And Up To 42 LAN
NA850
-
The NA850 offers cutting edge performance for networking applications with dual high performance 12-core Intel® Xeon® E5-2600 V3 series processors and Intel® C612 chipset, 16 high bandwidth DDR4 memory slots and two hot swappable 3.5” SATA HDD bays. For greater flexible and easy maintenance, the NA850 can be fitted with up to five Ethernet modules, supporting up to 42 Gigabit LAN ports or 20 10GbE LAN ports. Two PCIe x16 standard expansion slots are available for optional network security cards. The superior network appliance platform also supports the Intel® Data Plane Development Kit (Intel® DPDK), a set of software libraries that can improve packet processing performance by up to ten times. It could achieve over 80 Mbps on a single Intel Xeon processor and double with a dual-processor configuration. With its friendly design and high capacity, this powerful network appliance is suited for IDS/IPS, VPN, content filtering, UTM, network security applications, and cloud computing solutions.
-
Product
5 Gb/s Programmable Digital Delay Line
PDDL5
-
The PDDL5 is a precision time delay generator for digital signals. Delays are controlled precisely in 5, 10 or 20 ps increments from 0 to 5115, 10,230 or 20,460 ps range respectively. Data rates up to 5 gigabits per second are supported for very high-speed applications. Delays can be programmed via a TTL bus.
-
Product
Network Test and Security
-
Ensuring high performance of wired, Wi-Fi, and 3G/4G/LTE and 5G networks in both pre-deployment and real-world environments while enabling dynamic security intelligence to help stay one step ahead of attacks.
-
Product
2 Port Analog Phone Line (FXS)
SIM-2FXS
-
This unit has 2 analog phone lines (FXS) making it a perfect tool for testing VoIP gateways, IVR, modems, access servers, audio conference equipment or anything that requires phone lines. Telephone line simulator acts like a "telephone company in a box" providing dial tone, ring voltage and all advanced phone line features such Caller ID, Call Waiting, Call Hold, Three Way Calling and many others.
-
Product
Test Line • Perforation counter
Perforation counter PZ 3
-
The perforation counter PZ 3 can be used among other things in the production of plastic bags and garbage bags. By the non-contact perforation detection, for example, the number of bags / batches can be determined and the roll change can be initiated.
-
Product
Multi-Protocol Wireless Application Networking System with Open, Integrated, Secure & Scalable System for Data Aggregation & Viewing
Ion
-
Jacobs’ vendor agnostic architecture was designed and implemented with the goal of an open Industrial Internet of Things (IoT) solution. ion© adapts and applies technology that enables our customers to gain efficiencies and savings, through connecting our client’s sites then collecting and displaying data in a unified interface. This provides custom insights to our clients, empowering them to ensure safety and respond quickly. The Jacobs ion© solution has been operationally deployed for over a decade and enables innovative approaches for data accuracy, data timeliness, and safety — greatly improving information flow and productivity.
-
Product
Single-in-Line Reed Relays from Pickering Electronics
SIL / SIP
Reed Relay
The SIL / SIP reed relay is the industry standard when high reliability and consistent performance are desired in a compact package. Pickering Electronics Series 100 - 119 SIL / SIP reed relays feature the highest quality instrumentation grade reed switches making them suitable for the most demanding applications. Features include:
-
Product
FC(Fuel Cell) Impedance Measurement System
KFM2150 System
-
The KFM2150 system is a fuel cell impedance measurement system configured with an FC impedance meter KFM2150 and an electronic load PLZ-4W series. Combination of KFM2150 and PLZ-4WA series (0V input type) supports impedance measurement for single cell of fuel cell.In addition to impedance measurement with AC impedance method, KFM2150 system provides IR measurement with current interrupt method.Application software enables test for each characteristic of fuel cell such as I-V characteristics, Constant Current characteristics, Current Interrupt method and Cole-Cole plot by the AC impedance method. Moreover, each test can be performed in a specified order.
-
Product
High Impedance Active Probes
7A
-
An unterminated version, can be used for capacitance and resistance measurements or in low to medium speed signal applications where a 50 ohm termination is not required. A flexible coaxial cable length of 6 feet in length is standard on the Model 7A; however, when used for capacitance measurements, GGB Industries, Inc., recommends using a shorter 3 foot cable. If a shorter length of cable is desired for capacitance measurements, please specify it when ordering (Model 7A-3ft.). Please note that Model 7A uses Model 7 replacement tips.
