Labs
-
Product
Spectroscopy
Vis-NIR Spectroscopy Lab Analyzers
-
Metrohm NIRS lab analyzers enable you to perform routine analysis quickly and with confidence – without requiring sample preparation or additional reagents and yielding results in less than a minute. Combining visible (Vis) and near-infrared (NIR) spectroscopy, these analyzers are capable of performing qualitative analysis of various materials and quantitative analysis of a number of physical and chemical parameters in one run.
-
Product
Test Capabilities
-
Eltek International Laboratories
ELTEK Labs has conducted more Electrical Insulation Systems (EIS) and Component Compatibility Testing (CCT) than all other laboratories worldwide combined. ELTEK Labs is proud to be a Third-Party Testing Laboratory for internationally recognized certifying bodies.
-
Product
AC Leakage Current Tester
229-2
-
Testing for dangerous small leakage currents is easy with the Simpson Model 229-2 Leakage Current Tester. For use in appliance field service, in the lab, or in production, the 229-2 approximates the human threshold of perception in detecting hazardous AC leakage current. The 229-2 comes with test leads with alligator clips, manual and batteries.
-
Product
Microscopy and Nanotechnology Labs
-
Integrated Dynamics Engineering
IDE, with the most vibration isolation and EMI cancellation systems in use today, is no stranger to nanotechnology. For over twenty years, IDE has been addressing the special needs of research environments with advanced isolation solutions. IDE’s influence and global reach can be seen in the most cutting edge labs pushing physical boundaries to extremes in advanced materials, surface science, microbiology and more.
-
Product
ATCA 5U 7 Slot replicated Mesh - dual shelf managers
109ATCA507-3000R
-
The 5U 7-slot ATCA backplane is a Replicated Mesh, compliant to the PICMG 3.0 Rev 3.0 specification. Elma Bustronic’s ATCA backplanes have been simulated and characterized by our signal integrity lab to optimize performance.
-
Product
Cryogenic Lab Applications
-
Lake Shore products are used in a large variety of applications. Find your application here to see the recommended products.
-
Product
Network Emulation 100GE, 50GE, 40GE, 25GE, 10GE
-
Chimera by Xena is a network impairment emulator that makes it easy to introduce consistent, accurate, well-defined and repeatable impairments (e.g. packet manipulation, latency, jitter, bandwidth control and shaping) to traffic between DUTs in the lab. All rates from 10GE to 100GE are supported by a single 2-slot test module.
-
Product
Wireless Accreditations
-
MET Labs is a global leader in wireless testing with capabilities ranging from standard FCC & CE compliance to sophisticated cutting-edge programs like ZigBee.
-
Product
DC Power Supply, 30V, 5A
U8002A
DC Power Supply
The Keysight U8002A 30V/5A single-output, non-programmable DC power supplies is suitable for a variety of electronics manufacturing applications. With our affordable pricing, it is also well suited for usage in education labs.
-
Product
Oil Analyzers
-
We provide lab instruments, on-site oil analysis systems, and portable tools for a variety of customer needs . Our analyzers provide critical data about machinery condition and can provide an early warning of equipment failure.
-
Product
Water Samplers: Water Samplers
-
A water sampler is often used in conjunction with a CTD. The water sampler collects 1 or more actual samples of water for analysis in the lab after recovery of the package. The water samples can be used to verify the accuracy of data measured by the instruments on the package, and/or to provide additional information that cannot be measured with an instrument in the field. Sea-Bird water samplers can be controlled (i.e., bottles closed) from deck via a Sea-Bird deck unit and software, or can be pre-programmed to close bottles at desired depths. Sea-Bird manufactures two water samplers: the SBE 32 Carousel (up to 36 bottles, 1.7 - 30 liters, available in regular, compact, and sub-compact sizes, for depths to 10,500 m) and the SBE 55 ECO (small, 3- or 6-bottle sampler for depths to 600 meters).
-
Product
RK Deadweight Tester
-
AMETEK Sensors, Test & Calibration
The RK floating ball type pneumatic dead weight tester is engineered to offer user-friendly, safe operation. The easy-to-use primary standard provides reliable and accurate pressure measurement in the field, or in a lab.
-
Product
Dual Output Digital Lab Series Regulated DC Power Supply – Upto 1280W
-
- 300W to 1280W different combination- High current density.- 19″ rack adaptable -3U high- Remote sensing.- Front panel potentiometer to set V&I- 3Digit seven segment display for V&I- High stability and close regulation- Phase controlled preregulation plus linear post regulation- Optional, at extra cost- Over voltage protection- 19″ rack mounting- Analogue programming and monitoring for V&I
-
Product
PXIe Avionics Interface Cards
Interface
The OmniBus II PXIe is the next-generation of Astronics' popular OmniBus product with faster I/O and processing capabilities. With the newest advanced set of MIL-STD-1553 and ARINC 429 modules, users can verify wave form compatibilities, test functions of bus shorts and opens, and—when combined with our CoPilot® software—perform lab, production and flight test verification and simulation right out of the box. Readily available as Commercial Off-The-Shelf (COTS) products, the PCIe interface is perfect for challenging simulation, test, interface, and data recording applications.
-
Product
UL & CSA
-
If you are selling your product in the US and Canada, you need to comply with the applicable nationally accepted UL & CSA (and possibly other) standards. F2 Labs can evaluate and test your product, help you through the certification process and enable you to get your US and Canadian certifications to the UL and CSA standards.
-
Product
ATCA 5U 6 Slot Mesh with Radial IPMB
109ATCA506-3010R
-
The 5U 6-slot ATCA backplane is a 3X Replicated Mesh, compliant to the PICMG 3.0 Rev 3.0 specification. Elma Bustronic’s ATCA backplanes have been simulated and characterized by our signal integrity lab to optimize performance.