-
Product
High Impedance Transformers
-
Osborne high impedance transformers are used to step-up, step-down and isolate voltages in single phase and three phase circuits. A properly designed high impedance transformer can be used an an equivalent to an isolation transformer connected in series with an inductor. The high impedance characteristic may be employed as a current limiting feature in both the primary and secondary circuity.
-
Product
LAN Network Testers
-
A cable detector can locate open power cables, either live or without current, up to 300 V. A cable detector can locate cables, circuits, short circuits and ground wires. To perform these functions, it is not always necessary to disconnect electrically sensitive devices or to disconnect the power to the cable being tested.Many cable detector devices can also locate ferrous and non-ferrous metals, wood and plastic with high degrees of accuracy. A cable detector provides a safe way to test wall sockets for which no electrical plans or wiring information is available about the cables or their output. A cable detector is very versatile, as it ensures speed and safety when making holes in walls, ceilings and floors.
-
Product
Line Powered Level Switch
ThePoint
-
ThePoint Line Powered provides a relay output switch and has hazardous area approvals making it a good choice for most of your point level application requirements. ThePoint sensing element offering is suitable for most temperature, pressure, and material types.
-
Product
625 KHz Data Acquisition Multifunction (Analog Output X2 Lines) PCMCIA
DAQi616MF(MF236/i)
-
The DAQi616MF is a type II PCMCIA I/O card for notebooks and other computers containing a PCMCIA slot.
-
Product
Network Analyzer, Tester, RJ45/RJ11, LED
72-9945
-
Quickly test RJ-45 and RJ-11 cables. Features LED's for each conductor for individual continuity testing.
-
Product
Telephone And Line Analyzer
TALAN™ 3.0
-
The TALAN 3.0 Telephone and Line Analyzer represents advanced capability to detect and locate illicit tampering and security vulnerabilities on digital, analog, and VoIP telephone systems. New hardware provides the ability to test twisted pairs against modern telecommunication threats including shield and ground.
-
Product
Network Interface Card
NIC10GFT
Interface Card
The NIC10GFT is a dual port 10GBase-T XMC module that brings 10GbE expandability to new and existing embedded systems with available XMC slots.
-
Product
Wafer Prober Networking System
PN-300
-
The Wafer Prober Networking System PN-300 utilizes a database to facilitate data access from other systems and provides an environment that enables the user to edit data and handle processing. The system achieves wide-ranging compatibility by adopting standard hardware and operating system. In addition, it is equipped with an N-PAF (Network-based Prober Advanced Function) to provide robust support for wafer prober operation and maintenance.
-
Product
Artificial Power Supply Network
KH3762
-
Beijing KeHuan Century EMC Technology Co,.LTD
The artificial power supply network (also called the power supply impedance stabilization network) should be able to provide a stable impedance to the device under test in the radio frequency range, isolate the device under test from high-frequency interference on the power grid, and then couple the interference voltage to the receiver.
-
Product
Networking Solutions
Wi-Fi® Modules
-
Silicon Labs' all-inclusive Wi-Fi module are targeted for applications where excellent RF performance, low power consumption and easy application development together with fast time to market are key requirements.
-
Product
Network Security Testing
-
Network Security Testing helps to identify the vulnerabilities in the security system of a business and to guide with solutions to improve the security measures. The key objective of network security testing is to identify the security risks, level of possible threats and revenue impact. QA Mentor follows their proven 4-D model and use the derived security measures to secure the business system with help of iterative vulnerability assessment and network penetration testing.
-
Product
Shared Memory Network PCI & PCIx Interface
PCI-SMN
-
Avionics Interface Technologies
2.125 Gbps Optical loop network - Single-mode and Multi-mode optical interfaces supported - Up to 256 Shared Memory Network nodes supported - Up to 200 MByte/sec sustained data rates - Maximum 500 nS latency between nodes - Network interrupts supported - Compatible with PCI & PCIx Host System Slots - Software Drivers available for Windows, Linux, LabVIEW Real-Time, and VxWorks
-
Product
Network Probe for TC-NT2
TC-TP1
-
TRENDnet´s TC-TP1 is an easy-to-use amplified inductor and tone probe that is used for tone tracing and line testing. The TC-TP1 features a simple push button that provides easy operation and conserves battery power. This ergonomically designed device comes with adjustable volume control and signal LED for enhanced accuracy in noisy environments.
-
Product
Utilization Planning, Radio Network Configuration, Data Distribution
SOVERON
-
R&S®SOVERON® management software supports centralized network management, where a central organizational unit performs complete mission planning as well as decentralized management, where the various configuration steps are made at different military hierarchy levels.