-
Product
Handheld Calibrators
-
These handheld calibrators are perfect for calibrating thermocouples and RTD's in cases where the sensors are fixed or need to be calibrated on the spot. Locations such as factory floor or in the lab.
-
Product
Barometers
-
Ideal for recording ambient changes in lab, monitoring conditions affecting sample analysis, and assisting in prediction of weather changesUnit includes a barometer, thermometer, clock, altitude adjustment, and weather symbol forecasting symbolsAdjustable altitude compensation from –900 to 3600 feet (–300 to 1200 meters)Barometric trend shows current reading, previous 1, 3, 6, and 12-hour readings in bar chart f
-
Product
GMSL3
-
FRAMOS is the first company in the market to integrate Analog Devices’s new GMSL3 technology into an embedded vision environment. GMSL3 can transmit high frame rates (4K, 90 fps) as far as 14 meters with unprecedented efficiency. This interface is well suited for applications where the MIPI CSI-2 (D-PHY) length restrictions are not sufficient, while at the same time, a highly durable cable with low power consumption and low cost are essential. Camera developers can use the flexible FRAMOS Sensor Module Ecosystem to validate a variety of image sensors in the lab and in the field while taking advantage of the interface’s features.
-
Product
Wireless Networking Systems
ZigBee®
-
Silicon Labs is the vendor of choice for OEMs developing ZigBee networking into their products. The Silicon Labs ZigBee platform is the most integrated, complete and feature rich ZigBee solution available a family of Wireless SoCs, based on ARM Cortex processor and 2.4 GHz transceiver, together the most reliable, scalable and advanced ZigBee software and supported by best-in-class development tools.
-
Product
Standard Light Source
SLS-50W
-
OSRAM Standard Lamp to calibrate the spectrum and luminous flux with Lisun Lab certification. The data can be traced NIM. The Standard Lamp Source is used to calibrate the integrating sphere system. The different size of Integrating Sphere should choose the right power of standard lamp source.
-
Product
Produce Quality Meter
F-750
-
The F-750 Handheld Brix & Dry Matter Meter uses near-infrared (NIR) spectroscopy to estimate quality metrics such as dry matter, Total Soluble Solids (TSS or brix), titratable acidity, and color. Working like a high-powered flashlight, the F-750 sends particles of light into a commodity, then measures the NIR light interactance with molecular components inside of the commodity to quantify user-selected traits. The F-750 has a wide range of applications, from determining optimal harvest timing by assessing fruit maturity, to providing an objective analysis of produce quality of fruit in packing houses and upon import. The F-750 is a handheld, fully integrated system, allowing users to operate it out in the orchard or inside the QA lab. Its simple, intuitive user interface makes it easy for anyone to use, while its model building software makes it customizable and versatile.
-
Product
CGH & CGH+SNP Microarray Platform
-
Learn about Agilent’s industry leading CGH + SNP Microarray platform for your workflows and clinical research needs. Agilent provides a complete platform including microarrays, reagents, hardware and software. With almost 20 years’ experience and thousands of publications, Agilent’s CGH platform is widely adopted by cytogenetics labs running pre- and post-natal, preimplantation and cancer clinical research. The platform enables to quickly and reliably identify aneuploidies, microdeletions, microduplications, as well as other types of chromosomal aberrations across the genome. Agilent’s CGH platform offers real comparative genomic data thanks to the 2-color approach, and unlimited flexibility in terms of format and content. Learn more about our catalog and custom microarrays.
-
Product
ICAM ProofCards™
-
CertiPath, the leader in high-assurance identity management and security solutions, now offers ICAM ProofCards. These ICAM ProofCards have been specifically created to leverage the testing infrastructure of the GSA Approved Products List to provide the closest possible approximation of the conditions a product will be tested under at the GSA FICAM APL lab.
-
Product
Microcontrollers (MCUs)
8-bit
-
An innovative 8-bit chip design provides a fully-integrated experience. Silicon Labs' 8-bit MCUs are ideal for IoT applications and beyond, delivering the industry's fastest speeds and lowest power.
-
Product
Stress Testing System
Load Dynamix
-
LoadDynamix (former Swifttest) is famous for its IP based converged storage system stress testing, including iSCSI, SMB/CIFS, NFS, FC and HTTP/HTTPS based storage systems. Its GUI interface is very easy to use and allow customer engineer to fully configure all the parameters at the protcol layer. Nearlly all the major IP storage system manufacturers have LoadDynamix products in their test lab.
-
Product
Primary Standard Capacitors
GenRad 1404 Series
-
The GenRad 1404 Series standard capacitors are the standard of choice in metrology labs, and still used today by standards bodies around the world. These capacitors have been designed as primary reference standards of capacitance with which working standards can be compared.
-
Product
100-Amp Current Calibrator And AC/DC Transconductance Amplifier
2555A
-
World’s Leading Precision 100-Amp AC/DC Current Standard - For 30 years Valhalla Scientific’s design has proven rock-solid reliability in metrology labs worldwide. The 2555A is a calibration powerhouse with wide-ranging applications and unsurpassed quality.
-
Product
High Voltage DC Lab Power Supplies 300V-5000V Output for Research Labs / Capacitor Testing – 300, 600, 1000, 3000, 5000V
-
- 19” Rack Adaptable- Laboratory Bench Unit- Digital Output Metering- Constant Voltage Current Limit Type Character- Micro Switch Provided for Protection against Shock- 3U High (133 mm)- Power Saving Thyristor Preregulator Technique
-
Product
iOS App Testing Services
-
To perform app testing, the approach for you to follow is creating a device lab, using UI automation services.





























